configs/ls1028aqds_tfa_defconfig

   1 CONFIG_ARM=y
   2 CONFIG_SKIP_LOWLEVEL_INIT=y
   3 CONFIG_GIC_V3_ITS=y
   4 CONFIG_TARGET_LS1028AQDS=y
   5 CONFIG_TFABOOT=y
   6 CONFIG_SYS_MALLOC_F_LEN=0x6000
   7 CONFIG_NR_DRAM_BANKS=2
   8 CONFIG_SYS_MEMTEST_START=0x80000000
   9 CONFIG_SYS_MEMTEST_END=0x9fffffff
  10 CONFIG_ENV_SIZE=0x2000
  11 CONFIG_ENV_OFFSET=0x500000
  12 CONFIG_ENV_SECT_SIZE=0x20000
  13 CONFIG_SYS_MALLOC_LEN=0x202000
  14 CONFIG_DM_GPIO=y
  15 CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1028a-qds-duart"
  16 CONFIG_FSPI_AHB_EN_4BYTE=y
  17 CONFIG_ARMV8_SEC_FIRMWARE_SUPPORT=y
  18 CONFIG_SEC_FIRMWARE_ARMV8_PSCI=y
  19 CONFIG_AHCI=y
  20 CONFIG_DISTRO_DEFAULTS=y
  21 CONFIG_FIT_VERBOSE=y
  22 CONFIG_OF_BOARD_SETUP=y
  23 CONFIG_OF_STDOUT_VIA_ALIAS=y
  24 CONFIG_BOOTDELAY=10
  25 CONFIG_USE_BOOTARGS=y
  26 CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 ramdisk_size=0x2000000 default_hugepagesz=2m hugepagesz=2m hugepages=256 video=1920x1080-32@60 cma=256M"
  27 CONFIG_MISC_INIT_R=y
  28 CONFIG_ID_EEPROM=y
  29 CONFIG_CMD_GREPENV=y
  30 CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
  31 CONFIG_CMD_MEMTEST=y
  32 CONFIG_CMD_DM=y
  33 CONFIG_CMD_GPIO=y
  34 CONFIG_CMD_GPT=y
  35 CONFIG_CMD_I2C=y
  36 CONFIG_CMD_MMC=y
  37 CONFIG_CMD_PCI=y
  38 CONFIG_CMD_USB=y
  39 CONFIG_CMD_WDT=y
  40 # CONFIG_CMD_SETEXPR is not set
  41 CONFIG_CMD_CACHE=y
  42 CONFIG_OF_CONTROL=y
  43 CONFIG_ENV_OVERWRITE=y
  44 CONFIG_ENV_IS_IN_MMC=y
  45 CONFIG_ENV_IS_IN_SPI_FLASH=y
  46 CONFIG_ENV_ADDR=0x20500000
  47 CONFIG_NET_RANDOM_ETHADDR=y
  48 CONFIG_NETCONSOLE=y
  49 CONFIG_DM=y
  50 CONFIG_SCSI_AHCI=y
  51 CONFIG_SATA_CEVA=y
  52 CONFIG_FSL_CAAM=y
  53 # CONFIG_DDR_SPD is not set
  54 CONFIG_DM_I2C=y
  55 CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
  56 CONFIG_I2C_MUX=y
  57 CONFIG_I2C_MUX_PCA954x=y
  58 CONFIG_SYS_I2C_EEPROM_ADDR=0x57
  59 CONFIG_FSL_ESDHC=y
  60 CONFIG_MTD=y
  61 CONFIG_DM_SPI_FLASH=y
  62 CONFIG_SPI_FLASH_EON=y
  63 CONFIG_SPI_FLASH_STMICRO=y
  64 CONFIG_SPI_FLASH_SST=y
  65 # CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
  66 CONFIG_PHYLIB=y
  67 CONFIG_PHY_AQUANTIA=y
  68 CONFIG_PHY_ATHEROS=y
  69 CONFIG_PHY_VITESSE=y
  70 CONFIG_PHY_FIXED=y
  71 CONFIG_DM_ETH=y
  72 CONFIG_DM_MDIO=y
  73 CONFIG_DM_MDIO_MUX=y
  74 CONFIG_DM_DSA=y
  75 CONFIG_E1000=y
  76 CONFIG_MSCC_FELIX_SWITCH=y
  77 CONFIG_MDIO_MUX_I2CREG=y
  78 CONFIG_NVME=y
  79 CONFIG_PCI=y
  80 CONFIG_PCIE_ECAM_GENERIC=y
  81 CONFIG_PCIE_LAYERSCAPE_RC=y
  82 CONFIG_DM_RTC=y
  83 CONFIG_RTC_PCF2127=y
  84 CONFIG_SCSI=y
  85 CONFIG_DM_SCSI=y
  86 CONFIG_SYS_NS16550=y
  87 CONFIG_SPI=y
  88 CONFIG_DM_SPI=y
  89 CONFIG_FSL_DSPI=y
  90 CONFIG_NXP_FSPI=y
  91 CONFIG_USB=y
  92 CONFIG_USB_XHCI_HCD=y
  93 CONFIG_USB_XHCI_DWC3=y
  94 CONFIG_WDT=y
  95 CONFIG_WDT_SP805=y
  96 CONFIG_OF_LIBFDT_OVERLAY=y
  97 CONFIG_EFI_LOADER_BOUNCE_BUFFER=y