include/configs/novena.h

   1 /* SPDX-License-Identifier: GPL-2.0+ */
   2 /*
   3  * Configuration settings for the Novena U-Boot.
   4  *
   5  * Copyright (C) 2014 Marek Vasut <[email protected]>
   6  */
   7
   8 #ifndef __CONFIG_H
   9 #define __CONFIG_H
  10
  11 /* System configurations */
  12 #define CONFIG_KEYBOARD
  13
  14 #include "mx6_common.h"
  15
  16 /* U-Boot Commands */
  17
  18 /* U-Boot general configurations */
  19
  20 /* U-Boot environment */
  21 /*
  22  * Environment is on MMC, starting at offset 512KiB from start of the card.
  23  * Please place first partition at offset 1MiB from the start of the card
  24  * as recommended by GNU/fdisk. See below for details:
  25  * http://homepage.ntlworld.com./jonathan.deboynepollard/FGA/disc-partition-alignment.html
  26  */
  27
  28 /* Booting Linux */
  29 #define CONFIG_BOOTFILE                 "fitImage"
  30 #define CONFIG_HOSTNAME                 "novena"
  31
  32 /* Physical Memory Map */
  33 #define PHYS_SDRAM                      MMDC0_ARB_BASE_ADDR
  34
  35 #define CONFIG_SYS_SDRAM_BASE           PHYS_SDRAM
  36 #define CONFIG_SYS_INIT_RAM_ADDR        IRAM_BASE_ADDR
  37 #define CONFIG_SYS_INIT_RAM_SIZE        IRAM_SIZE
  38
  39 #define CONFIG_SYS_INIT_SP_OFFSET \
  40         (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
  41 #define CONFIG_SYS_INIT_SP_ADDR \
  42         (CONFIG_SYS_INIT_RAM_ADDR + CONFIG_SYS_INIT_SP_OFFSET)
  43
  44 #define CONFIG_SYS_MALLOC_LEN           (64 * 1024 * 1024)
  45
  46 /* SPL */
  47 #include "imx6_spl.h"                   /* common IMX6 SPL configuration */
  48
  49 /* Ethernet Configuration */
  50 #ifdef CONFIG_SPL_BUILD
  51 #undef CONFIG_DM_ETH
  52 #endif
  53
  54 /* I2C */
  55 #define CONFIG_I2C_MULTI_BUS
  56 #define CONFIG_SYS_SPD_BUS_NUM          0
  57
  58 /* I2C EEPROM */
  59
  60 /* MMC Configs */
  61 #define CONFIG_SYS_FSL_ESDHC_ADDR       0
  62 #define CONFIG_SYS_FSL_USDHC_NUM        2
  63
  64 /* PCI express */
  65 #ifdef CONFIG_CMD_PCI
  66 #define CONFIG_PCI_SCAN_SHOW
  67 #define CONFIG_PCIE_IMX
  68 #define CONFIG_PCIE_IMX_PERST_GPIO      IMX_GPIO_NR(3, 29)
  69 #define CONFIG_PCIE_IMX_POWER_GPIO      IMX_GPIO_NR(7, 12)
  70 #endif
  71
  72 /* PMIC */
  73 #define CONFIG_POWER
  74 #define CONFIG_POWER_I2C
  75 #define CONFIG_POWER_PFUZE100
  76 #define CONFIG_POWER_PFUZE100_I2C_ADDR  0x08
  77
  78 /* SATA Configs */
  79 #define CONFIG_LBA48
  80
  81 /* UART */
  82 #define CONFIG_MXC_UART_BASE            UART2_BASE
  83
  84 /* USB Configs */
  85 #ifdef CONFIG_CMD_USB
  86 #define CONFIG_USB_MAX_CONTROLLER_COUNT 2
  87 #define CONFIG_MXC_USB_PORTSC           (PORT_PTS_UTMI | PORT_PTS_PTW)
  88 #define CONFIG_MXC_USB_FLAGS            0
  89 /* Gadget part */
  90 #define CONFIG_USBD_HS
  91 #endif
  92
  93 /* Video output */
  94 #define CONFIG_VIDEO_LOGO
  95 #define CONFIG_IMX_HDMI
  96 #define CONFIG_IMX_VIDEO_SKIP
  97
  98 /* Extra U-Boot environment. */
  99 #ifndef CONFIG_SPL_BUILD
 100 #define CONFIG_EXTRA_ENV_SETTINGS                                       \
 101         "fdt_high=0xffffffff\0"                                         \
 102         "initrd_high=0xffffffff\0"                                      \
 103         "consdev=ttymxc1\0"                                             \
 104         "baudrate=115200\0"                                             \
 105         "bootdev=/dev/mmcblk0p1\0"                                      \
 106         "rootdev=/dev/mmcblk0p2\0"                                      \
 107         "netdev=eth0\0"                                                 \
 108         "kernel_addr_r="__stringify(CONFIG_LOADADDR)"\0"                \
 109         "pxefile_addr_r="__stringify(CONFIG_LOADADDR)"\0"               \
 110         "scriptaddr="__stringify(CONFIG_LOADADDR)"\0"                   \
 111         "ramdisk_addr_r=0x28000000\0"                                   \
 112         "fdt_addr_r=0x18000000\0"                                       \
 113         "fdtfile=imx6q-novena.dtb\0"                                    \
 114         "stdout=serial,vidconsole\0"                                    \
 115         "stderr=serial,vidconsole\0"                                    \
 116         "addcons="                                                      \
 117                 "setenv bootargs ${bootargs} "                          \
 118                 "console=${consdev},${baudrate}\0"                      \
 119         "addip="                                                        \
 120                 "setenv bootargs ${bootargs} "                          \
 121                 "ip=${ipaddr}:${serverip}:${gatewayip}:"                \
 122                         "${netmask}:${hostname}:${netdev}:off\0"        \
 123         "addmisc="                                                      \
 124                 "setenv bootargs ${bootargs} ${miscargs}\0"             \
 125         "addargs=run addcons addmisc\0"                                 \
 126         "mmcload="                                                      \
 127                 "mmc rescan ; "                                         \
 128                 "ext4load mmc 0:1 ${kernel_addr_r} ${bootfile}\0"       \
 129         "netload="                                                      \
 130                 "tftp ${kernel_addr_r} ${hostname}/${bootfile}\0"       \
 131         "miscargs=nohlt panic=1\0"                                      \
 132         "mmcargs=setenv bootargs root=${rootdev} rw rootwait\0"         \
 133         "nfsargs="                                                      \
 134                 "setenv bootargs root=/dev/nfs rw "                     \
 135                         "nfsroot=${serverip}:${rootpath},v3,tcp\0"      \
 136         "mmc_mmc="                                                      \
 137                 "run mmcload mmcargs addargs ; "                        \
 138                 "bootm ${kernel_addr_r}\0"                              \
 139         "mmc_nfs="                                                      \
 140                 "run mmcload nfsargs addip addargs ; "                  \
 141                 "bootm ${kernel_addr_r}\0"                              \
 142         "net_mmc="                                                      \
 143                 "run netload mmcargs addargs ; "                        \
 144                 "bootm ${kernel_addr_r}\0"                              \
 145         "net_nfs="                                                      \
 146                 "run netload nfsargs addip addargs ; "                  \
 147                 "bootm ${kernel_addr_r}\0"                              \
 148         "update_sd_spl_filename=SPL\0"                                  \
 149         "update_sd_uboot_filename=u-boot.img\0"                         \
 150         "update_sd_firmware="   /* Update the SD firmware partition */  \
 151                 "if mmc rescan ; then "                                 \
 152                 "if dhcp ${update_sd_spl_filename} ; then "             \
 153                 "mmc write ${loadaddr} 2 0x200 ; "                      \
 154                 "fi ; "                                                 \
 155                 "if dhcp ${update_sd_uboot_filename} ; then "           \
 156                 "fatwrite mmc 0:1 ${loadaddr} u-boot.img ${filesize} ; "\
 157                 "fi ; "                                                 \
 158                 "fi\0"                                                  \
 159         BOOTENV
 160
 161 #define BOOT_TARGET_DEVICES(func) \
 162         func(MMC, mmc, 0) \
 163         func(USB, usb, 0) \
 164         func(SATA, sata, 0) \
 165         func(PXE, pxe, na) \
 166         func(DHCP, dhcp, na)
 167
 168 #include <config_distro_bootcmd.h>
 169
 170 #else
 171 #define CONFIG_EXTRA_ENV_SETTINGS
 172 #endif /* CONFIG_SPL_BUILD */
 173
 174 #endif                          /* __CONFIG_H */