With this setting enabled, the on-board QSPI cannot be
properly flashed. There are no error messages, but the simple
write / read / compare tests fail.
This is already disabled in the qspi and tfa defconfigs for the
LS1046ARDB platform.
Signed-off-by: Maciej Pijanowski <[email protected]>
Cc: [email protected]
Reviewed-by: Prabhakar Kushwaha <[email protected]>
CONFIG_FSL_ESDHC=y
CONFIG_SPI_FLASH=y
# CONFIG_SPI_FLASH_BAR is not set
+# CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
CONFIG_PHYLIB=y
CONFIG_PHY_AQUANTIA=y
CONFIG_E1000=y
CONFIG_FSL_ESDHC=y
CONFIG_SPI_FLASH=y
# CONFIG_SPI_FLASH_BAR is not set
+# CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
CONFIG_PHYLIB=y
CONFIG_PHY_GIGE=y
CONFIG_E1000=y
CONFIG_FSL_ESDHC=y
CONFIG_SPI_FLASH=y
# CONFIG_SPI_FLASH_BAR is not set
+# CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
CONFIG_PHYLIB=y
CONFIG_PHY_AQUANTIA=y
CONFIG_E1000=y
CONFIG_FSL_ESDHC=y
CONFIG_SPI_FLASH=y
# CONFIG_SPI_FLASH_BAR is not set
+# CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
CONFIG_PHYLIB=y
CONFIG_PHY_AQUANTIA=y
CONFIG_E1000=y