include/configs/ls1012aqds.h

   1 /* SPDX-License-Identifier: GPL-2.0+ */
   2 /*
   3  * Copyright 2016 Freescale Semiconductor, Inc.
   4  */
   5
   6 #ifndef __LS1012AQDS_H__
   7 #define __LS1012AQDS_H__
   8
   9 #include "ls1012a_common.h"
  10
  11 /* DDR */
  12 #define CONFIG_DIMM_SLOTS_PER_CTLR      1
  13 #define CONFIG_CHIP_SELECTS_PER_CTRL    1
  14 #define CONFIG_SYS_SDRAM_SIZE           0x40000000
  15
  16 /*
  17  * QIXIS Definitions
  18  */
  19 #define CONFIG_FSL_QIXIS
  20
  21 #ifdef CONFIG_FSL_QIXIS
  22 #define CONFIG_QIXIS_I2C_ACCESS
  23 #define CONFIG_SYS_I2C_FPGA_ADDR        0x66
  24 #define QIXIS_LBMAP_BRDCFG_REG          0x04
  25 #define QIXIS_LBMAP_SWITCH              6
  26 #define QIXIS_LBMAP_MASK                0x08
  27 #define QIXIS_LBMAP_SHIFT               0
  28 #define QIXIS_LBMAP_DFLTBANK            0x00
  29 #define QIXIS_LBMAP_ALTBANK             0x08
  30 #define QIXIS_RST_CTL_RESET             0x31
  31 #define QIXIS_RCFG_CTL_RECONFIG_IDLE    0x20
  32 #define QIXIS_RCFG_CTL_RECONFIG_START   0x21
  33 #define QIXIS_RCFG_CTL_WATCHDOG_ENBLE   0x08
  34 #endif
  35
  36 /*
  37  * I2C bus multiplexer
  38  */
  39 #define I2C_MUX_PCA_ADDR_PRI            0x77
  40 #define I2C_MUX_PCA_ADDR_SEC            0x76 /* Secondary multiplexer */
  41 #define I2C_RETIMER_ADDR                0x18
  42 #define I2C_MUX_CH_DEFAULT              0x8
  43 #define I2C_MUX_CH_CH7301               0xC
  44 #define I2C_MUX_CH5                     0xD
  45 #define I2C_MUX_CH7                     0xF
  46
  47 #define I2C_MUX_CH_VOL_MONITOR 0xa
  48
  49 /*
  50 * RTC configuration
  51 */
  52 #define RTC
  53 #define CONFIG_SYS_I2C_RTC_ADDR         0x51  /* Channel 3*/
  54
  55 /* EEPROM */
  56 #define CONFIG_ID_EEPROM
  57 #define CONFIG_SYS_I2C_EEPROM_NXID
  58 #define CONFIG_SYS_EEPROM_BUS_NUM    0
  59 #define CONFIG_SYS_I2C_EEPROM_ADDR   0x57
  60 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN     1
  61 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
  62 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 5
  63
  64
  65 /* Voltage monitor on channel 2*/
  66 #define I2C_VOL_MONITOR_ADDR           0x40
  67 #define I2C_VOL_MONITOR_BUS_V_OFFSET   0x2
  68 #define I2C_VOL_MONITOR_BUS_V_OVF      0x1
  69 #define I2C_VOL_MONITOR_BUS_V_SHIFT    3
  70
  71 /* DSPI */
  72 #define CONFIG_FSL_DSPI1
  73
  74 #define MMAP_DSPI          DSPI1_BASE_ADDR
  75
  76 #define CONFIG_SYS_DSPI_CTAR0   1
  77
  78 #define CONFIG_SYS_DSPI_CTAR1   (DSPI_CTAR_TRSZ(7) | DSPI_CTAR_PCSSCK_1CLK |\
  79                                 DSPI_CTAR_PASC(0) | DSPI_CTAR_PDT(0) | \
  80                                 DSPI_CTAR_CSSCK(2) | DSPI_CTAR_ASC(0) | \
  81                                 DSPI_CTAR_DT(0))
  82 #define CONFIG_SPI_FLASH_SST /* cs1 */
  83
  84 #define CONFIG_SYS_DSPI_CTAR2   (DSPI_CTAR_TRSZ(7) | DSPI_CTAR_PCSSCK_1CLK |\
  85                                 DSPI_CTAR_PASC(0) | DSPI_CTAR_PDT(0) | \
  86                                 DSPI_CTAR_CSSCK(0) | DSPI_CTAR_ASC(0) | \
  87                                 DSPI_CTAR_DT(0))
  88 #define CONFIG_SPI_FLASH_STMICRO /* cs2 */
  89
  90 #define CONFIG_SYS_DSPI_CTAR3   (DSPI_CTAR_TRSZ(7) | DSPI_CTAR_PCSSCK_1CLK |\
  91                                 DSPI_CTAR_PASC(0) | DSPI_CTAR_PDT(0) | \
  92                                 DSPI_CTAR_CSSCK(2) | DSPI_CTAR_ASC(0) | \
  93                                 DSPI_CTAR_DT(0))
  94 #define CONFIG_SPI_FLASH_EON /* cs3 */
  95
  96 /*  MMC  */
  97 #ifdef CONFIG_MMC
  98 #define CONFIG_SYS_FSL_MMC_HAS_CAPBLT_VS33
  99 #endif
 100
 101 #define CONFIG_PCIE1            /* PCIE controller 1 */
 102
 103 #define CONFIG_PCI_SCAN_SHOW
 104
 105 #include <asm/fsl_secure_boot.h>
 106 #endif /* __LS1012AQDS_H__ */