if (!(flags & MAP_FIXED)) {
#if defined(__alpha__) || defined(__sparc__) || defined(__x86_64__)
- /* tell the kenel to search at the same place as i386 */
+ /* tell the kernel to search at the same place as i386 */
if (host_start == 0) {
host_start = last_start;
last_start += HOST_PAGE_ALIGN(len);
}
#endif
-/* Disassemble this for me please... (debugging). 'flags' has teh following
+/* Disassemble this for me please... (debugging). 'flags' has the following
values:
i386 - nonzero means 16 bit code
arm - nonzero means thumb code
{ CPU_LOG_EXEC, "exec",
"show trace before each executed TB (lots of logs)" },
{ CPU_LOG_TB_CPU, "cpu",
- "show CPU state before bloc translation" },
+ "show CPU state before block translation" },
#ifdef TARGET_I386
{ CPU_LOG_PCALL, "pcall",
"show protected mode far calls/returns/exceptions" },
case 0x09:
case 0x0c:
case 0x0d:
- case 0x12: /* veritcal display end */
+ case 0x12: /* vertical display end */
s->cr[s->cr_index] = val;
break;
cuda_update_irq(s);
} else {
if (!(s->last_b & TIP)) {
- /* handle end of host to cuda transfert */
+ /* handle end of host to cuda transfer */
packet_received = (s->data_out_index > 0);
- /* always an IRQ at the end of transfert */
+ /* always an IRQ at the end of transfer */
s->ifr |= SR_INT;
cuda_update_irq(s);
}
s->cmd = val;
if (!(val & E8390_STOP)) { /* START bit makes no sense on RTL8029... */
s->isr &= ~ENISR_RESET;
- /* test specific case: zero length transfert */
+ /* test specific case: zero length transfer */
if ((val & (E8390_RREAD | E8390_RWRITE)) &&
s->rcnt == 0) {
s->isr |= ENISR_RDC;
if (index + s->tcnt <= NE2000_PMEM_END) {
qemu_send_packet(s->vc, s->mem + index, s->tcnt);
}
- /* signal end of transfert */
+ /* signal end of transfer */
s->tsr = ENTSR_PTX;
s->isr |= ENISR_TX;
s->cmd &= ~E8390_TRANS;
if (s->rcnt <= len) {
s->rcnt = 0;
- /* signal end of transfert */
+ /* signal end of transfer */
s->isr |= ENISR_RDC;
ne2000_update_irq(s);
} else {
is_write = 1;
break;
case 0x35:
- DPRINTF("Syncronise cache (sector %d, count %d)\n", lba, len);
+ DPRINTF("Synchronise cache (sector %d, count %d)\n", lba, len);
bdrv_flush(s->bdrv);
break;
case 0x43:
case 0x09:
case 0x0c:
case 0x0d:
- case 0x12: /* veritcal display end */
+ case 0x12: /* vertical display end */
s->cr[s->cr_index] = val;
break;
default:
#endif
if (interp_elf_ex->e_type == ET_DYN) {
- /* in order to avoid harcoding the interpreter load
+ /* in order to avoid hardcoding the interpreter load
address in qemu, we allocate a big enough memory zone */
error = target_mmap(0, INTERP_MAP_SIZE,
PROT_NONE, MAP_PRIVATE | MAP_ANON,
base, as well as whatever program they might try to exec. This
is because the brk will follow the loader, and is not movable. */
/* NOTE: for qemu, we do a big mmap to get enough space
- without harcoding any address */
+ without hardcoding any address */
error = target_mmap(0, ET_DYN_MAP_SIZE,
PROT_NONE, MAP_PRIVATE | MAP_ANON,
-1, 0);
case SDLK_END: keysym = QEMU_KEY_END; break;
case SDLK_PAGEUP: keysym = QEMU_KEY_PAGEUP; break;
case SDLK_PAGEDOWN: keysym = QEMU_KEY_PAGEDOWN; break;
- case SDLK_BACKSPACE: keysym = QEMU_KEY_BACKSPACE; break; case SDLK_DELETE: keysym = QEMU_KEY_DELETE; break;
+ case SDLK_BACKSPACE: keysym = QEMU_KEY_BACKSPACE; break;
+ case SDLK_DELETE: keysym = QEMU_KEY_DELETE; break;
default: break;
}
}
opc_ptr = opc_buf + opc_buf_len;
/* live_flags contains the flags needed by the next instructions
- in the code. At the end of the bloc, we consider that all the
+ in the code. At the end of the block, we consider that all the
flags are live. */
live_flags = CC_OSZAPC;
while (opc_ptr > opc_buf) {