serial: stm32: Reset .throttled state in .startup()

When an UART is opened that still has .throttled set from a previous
open, the RX interrupt is enabled but the irq handler doesn't consider
it. This easily results in a stuck irq with the effect to occupy the CPU
in a tight loop.

So reset the throttle state in .startup() to ensure that RX irqs are
handled.

Fixes: d1ec8a2eabe9 ("serial: stm32: update throttle and unthrottle ops for dma mode")
Cc: [email protected]
Signed-off-by: Uwe Kleine-König <[email protected]>
Link: https://lore.kernel.org/r/a784f80d3414f7db723b2ec66efc56e1ad666cbf.1713344161.git.u.kleine-koenig@pengutronix.de
Signed-off-by: Greg Kroah-Hartman <[email protected]>

diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index d60cbac691944e131d73d297505d32f04c1cce97..4fa5a03ebac08e4dbc9a85e6e54b0930595fa0ed 100644 (file)
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c
@@ -1092,6 +1092,7 @@ static int stm32_usart_startup(struct uart_port *port)
                val |= USART_CR2_SWAP;
                writel_relaxed(val, port->membase + ofs->cr2);
        }
+       stm32_port->throttled = false;
 
        /* RX FIFO Flush */
        if (ofs->rqr != UNDEF_REG)