drivers/leds/leds-gpio.c: use gpio_get_value_cansleep() when initializing

I get the following warning:

------------[ cut here ]------------
WARNING: at drivers/gpio/gpiolib.c:1559 __gpio_get_value+0x90/0x98()
Modules linked in:
Call Trace:
[<ffffffff81440950>] dump_stack+0x8/0x34
[<ffffffff81141478>] warn_slowpath_common+0x78/0xa0
[<ffffffff812f0958>] __gpio_get_value+0x90/0x98
[<ffffffff81434f04>] create_gpio_led+0xdc/0x194
[<ffffffff8143524c>] gpio_led_probe+0x290/0x36c
[<ffffffff8130e8b0>] driver_probe_device+0x78/0x1b0
[<ffffffff8130eaa8>] __driver_attach+0xc0/0xc8
[<ffffffff8130d7ac>] bus_for_each_dev+0x64/0xb0
[<ffffffff8130e130>] bus_add_driver+0x1c8/0x2a8
[<ffffffff8130f100>] driver_register+0x90/0x180
[<ffffffff81100438>] do_one_initcall+0x38/0x160

---[ end trace ee38723fbefcd65c ]---

My GPIOs are on an I2C port expander, so we must use the *_cansleep()
variant of the GPIO functions.  This is was not being done in
create_gpio_led().

We can change gpio_get_value() to gpio_get_value_cansleep() because it is
only called from the platform_driver probe function, which is a context
where we can sleep.

Only tested on my gpio_cansleep() system, but it seems safe for all
systems.

Signed-off-by: David Daney <[email protected]>
Cc: Richard Purdie <[email protected]>
Acked-by: Trent Piepho <[email protected]>
Cc: Grant Likely <[email protected]>
Signed-off-by: Andrew Morton <[email protected]>
Signed-off-by: Linus Torvalds <[email protected]>

diff --git a/drivers/leds/leds-gpio.c b/drivers/leds/leds-gpio.c
index 3d8bc327a68d215dcd17694b71f7397692818c4f..504cc26c7e4be9a4ea87ee708e3afd135846b68c 100644 (file)
--- a/drivers/leds/leds-gpio.c
+++ b/drivers/leds/leds-gpio.c
@@ -121,7 +121,7 @@ static int __devinit create_gpio_led(const struct gpio_led *template,
        }
        led_dat->cdev.brightness_set = gpio_led_set;
        if (template->default_state == LEDS_GPIO_DEFSTATE_KEEP)
-               state = !!gpio_get_value(led_dat->gpio) ^ led_dat->active_low;
+               state = !!gpio_get_value_cansleep(led_dat->gpio) ^ led_dat->active_low;
        else
                state = (template->default_state == LEDS_GPIO_DEFSTATE_ON);
        led_dat->cdev.brightness = state ? LED_FULL : LED_OFF;