There was a spelling mistake on TSC/ADC binding where "coordinate" was
spelled as "coordiante".
We can't simply fix the error due to DT being an ABI, the approach taken
was to first use correct spelling and if that fails, fall back to
miss-spelled version.
It's unfortunate that has creeped into the tree.
Signed-off-by: Felipe Balbi <[email protected]>
Signed-off-by: Dmitry Torokhov <[email protected]>
ti,wires: Wires refer to application modes i.e. 4/5/8 wire touchscreen
support on the platform.
ti,x-plate-resistance: X plate resistance
- ti,coordiante-readouts: The sequencer supports a total of 16
+ ti,coordinate-readouts: The sequencer supports a total of 16
programmable steps each step is used to
read a single coordinate. A single
readout is enough but multiple reads can
tsc {
ti,wires = <4>;
ti,x-plate-resistance = <200>;
- ti,coordiante-readouts = <5>;
+ ti,coordinate-readouts = <5>;
ti,wire-config = <0x00 0x11 0x22 0x33>;
};
if (err < 0)
return err;
- err = of_property_read_u32(node, "ti,coordiante-readouts",
+ /*
+ * Try with the new binding first. If it fails, try again with
+ * bogus, miss-spelled version.
+ */
+ err = of_property_read_u32(node, "ti,coordinate-readouts",
&ts_dev->coordinate_readouts);
+ if (err < 0)
+ err = of_property_read_u32(node, "ti,coordiante-readouts",
+ &ts_dev->coordinate_readouts);
if (err < 0)
return err;