thunderbolt: Fix wake configurations after device unplug

Currently we don't configure correctly the wake events after unplug of device
router. What can happen is that the downstream ports of host router will be
configured to wake on: USB4-wake and wake-on-disconnect, but not on
wake-on-connect. This may cause the later plugged device not to wake the
domain and fail in enumeration. Fix this by clearing downstream port's "USB4
Port is Configured" bit, after unplug of a device router.

Signed-off-by: Gil Fine <[email protected]>
Cc: [email protected]
Signed-off-by: Mika Westerberg <[email protected]>

diff --git a/drivers/thunderbolt/switch.c b/drivers/thunderbolt/switch.c
index 6ffc4e81ffed78bedaac182b5a77742390c6cd74..4edfd6e34e31938030da19b5c0c7680ade2571e8 100644 (file)
--- a/drivers/thunderbolt/switch.c
+++ b/drivers/thunderbolt/switch.c
@@ -3180,22 +3180,29 @@ void tb_switch_unconfigure_link(struct tb_switch *sw)
 {
        struct tb_port *up, *down;
 
-       if (sw->is_unplugged)
-               return;
        if (!tb_route(sw) || tb_switch_is_icm(sw))
                return;
 
+       /*
+        * Unconfigure downstream port so that wake-on-connect can be
+        * configured after router unplug. No need to unconfigure upstream port
+        * since its router is unplugged.
+        */
        up = tb_upstream_port(sw);
-       if (tb_switch_is_usb4(up->sw))
-               usb4_port_unconfigure(up);
-       else
-               tb_lc_unconfigure_port(up);
-
        down = up->remote;
        if (tb_switch_is_usb4(down->sw))
                usb4_port_unconfigure(down);
        else
                tb_lc_unconfigure_port(down);
+
+       if (sw->is_unplugged)
+               return;
+
+       up = tb_upstream_port(sw);
+       if (tb_switch_is_usb4(up->sw))
+               usb4_port_unconfigure(up);
+       else
+               tb_lc_unconfigure_port(up);
 }
 
 static void tb_switch_credits_init(struct tb_switch *sw)