tty: hvc: Don't enable the RISC-V SBI console by default

The new SBI console has the same problem as the old one: there's only
one shared backing hardware and no synchronization, so the two drivers
end up stepping on each other.  This was the same issue the old SBI-0.1
console drivers had, but that was disabled by default when SBI-0.1 was.

So just mark the new driver as nonportable.

Reported-by: Emil Renner Berthing <[email protected]>
Fixes: 88ead68e764c ("tty: Add SBI debug console support to HVC SBI driver")
Signed-off-by: Palmer Dabbelt <[email protected]>
Reviewed-by: Paul Walmsley <[email protected]>
Reviewed-by: Anup Patel <[email protected]>
Reviewed-by: Conor Dooley <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Greg Kroah-Hartman <[email protected]>

diff --git a/drivers/tty/hvc/Kconfig b/drivers/tty/hvc/Kconfig
index 6e05c5c7bca1ad258502eaf158b94534c1cdd23d..c2a4e88b328f35888cb44c0fe1ca5f57f2040e66 100644 (file)
--- a/drivers/tty/hvc/Kconfig
+++ b/drivers/tty/hvc/Kconfig
@@ -108,13 +108,15 @@ config HVC_DCC_SERIALIZE_SMP
 
 config HVC_RISCV_SBI
        bool "RISC-V SBI console support"
-       depends on RISCV_SBI
+       depends on RISCV_SBI && NONPORTABLE
        select HVC_DRIVER
        help
          This enables support for console output via RISC-V SBI calls, which
-         is normally used only during boot to output printk.
+         is normally used only during boot to output printk.  This driver
+         conflicts with real console drivers and should not be enabled on
+         systems that directly access the console.
 
-         If you don't know what do to here, say Y.
+         If you don't know what do to here, say N.
 
 config HVCS
        tristate "IBM Hypervisor Virtual Console Server support"