CMD23 causes lots of errors in kernel on some freescale SoCs
(P1020, P1021, P1022, P1024, P1025 and P4080) when MMC card used,
which is because these controllers does not support CMD23,
even on the SoCs which declares CMD23 is supported.
Therefore, we'll not use CMD23.
Signed-off-by: Jerry Huang <[email protected]>
Signed-off-by: Shaohui Xie <[email protected]>
Acked-by: Anton Vorontsov <[email protected]>
Signed-off-by: Chris Ball <[email protected]>
}
#endif
+static void esdhc_of_platform_init(struct sdhci_host *host)
+{
+ u32 vvn;
+
+ vvn = in_be32(host->ioaddr + SDHCI_SLOT_INT_STATUS);
+ vvn = (vvn & SDHCI_VENDOR_VER_MASK) >> SDHCI_VENDOR_VER_SHIFT;
+ if (vvn == VENDOR_V_22)
+ host->quirks2 |= SDHCI_QUIRK2_HOST_NO_CMD23;
+}
+
static struct sdhci_ops sdhci_esdhc_ops = {
.read_l = esdhc_readl,
.read_w = esdhc_readw,
.enable_dma = esdhc_of_enable_dma,
.get_max_clock = esdhc_of_get_max_clock,
.get_min_clock = esdhc_of_get_min_clock,
+ .platform_init = esdhc_of_platform_init,
#ifdef CONFIG_PM
.platform_suspend = esdhc_of_suspend,
.platform_resume = esdhc_of_resume,
goto err_remap;
}
+ /*
+ * Some platforms need to probe the controller to be able to
+ * determine which caps should be used.
+ */
+ if (host->ops && host->ops->platform_init)
+ host->ops->platform_init(host);
+
platform_set_drvdata(pdev, host);
return host;
if (!(host->quirks & SDHCI_QUIRK_FORCE_1_BIT_DATA))
mmc->caps |= MMC_CAP_4_BIT_DATA;
+ if (host->quirks2 & SDHCI_QUIRK2_HOST_NO_CMD23)
+ mmc->caps &= ~MMC_CAP_CMD23;
+
if (caps[0] & SDHCI_CAN_DO_HISPD)
mmc->caps |= MMC_CAP_SD_HIGHSPEED | MMC_CAP_MMC_HIGHSPEED;
void (*hw_reset)(struct sdhci_host *host);
void (*platform_suspend)(struct sdhci_host *host);
void (*platform_resume)(struct sdhci_host *host);
+ void (*platform_init)(struct sdhci_host *host);
};
#ifdef CONFIG_MMC_SDHCI_IO_ACCESSORS
unsigned int quirks2; /* More deviations from spec. */
#define SDHCI_QUIRK2_HOST_OFF_CARD_ON (1<<0)
+#define SDHCI_QUIRK2_HOST_NO_CMD23 (1<<1)
int irq; /* Device IRQ */
void __iomem *ioaddr; /* Mapped address */