The IRQ_EXIT_OFFSET trick was used to make sure the irq
doesn't get preempted after we substract the HARDIRQ_OFFSET
until we are entirely done with any code in irq_exit().
This workaround was necessary because some archs may call
irq_exit() with irqs enabled and there is still some code
in the end of this function that is not covered by the
HARDIRQ_OFFSET but want to stay non-preemptible.
Now that irq are always disabled in irq_exit(), the whole code
is guaranteed not to be preempted. We can thus remove this hack.
Signed-off-by: Frederic Weisbecker <[email protected]>
Cc: Linus Torvalds <[email protected]>
Cc: Thomas Gleixner <[email protected]>
Cc: Ingo Molnar <[email protected]>
Cc: Peter Zijlstra <[email protected]>
Cc: Paul E. McKenney <[email protected]>
#ifdef CONFIG_PREEMPT_COUNT
# define preemptible() (preempt_count() == 0 && !irqs_disabled())
-# define IRQ_EXIT_OFFSET (HARDIRQ_OFFSET-1)
#else
# define preemptible() 0
-# define IRQ_EXIT_OFFSET HARDIRQ_OFFSET
#endif
#if defined(CONFIG_SMP) || defined(CONFIG_GENERIC_HARDIRQS)
account_irq_exit_time(current);
trace_hardirq_exit();
- sub_preempt_count(IRQ_EXIT_OFFSET);
+ sub_preempt_count(HARDIRQ_OFFSET);
if (!in_interrupt() && local_softirq_pending())
invoke_softirq();
tick_nohz_irq_exit();
#endif
rcu_irq_exit();
- sched_preempt_enable_no_resched();
#ifndef __ARCH_IRQ_EXIT_IRQS_DISABLED
local_irq_restore(flags);
#endif