Is possible that we stop queue and then do not wake up it again,
especially when packets are transmitted fast. That can be easily
reproduced with modified tx queue entry_num to some small value e.g. 16.
If mac80211 already hold local->queue_stop_reason_lock, then we can wait
on that lock in both rt2x00queue_pause_queue() and
rt2x00queue_unpause_queue(). After drooping ->queue_stop_reason_lock
is possible that __ieee80211_wake_queue() will be performed before
__ieee80211_stop_queue(), hence we stop queue and newer wake up it
again.
Another race condition is possible when between rt2x00queue_threshold()
check and rt2x00queue_pause_queue() we will process all pending tx
buffers on different cpu. This might happen if for example interrupt
will be triggered on cpu performing rt2x00mac_tx().
To prevent race conditions serialize pause/unpause by queue->tx_lock.
Cc: [email protected]
Signed-off-by: Stanislaw Gruszka <[email protected]>
Acked-by: Gertjan van Wingerde <[email protected]>
Signed-off-by: John W. Linville <[email protected]>
/*
* If the data queue was below the threshold before the txdone
* handler we must make sure the packet queue in the mac80211 stack
- * is reenabled when the txdone handler has finished.
+ * is reenabled when the txdone handler has finished. This has to be
+ * serialized with rt2x00mac_tx(), otherwise we can wake up queue
+ * before it was stopped.
*/
+ spin_lock_bh(&entry->queue->tx_lock);
if (!rt2x00queue_threshold(entry->queue))
rt2x00queue_unpause_queue(entry->queue);
+ spin_unlock_bh(&entry->queue->tx_lock);
}
EXPORT_SYMBOL_GPL(rt2x00lib_txdone);
if (unlikely(rt2x00queue_write_tx_frame(queue, skb, false)))
goto exit_fail;
+ /*
+ * Pausing queue has to be serialized with rt2x00lib_txdone(). Note
+ * we should not use spin_lock_bh variant as bottom halve was already
+ * disabled before ieee80211_xmit() call.
+ */
+ spin_lock(&queue->tx_lock);
if (rt2x00queue_threshold(queue))
rt2x00queue_pause_queue(queue);
+ spin_unlock(&queue->tx_lock);
return;
exit_fail:
+ spin_lock(&queue->tx_lock);
rt2x00queue_pause_queue(queue);
+ spin_unlock(&queue->tx_lock);
exit_free_skb:
ieee80211_free_txskb(hw, skb);
}
else if (test_bit(REQUIRE_DMA, &queue->rt2x00dev->cap_flags))
rt2x00queue_align_frame(skb);
+ /*
+ * That function must be called with bh disabled.
+ */
spin_lock(&queue->tx_lock);
if (unlikely(rt2x00queue_full(queue))) {