The original QHT7040 had significant performance issues so there was an
additional check in the driver for a newer serial number. Support for
the small quantities of that board shipped has been dropped, so this
patch removes the special checks to simplify the code.
Signed-off-by: Dave Olson <[email protected]>
Signed-off-by: Roland Dreier <[email protected]>
}
ipath_get_eeprom_info(dd);
- if (dd->ipath_boardrev == 5 && dd->ipath_serial[0] == '1' &&
- dd->ipath_serial[1] == '2' && dd->ipath_serial[2] == '8') {
+ if (dd->ipath_boardrev == 5) {
/*
* Later production QHT7040 has same changes as QHT7140, so
* can use GPIO interrupts. They have serial #'s starting