Currently, the eth devices are probed in the inverse order, first
au1xxx_eth1_device and then au1xxx_eth0_device. On the GPR board,
this makes trouble:
# ifconfig|grep HWaddr
eth0 Link encap:Ethernet HWaddr 00:50:C2:0C:30:01
eth1 Link encap:Ethernet HWaddr 66:22:01:80:38:10
A bogous ethernet hwaddr is assigned to the first device and
au1xxx_eth0_device is mapped to eth1, which even does not work
properly. With this patch, the problems are gone:
# ifconfig|grep HWaddr
eth0 Link encap:Ethernet HWaddr 66:22:11:32:38:10
eth1 Link encap:Ethernet HWaddr 66:22:11:32:38:11
Signed-off-by: Wolfgang Grandegger <[email protected]>
To:
[email protected]
Patchwork: https://patchwork.linux-mips.org/patch/1473/
Signed-off-by: Ralf Baechle <[email protected]>
static int __init au1xxx_platform_init(void)
{
unsigned int uartclk = get_au1x00_uart_baud_base() * 16;
- int i;
+ int err, i;
/* Fill up uartclk. */
for (i = 0; au1x00_uart_data[i].flags; i++)
au1x00_uart_data[i].uartclk = uartclk;
+ err = platform_add_devices(au1xxx_platform_devices,
+ ARRAY_SIZE(au1xxx_platform_devices));
#ifndef CONFIG_SOC_AU1100
/* Register second MAC if enabled in pinfunc */
- if (!(au_readl(SYS_PINFUNC) & (u32)SYS_PF_NI2))
+ if (!err && !(au_readl(SYS_PINFUNC) & (u32)SYS_PF_NI2))
platform_device_register(&au1xxx_eth1_device);
#endif
- return platform_add_devices(au1xxx_platform_devices,
- ARRAY_SIZE(au1xxx_platform_devices));
+ return err;
}
arch_initcall(au1xxx_platform_init);