#endif
/* uart */
-#ifdef XILINX_UARTLITE_BASEADDR
-# define CONFIG_XILINX_UARTLITE
-# define CONFIG_SERIAL_BASE XILINX_UARTLITE_BASEADDR
-# define CONFIG_BAUDRATE XILINX_UARTLITE_BAUDRATE
-# define CONFIG_SYS_BAUDRATE_TABLE { CONFIG_BAUDRATE }
-# define CONSOLE_ARG "console=console=ttyUL0,115200\0"
-#elif XILINX_UART16550_BASEADDR
-# define CONFIG_SYS_NS16550_SERIAL
-# if defined(__MICROBLAZEEL__)
-# define CONFIG_SYS_NS16550_REG_SIZE -4
-# else
-# define CONFIG_SYS_NS16550_REG_SIZE 4
-# endif
-# define CONFIG_CONS_INDEX 1
-# define CONFIG_SYS_NS16550_COM1 \
- ((XILINX_UART16550_BASEADDR & ~0xF) + 0x1000)
-# define CONFIG_SYS_NS16550_CLK XILINX_UART16550_CLOCK_HZ
# define CONFIG_BAUDRATE 115200
-
/* The following table includes the supported baudrates */
# define CONFIG_SYS_BAUDRATE_TABLE \
{300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200, 230400}
-# define CONSOLE_ARG "console=console=ttyS0,115200\0"
-#else
-# error Undefined uart
-#endif
/* setting reset address */
/*#define CONFIG_SYS_RESET_ADDRESS CONFIG_SYS_TEXT_BASE*/
-/* ethernet */
-#undef CONFIG_SYS_ENET
-#if defined(XILINX_EMACLITE_BASEADDR) || defined(CONFIG_OF_CONTROL)
-# define CONFIG_XILINX_EMACLITE 1
-# define CONFIG_SYS_ENET
-#endif
-#if defined(XILINX_LLTEMAC_BASEADDR)
-# define CONFIG_XILINX_LL_TEMAC 1
-# define CONFIG_SYS_ENET
-#endif
-#if defined(XILINX_AXIEMAC_BASEADDR)
-# define CONFIG_XILINX_AXIEMAC 1
-# define CONFIG_SYS_ENET
-#endif
-
-#undef ET_DEBUG
-
/* gpio */
#ifdef XILINX_GPIO_BASEADDR
# define CONFIG_XILINX_GPIO
# define CONFIG_SYS_GPIO_0_ADDR XILINX_GPIO_BASEADDR
#endif
-
-/* interrupt controller */
-#ifdef XILINX_INTC_BASEADDR
-# define CONFIG_SYS_INTC_0_ADDR XILINX_INTC_BASEADDR
-# define CONFIG_SYS_INTC_0_NUM XILINX_INTC_NUM_INTR_INPUTS
-#endif
-
-/* timer */
-#if defined(XILINX_TIMER_BASEADDR) && defined(XILINX_TIMER_IRQ)
-# define CONFIG_SYS_TIMER_0_ADDR XILINX_TIMER_BASEADDR
-# define CONFIG_SYS_TIMER_0_IRQ XILINX_TIMER_IRQ
-#endif
+#define CONFIG_BOARD_LATE_INIT
/* watchdog */
#if defined(XILINX_WATCHDOG_BASEADDR) && defined(XILINX_WATCHDOG_IRQ)
# define CONFIG_WATCHDOG_BASEADDR XILINX_WATCHDOG_BASEADDR
# define CONFIG_WATCHDOG_IRQ XILINX_WATCHDOG_IRQ
-# define CONFIG_HW_WATCHDOG
-# define CONFIG_XILINX_TB_WATCHDOG
-#endif
-
-#if !defined(CONFIG_OF_CONTROL) || \
- (defined(CONFIG_SPL_BUILD) && !defined(CONFIG_SPL_OF_CONTROL))
-/* ddr sdram - main memory */
-# define CONFIG_SYS_SDRAM_BASE XILINX_RAM_START
-# define CONFIG_SYS_SDRAM_SIZE XILINX_RAM_SIZE
+# ifndef CONFIG_SPL_BUILD
+# define CONFIG_HW_WATCHDOG
+# define CONFIG_XILINX_TB_WATCHDOG
+# endif
#endif
#define CONFIG_SYS_MALLOC_LEN 0xC0000
-#ifndef CONFIG_SPL_BUILD
-# define CONFIG_SYS_MALLOC_F_LEN 1024
-#else
-# define CONFIG_SYS_MALLOC_SIMPLE
-# define CONFIG_SYS_MALLOC_F_LEN 0x150
-#endif
/* Stack location before relocation */
-#define CONFIG_SYS_INIT_SP_OFFSET CONFIG_SYS_TEXT_BASE
+#define CONFIG_SYS_INIT_SP_OFFSET (CONFIG_SYS_TEXT_BASE - \
+ CONFIG_SYS_MALLOC_F_LEN)
/*
* CFI flash memory layout - Example
#endif /* !SPIFLASH */
#endif /* !FLASH */
-/* system ace */
-#ifdef XILINX_SYSACE_BASEADDR
-# define CONFIG_SYSTEMACE
-/* #define DEBUG_SYSTEMACE */
-# define SYSTEMACE_CONFIG_FPGA
-# define CONFIG_SYS_SYSTEMACE_BASE XILINX_SYSACE_BASEADDR
-# define CONFIG_SYS_SYSTEMACE_WIDTH XILINX_SYSACE_MEM_WIDTH
-# define CONFIG_DOS_PARTITION
-#endif
-
#if defined(XILINX_USE_ICACHE)
# define CONFIG_ICACHE
#else
/*
* Command line configuration.
*/
-#define CONFIG_CMD_ASKENV
#define CONFIG_CMD_IRQ
#define CONFIG_CMD_MFSL
-#if defined(CONFIG_DCACHE) || defined(CONFIG_ICACHE)
-# define CONFIG_CMD_CACHE
-#else
-# undef CONFIG_CMD_CACHE
-#endif
-
-#ifdef CONFIG_SYS_ENET
-# define CONFIG_CMD_PING
-# define CONFIG_CMD_DHCP
-# define CONFIG_CMD_TFTPPUT
-#endif
-
-#if defined(CONFIG_SYSTEMACE)
-# define CONFIG_CMD_EXT2
-# define CONFIG_CMD_FAT
-#endif
-
#if defined(FLASH)
# define CONFIG_CMD_JFFS2
-# define CONFIG_CMD_UBI
# undef CONFIG_CMD_UBIFS
# if !defined(RAMENV)
#else
#if defined(SPIFLASH)
-# define CONFIG_CMD_SF
# if !defined(RAMENV)
# define CONFIG_CMD_SAVES
# endif
#else
# undef CONFIG_CMD_JFFS2
-# undef CONFIG_CMD_UBI
# undef CONFIG_CMD_UBIFS
#endif
#endif
#endif
#if defined(CONFIG_CMD_UBIFS)
-# define CONFIG_CMD_UBI
# define CONFIG_LZO
#endif
#define CONFIG_SYS_MAXARGS 15
#define CONFIG_SYS_LONGHELP
/* default load address */
-#define CONFIG_SYS_LOAD_ADDR XILINX_RAM_START
+#define CONFIG_SYS_LOAD_ADDR 0
-#define CONFIG_BOOTDELAY -1 /* -1 disables auto-boot */
#define CONFIG_BOOTARGS "root=romfs"
#define CONFIG_HOSTNAME XILINX_BOARD_NAME
#define CONFIG_BOOTCOMMAND "base 0;tftp 11000000 image.img;bootm"
#define CONFIG_CMDLINE_EDITING
-#define CONFIG_NETCONSOLE
#define CONFIG_SYS_CONSOLE_IS_IN_ENV
-/* Use the HUSH parser */
-#define CONFIG_SYS_HUSH_PARSER
-
/* Enable flat device tree support */
#define CONFIG_LMB 1
-#define CONFIG_FIT 1
-#define CONFIG_OF_LIBFDT 1
-#if defined(CONFIG_XILINX_LL_TEMAC) || defined(CONFIG_XILINX_AXIEMAC)
+#if defined(CONFIG_XILINX_AXIEMAC)
# define CONFIG_MII 1
-# define CONFIG_CMD_MII 1
# define CONFIG_PHY_GIGE 1
# define CONFIG_SYS_FAULT_ECHO_LINK_DOWN 1
-# define CONFIG_PHYLIB 1
# define CONFIG_PHY_ATHEROS 1
# define CONFIG_PHY_BROADCOM 1
# define CONFIG_PHY_DAVICOM 1
# define CONFIG_PHY_LXT 1
# define CONFIG_PHY_MARVELL 1
# define CONFIG_PHY_MICREL 1
+# define CONFIG_PHY_MICREL_KSZ9021
# define CONFIG_PHY_NATSEMI 1
# define CONFIG_PHY_REALTEK 1
# define CONFIG_PHY_VITESSE 1
#else
# undef CONFIG_MII
-# undef CONFIG_CMD_MII
-# undef CONFIG_PHYLIB
#endif
/* SPL part */
#define CONFIG_CMD_SPL
#define CONFIG_SPL_FRAMEWORK
-#define CONFIG_SPL_LIBCOMMON_SUPPORT
-#define CONFIG_SPL_LIBGENERIC_SUPPORT
-#define CONFIG_SPL_SERIAL_SUPPORT
#define CONFIG_SPL_BOARD_INIT
#define CONFIG_SPL_LDSCRIPT "arch/microblaze/cpu/u-boot-spl.lds"
#define CONFIG_SPL_RAM_DEVICE
#ifdef CONFIG_SYS_FLASH_BASE
-# define CONFIG_SPL_NOR_SUPPORT
# define CONFIG_SYS_UBOOT_BASE CONFIG_SYS_FLASH_BASE
#endif
0x60000)
#define CONFIG_SYS_FDT_BASE (CONFIG_SYS_FLASH_BASE + \
0x40000)
+#define CONFIG_SYS_FDT_SIZE (16<<10)
#define CONFIG_SYS_SPL_ARGS_ADDR (CONFIG_SYS_TEXT_BASE + \
0x1000000)
projects / J-u-boot.git / blobdiff