spl: Use CONFIG_SPL... instead of CONFIG_..._SPL_...

[J-u-boot.git] / configs / ls1021atwr_sdcard_qspi_defconfig

diff --git a/configs/ls1021atwr_sdcard_qspi_defconfig b/configs/ls1021atwr_sdcard_qspi_defconfig
index 8e045d21fb3295e4e732421989f7821369e7234f..26d302cee56399c8ab5d80eaf963f9a8a63d0f81 100644 (file)
--- a/configs/ls1021atwr_sdcard_qspi_defconfig
+++ b/configs/ls1021atwr_sdcard_qspi_defconfig
@@ -1,14 +1,13 @@
 CONFIG_ARM=y
 CONFIG_SKIP_LOWLEVEL_INIT=y
 CONFIG_SPL_SKIP_LOWLEVEL_INIT=y
+CONFIG_COUNTER_FREQUENCY=12500000
 CONFIG_TARGET_LS1021ATWR=y
-CONFIG_SYS_TEXT_BASE=0x82000000
+CONFIG_TEXT_BASE=0x82000000
 CONFIG_SYS_MALLOC_LEN=0x1020000
 CONFIG_SPL_LIBCOMMON_SUPPORT=y
 CONFIG_SPL_LIBGENERIC_SUPPORT=y
 CONFIG_NR_DRAM_BANKS=1
-CONFIG_SYS_MEMTEST_START=0x80000000
-CONFIG_SYS_MEMTEST_END=0x9fffffff
 CONFIG_ENV_SIZE=0x20000
 CONFIG_ENV_OFFSET=0x300000
 CONFIG_SYS_I2C_MXC_I2C1=y
@@ -17,36 +16,58 @@ CONFIG_SYS_I2C_MXC_I2C3=y
 CONFIG_DM_GPIO=y
 CONFIG_DEFAULT_DEVICE_TREE="ls1021a-twr-duart"
 CONFIG_SPL_TEXT_BASE=0x10000000
+CONFIG_SYS_MONITOR_LEN=1048576
 CONFIG_SPL_MMC=y
 CONFIG_SPL_SERIAL=y
+CONFIG_SPL_STACK=0x1001d000
 CONFIG_SPL=y
-CONFIG_AHCI=y
-CONFIG_DISTRO_DEFAULTS=y
 CONFIG_SYS_LOAD_ADDR=0x82000000
+CONFIG_PCI=y
+CONFIG_AHCI=y
+CONFIG_LAYERSCAPE_NS_ACCESS=y
+CONFIG_PCIE1=y
+CONFIG_PCIE2=y
+CONFIG_SYS_MEMTEST_START=0x80000000
+CONFIG_SYS_MEMTEST_END=0x9fffffff
 CONFIG_FIT=y
 CONFIG_FIT_VERBOSE=y
-CONFIG_OF_BOARD_SETUP=y
-CONFIG_OF_STDOUT_VIA_ALIAS=y
 CONFIG_RAMBOOT_PBL=y
 CONFIG_SYS_FSL_PBL_PBI="board/freescale/ls1021atwr/ls102xa_pbi.cfg"
 CONFIG_SYS_FSL_PBL_RCW="board/freescale/ls1021atwr/ls102xa_rcw_sd_qspi.cfg"
+CONFIG_DISTRO_DEFAULTS=y
 CONFIG_SD_BOOT=y
 CONFIG_SD_BOOT_QSPI=y
 CONFIG_BOOTDELAY=3
+CONFIG_OF_BOARD_SETUP=y
+CONFIG_OF_STDOUT_VIA_ALIAS=y
 CONFIG_USE_BOOTARGS=y
 CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0"
 CONFIG_BOOTCOMMAND="run distro_bootcmd; run qspi_bootcmd; env exists secureboot && esbc_halt"
 CONFIG_SILENT_CONSOLE=y
 CONFIG_SYS_CONSOLE_IS_IN_ENV=y
+CONFIG_ARCH_MISC_INIT=y
 CONFIG_MISC_INIT_R=y
 CONFIG_ID_EEPROM=y
+CONFIG_SYS_EEPROM_BUS_NUM=1
+CONFIG_SPL_MAX_SIZE=0x1a000
+CONFIG_SPL_PAD_TO=0x1c000
+CONFIG_SPL_HAS_BSS_LINKER_SECTION=y
+CONFIG_SPL_BSS_START_ADDR=0x80100000
+CONFIG_SPL_BSS_MAX_SIZE=0x80000
 CONFIG_SPL_FSL_PBL=y
+# CONFIG_SPL_SHARES_INIT_SP_ADDR is not set
+CONFIG_SPL_SYS_MALLOC=y
+CONFIG_SPL_HAS_CUSTOM_MALLOC_START=y
+CONFIG_SPL_CUSTOM_SYS_MALLOC_ADDR=0x82100000
 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y
 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0xe8
 CONFIG_SPL_ENV_SUPPORT=y
 CONFIG_SPL_I2C=y
 CONFIG_SPL_MPC8XXX_INIT_DDR=y
 CONFIG_SPL_WATCHDOG=y
+CONFIG_SYS_CBSIZE=256
+CONFIG_SYS_PBSIZE=276
+CONFIG_SYS_BOOTM_LEN=0x4000000
 CONFIG_CMD_GREPENV=y
 CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
 CONFIG_CMD_MEMINFO=y
@@ -63,7 +84,6 @@ CONFIG_ENV_IS_IN_MMC=y
 CONFIG_SYS_RELOC_GD_ENV_ADDR=y
 CONFIG_USE_ETHPRIME=y
 CONFIG_ETHPRIME="ethernet@2d10000"
-CONFIG_DM=y
 CONFIG_SATA=y
 CONFIG_SATA_CEVA=y
 CONFIG_FSL_CAAM=y
@@ -77,17 +97,15 @@ CONFIG_MTD=y
 CONFIG_SPI_FLASH_ATMEL=y
 CONFIG_SPI_FLASH_STMICRO=y
 CONFIG_PHY_ATHEROS=y
-CONFIG_DM_ETH=y
 CONFIG_DM_MDIO=y
 CONFIG_PHY_GIGE=y
 CONFIG_E1000=y
 CONFIG_MII=y
 CONFIG_TSEC_ENET=y
 CONFIG_NVME_PCI=y
-CONFIG_PCI=y
 CONFIG_PCIE_LAYERSCAPE_RC=y
 CONFIG_DM_SCSI=y
-CONFIG_SYS_NS16550=y
+CONFIG_SYS_NS16550_SERIAL=y
 CONFIG_SPI=y
 CONFIG_DM_SPI=y
 CONFIG_FSL_DSPI=y