Convert CONFIG_CONS_INDEX et al to Kconfig

[J-u-boot.git] / configs / ls1046ardb_qspi_spl_defconfig

diff --git a/configs/ls1046ardb_qspi_spl_defconfig b/configs/ls1046ardb_qspi_spl_defconfig
index 327028619b16a16545410ed9fdd615ee3d701803..777b7678a3b913b8b7b90e68f6bb5b09e91a60ca 100644 (file)
--- a/configs/ls1046ardb_qspi_spl_defconfig
+++ b/configs/ls1046ardb_qspi_spl_defconfig
@@ -1,42 +1,53 @@
 CONFIG_ARM=y
 CONFIG_TARGET_LS1046ARDB=y
 CONFIG_SYS_TEXT_BASE=0x82000000
+CONFIG_SYS_MALLOC_LEN=0x102000
 CONFIG_SPL_LIBCOMMON_SUPPORT=y
 CONFIG_SPL_LIBGENERIC_SUPPORT=y
 CONFIG_NR_DRAM_BANKS=2
 CONFIG_ENV_SIZE=0x2000
 CONFIG_ENV_OFFSET=0x300000
 CONFIG_ENV_SECT_SIZE=0x40000
+CONFIG_SYS_I2C_MXC_I2C1=y
+CONFIG_SYS_I2C_MXC_I2C2=y
+CONFIG_SYS_I2C_MXC_I2C3=y
+CONFIG_SYS_I2C_MXC_I2C4=y
 CONFIG_DM_GPIO=y
+CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1046a-rdb"
 CONFIG_SPL_TEXT_BASE=0x10000000
 CONFIG_FSL_LS_PPA=y
 CONFIG_SPL_FSL_LS_PPA=y
 CONFIG_QSPI_AHB_INIT=y
-CONFIG_SPL_SERIAL_SUPPORT=y
-CONFIG_SPL_DRIVERS_MISC_SUPPORT=y
+CONFIG_SPL_SERIAL=y
+CONFIG_SPL_DRIVERS_MISC=y
 CONFIG_SPL=y
-CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1046a-rdb"
 CONFIG_AHCI=y
 CONFIG_DISTRO_DEFAULTS=y
 CONFIG_FIT_VERBOSE=y
 CONFIG_SPL_LOAD_FIT=y
 # CONFIG_USE_SPL_FIT_GENERATOR is not set
 CONFIG_OF_BOARD_SETUP=y
+CONFIG_RAMBOOT_PBL=y
+CONFIG_SYS_FSL_PBL_PBI="board/freescale/ls1046ardb/ls1046ardb_qspi_pbi.cfg"
+CONFIG_SYS_FSL_PBL_RCW="board/freescale/ls1046ardb/ls1046ardb_rcw_qspi.cfg"
 CONFIG_QSPI_BOOT=y
 CONFIG_BOOTDELAY=10
 CONFIG_USE_BOOTARGS=y
 CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 mtdparts=1550000.spi-0:1m(rcw),15m(u-boot),48m(kernel.itb);7e800000.flash:16m(nand_uboot),48m(nand_kernel),448m(nand_free)"
+CONFIG_BOOTCOMMAND="run distro_bootcmd; run qspi_bootcmd; env exists secureboot && esbc_halt;;"
 CONFIG_MISC_INIT_R=y
 CONFIG_SPL_BOARD_INIT=y
 CONFIG_SPL_ENV_SUPPORT=y
-CONFIG_SPL_I2C_SUPPORT=y
-CONFIG_SPL_MPC8XXX_INIT_DDR_SUPPORT=y
+CONFIG_SPL_I2C=y
+CONFIG_SPL_MPC8XXX_INIT_DDR=y
 CONFIG_SPL_NOR_SUPPORT=y
 CONFIG_SPL_OS_BOOT=y
 CONFIG_SYS_OS_BASE=0x40980000
-CONFIG_SPL_WATCHDOG_SUPPORT=y
+CONFIG_SPL_WATCHDOG=y
 CONFIG_CMD_SPL=y
+CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
 CONFIG_CMD_DM=y
+CONFIG_CMD_GPIO=y
 CONFIG_CMD_GPT=y
 CONFIG_CMD_I2C=y
 CONFIG_CMD_MMC=y
@@ -55,25 +66,34 @@ CONFIG_SPL_ENV_IS_NOWHERE=y
 CONFIG_DM=y
 CONFIG_SATA_CEVA=y
 CONFIG_FSL_CAAM=y
+CONFIG_DDR_ECC=y
+CONFIG_ECC_INIT_VIA_DDRCONTROLLER=y
+CONFIG_MPC8XXX_GPIO=y
 CONFIG_DM_I2C=y
-CONFIG_DM_MMC=y
+CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
+CONFIG_SYS_I2C_EEPROM_ADDR=0x53
 CONFIG_FSL_ESDHC=y
 CONFIG_MTD=y
 CONFIG_MTD_RAW_NAND=y
+CONFIG_NAND_FSL_IFC=y
+CONFIG_SYS_NAND_ONFI_DETECTION=y
 # CONFIG_SPI_FLASH_BAR is not set
 # CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
 CONFIG_PHYLIB=y
 CONFIG_PHY_REALTEK=y
+CONFIG_PHY_FIXED=y
 CONFIG_DM_ETH=y
 CONFIG_DM_MDIO=y
 CONFIG_PHY_GIGE=y
 CONFIG_E1000=y
 CONFIG_FMAN_ENET=y
+CONFIG_SYS_FMAN_FW_ADDR=0x40900000
+CONFIG_NVME=y
 CONFIG_PCI=y
-CONFIG_DM_PCI=y
-CONFIG_DM_PCI_COMPAT=y
 CONFIG_PCIE_LAYERSCAPE_RC=y
 CONFIG_PCIE_LAYERSCAPE_EP=y
+CONFIG_POWER_LEGACY=y
+CONFIG_POWER_I2C=y
 CONFIG_SYS_QE_FMAN_FW_IN_SPIFLASH=y
 CONFIG_DM_SCSI=y
 CONFIG_SYS_NS16550=y
@@ -81,7 +101,6 @@ CONFIG_SPI=y
 CONFIG_DM_SPI=y
 CONFIG_FSL_QSPI=y
 CONFIG_USB=y
-CONFIG_DM_USB=y
 CONFIG_USB_XHCI_HCD=y
 CONFIG_USB_XHCI_DWC3=y
 CONFIG_SPL_GZIP=y