#define CONFIG_SKIP_LOWLEVEL_INIT /* U-Boot is a 2nd stage loader */
/* SoC Configuration */
-#define CONFIG_ARCH_CPU_INIT
#define CONFIG_SPL_TARGET "u-boot-spi.gph"
-#define CONFIG_SYS_DCACHE_OFF
/* Memory Configuration */
-#define CONFIG_NR_DRAM_BANKS 2
#define CONFIG_SYS_LPAE_SDRAM_BASE 0x800000000
#define CONFIG_MAX_RAM_BANK_SIZE (2 << 30) /* 2GB */
-#define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SPL_TEXT_BASE - \
+#define CONFIG_SYS_INIT_SP_ADDR (CONFIG_ISW_ENTRY_ADDR - \
GENERATED_GBL_DATA_SIZE)
#ifdef CONFIG_SYS_MALLOC_F_LEN
/* SPL SPI Loader Configuration */
#define CONFIG_SPL_PAD_TO 65536
#define CONFIG_SPL_MAX_SIZE (CONFIG_SPL_PAD_TO - 8)
-#define CONFIG_SPL_BSS_START_ADDR (CONFIG_SPL_TEXT_BASE + \
+#define CONFIG_SPL_BSS_START_ADDR (CONFIG_ISW_ENTRY_ADDR + \
CONFIG_SPL_MAX_SIZE)
#define CONFIG_SPL_BSS_MAX_SIZE (32 * 1024)
#define CONFIG_SYS_SPL_MALLOC_START (CONFIG_SPL_BSS_START_ADDR + \
CONFIG_SYS_SPL_MALLOC_SIZE + \
SPL_MALLOC_F_SIZE + \
KEYSTONE_SPL_STACK_SIZE - 4)
-#define CONFIG_SYS_SPI_U_BOOT_OFFS CONFIG_SPL_PAD_TO
/* SRAM scratch space entries */
#define SRAM_SCRATCH_SPACE_ADDR CONFIG_SPL_STACK + 0x8
/* UART Configuration */
#define CONFIG_SYS_NS16550_MEM32
-#if defined(CONFIG_SPL_BUILD) || !defined(CONFIG_DM_SERIAL)
-#define CONFIG_SYS_NS16550_SERIAL
-#define CONFIG_SYS_NS16550_REG_SIZE -4
-#endif
#define CONFIG_SYS_NS16550_COM1 KS2_UART0_BASE
#define CONFIG_SYS_NS16550_COM2 KS2_UART1_BASE
/* SPI Configuration */
#define CONFIG_SYS_SPI_CLK ks_clk_get_rate(KS2_CLK1_6)
-#define CONFIG_SF_DEFAULT_SPEED 30000000
-#define CONFIG_ENV_SPI_MAX_HZ CONFIG_SF_DEFAULT_SPEED
-#define CONFIG_SYS_SPI0
-#define CONFIG_SYS_SPI_BASE KS2_SPI0_BASE
-#define CONFIG_SYS_SPI0_NUM_CS 4
-#define CONFIG_SYS_SPI1
-#define CONFIG_SYS_SPI1_BASE KS2_SPI1_BASE
-#define CONFIG_SYS_SPI1_NUM_CS 4
-#define CONFIG_SYS_SPI2
-#define CONFIG_SYS_SPI2_BASE KS2_SPI2_BASE
-#define CONFIG_SYS_SPI2_NUM_CS 4
-#ifdef CONFIG_SPL_BUILD
-#undef CONFIG_DM_SPI
-#undef CONFIG_DM_SPI_FLASH
-#endif
/* Network Configuration */
-#define CONFIG_MII
#define CONFIG_BOOTP_DEFAULT
-#define CONFIG_BOOTP_DNS2
#define CONFIG_BOOTP_SEND_HOSTNAME
#define CONFIG_NET_RETRY_COUNT 32
#define CONFIG_SYS_SGMII_REFCLK_MHZ 312
#define CONFIG_KSNAV_NETCP_PDMA_TX_SND_QUEUE KS2_NETCP_PDMA_TX_SND_QUEUE
/* Keystone net */
-#define CONFIG_DRIVER_TI_KEYSTONE_NET
#define CONFIG_KSNET_MAC_ID_BASE KS2_MAC_ID_BASE_ADDR
#define CONFIG_KSNET_NETCP_BASE KS2_NETCP_BASE
#define CONFIG_KSNET_SERDES_SGMII_BASE KS2_SGMII_SERDES_BASE
#define CONFIG_KSNET_SERDES_SGMII2_BASE KS2_SGMII_SERDES2_BASE
#define CONFIG_KSNET_SERDES_LANES_PER_SGMII KS2_LANES_PER_SGMII_SERDES
-/* SerDes */
-#define CONFIG_TI_KEYSTONE_SERDES
-
#define CONFIG_AEMIF_CNTRL_BASE KS2_AEMIF_CNTRL_BASE
/* I2C Configuration */
-#define CONFIG_SYS_I2C_DAVINCI
#define CONFIG_SYS_DAVINCI_I2C_SPEED 100000
#define CONFIG_SYS_DAVINCI_I2C_SLAVE 0x10 /* SMBus host address */
#define CONFIG_SYS_DAVINCI_I2C_SPEED1 100000
#define CONFIG_ENV_EEPROM_IS_ON_I2C
/* NAND Configuration */
-#define CONFIG_NAND_DAVINCI
#define CONFIG_KEYSTONE_RBL_NAND
#define CONFIG_KEYSTONE_NAND_MAX_RBL_SIZE CONFIG_ENV_OFFSET
#define CONFIG_SYS_NAND_MASK_CLE 0x4000
#define CONFIG_SYS_NAND_MASK_ALE 0x2000
#define CONFIG_SYS_NAND_CS 2
-#define CONFIG_SYS_NAND_USE_FLASH_BBT
#define CONFIG_SYS_NAND_4BIT_HW_ECC_OOBFIRST
#define CONFIG_SYS_NAND_LARGEPAGE
#define CONFIG_SYS_MAX_NAND_DEVICE 1
#define CONFIG_SYS_NAND_MAX_CHIPS 1
#define CONFIG_SYS_NAND_NO_SUBPAGE_WRITE
-#define CONFIG_MTD_PARTITIONS
-/* USB Configuration */
-#define CONFIG_USB_XHCI_KEYSTONE
-#define CONFIG_USB_SS_BASE KS2_USB_SS_BASE
-#define CONFIG_USB_HOST_XHCI_BASE KS2_USB_HOST_XHCI_BASE
-#define CONFIG_DEV_USB_PHY_BASE KS2_DEV_USB_PHY_BASE
-#define CONFIG_USB_PHY_CFG_BASE KS2_USB_PHY_CFG_BASE
+#define DFU_ALT_INFO_MMC \
+ "dfu_alt_info_mmc=" \
+ "MLO fat 0 1;" \
+ "u-boot.img fat 0 1;" \
+ "uEnv.txt fat 0 1\0"
+
+/* DFU settings */
+#define DFUARGS \
+ "dfu_bufsiz=0x10000\0" \
+ DFU_ALT_INFO_MMC \
/* U-Boot general configuration */
-#define CONFIG_MISC_INIT_R
-#define CONFIG_MX_CYCLIC
#define CONFIG_TIMESTAMP
/* EDMA3 */
#define CONFIG_EXTRA_ENV_SETTINGS \
DEFAULT_LINUX_BOOT_ENV \
CONFIG_EXTRA_ENV_KS2_BOARD_SETTINGS \
+ DFUARGS \
"bootdir=/boot\0" \
"tftp_root=/\0" \
"nfs_root=/export\0" \
"mem_lpae=1\0" \
+ "uinitrd_fixup=1\0" \
"addr_ubi=0x82000000\0" \
"addr_secdb_key=0xc000000\0" \
"name_kern=zImage\0" \
"addr_mon=0x87000000\0" \
- "addr_non_sec_mon=0x0c087fc0\0" \
- "addr_load_sec_bm=0x0c08c000\0" \
+ "addr_non_sec_mon=0x0c097fc0\0" \
+ "addr_load_sec_bm=0x0c09c000\0" \
"run_mon=mon_install ${addr_mon}\0" \
"run_mon_hs=mon_install ${addr_non_sec_mon} " \
"${addr_load_sec_bm}\0" \
"get_mon_net=dhcp ${addr_mon} ${tftp_root}/${name_mon}\0" \
"get_mon_nfs=nfs ${addr_mon} ${nfs_root}/boot/${name_mon}\0" \
"get_mon_ubi=ubifsload ${addr_mon} ${bootdir}/${name_mon}\0" \
- "get_fit_net=dhcp ${fit_loadaddr} ${tftp_root}" \
- "/${fit_bootfile}\0" \
- "get_fit_nfs=nfs ${fit_loadaddr} ${nfs_root}/boot/${fit_bootfile}\0"\
- "get_fit_ubi=ubifsload ${fit_loadaddr} ${bootdir}/${fit_bootfile}\0"\
- "get_fit_mmc=load mmc ${bootpart} ${fit_loadaddr} " \
- "${bootdir}/${fit_bootfile}\0" \
+ "get_fit_net=dhcp ${addr_fit} ${tftp_root}/${name_fit}\0" \
+ "get_fit_nfs=nfs ${addr_fit} ${nfs_root}/boot/${name_fit}\0" \
+ "get_fit_ubi=ubifsload ${addr_fit} ${bootdir}/${name_fit}\0" \
+ "get_fit_mmc=load mmc ${bootpart} ${addr_fit} ${bootdir}/${name_fit}\0" \
"get_uboot_net=dhcp ${loadaddr} ${tftp_root}/${name_uboot}\0" \
"get_uboot_nfs=nfs ${loadaddr} ${nfs_root}/boot/${name_uboot}\0" \
"burn_uboot_spi=sf probe; sf erase 0 0x100000; " \
"get_fdt_ramfs=dhcp ${fdtaddr} ${tftp_root}/${name_fdt}\0" \
"get_kern_ramfs=dhcp ${loadaddr} ${tftp_root}/${name_kern}\0" \
"get_mon_ramfs=dhcp ${addr_mon} ${tftp_root}/${name_mon}\0" \
- "get_fit_ramfs=dhcp ${fit_loadaddr} ${tftp_root}" \
- "/${fit_bootfile}\0" \
+ "get_fit_ramfs=dhcp ${addr_fit} ${tftp_root}/${name_fit}\0" \
"get_fs_ramfs=dhcp ${rdaddr} ${tftp_root}/${name_fs}\0" \
"get_ubi_net=dhcp ${addr_ubi} ${tftp_root}/${name_ubi}\0" \
"get_ubi_nfs=nfs ${addr_ubi} ${nfs_root}/boot/${name_ubi}\0" \
"run run_mon_hs; " \
"run init_${boot}; " \
"run get_fit_${boot}; " \
- "bootm ${fit_loadaddr}#${name_fdt}"
+ "bootm ${addr_fit}#${name_fdt}"
#endif
#endif
projects / J-u-boot.git / blobdiff