nxp: Migrate a number of DDR related symbols to Kconfig

[J-u-boot.git] / configs / ls1046aqds_sdcard_qspi_defconfig

diff --git a/configs/ls1046aqds_sdcard_qspi_defconfig b/configs/ls1046aqds_sdcard_qspi_defconfig
index a66b1bdca93852da82ac38a0797ff28a5a808fcb..85bc193773bfc00a3327c33ae48102faf0d4780c 100644 (file)
--- a/configs/ls1046aqds_sdcard_qspi_defconfig
+++ b/configs/ls1046aqds_sdcard_qspi_defconfig
@@ -3,16 +3,24 @@ CONFIG_TARGET_LS1046AQDS=y
 CONFIG_SYS_TEXT_BASE=0x82000000
 CONFIG_SPL_LIBCOMMON_SUPPORT=y
 CONFIG_SPL_LIBGENERIC_SUPPORT=y
+CONFIG_NR_DRAM_BANKS=2
+CONFIG_SYS_MEMTEST_START=0x80000000
+CONFIG_SYS_MEMTEST_END=0x9fffffff
 CONFIG_ENV_SIZE=0x2000
 CONFIG_ENV_OFFSET=0x300000
+CONFIG_SYS_I2C_MXC_I2C1=y
+CONFIG_SYS_I2C_MXC_I2C2=y
+CONFIG_SYS_I2C_MXC_I2C3=y
+CONFIG_SYS_I2C_MXC_I2C4=y
 CONFIG_DM_GPIO=y
+CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1046a-qds-duart"
+CONFIG_SPL_TEXT_BASE=0x10000000
+CONFIG_FSL_USE_PCA9547_MUX=y
 CONFIG_FSL_LS_PPA=y
 CONFIG_SPL_MMC_SUPPORT=y
 CONFIG_SPL_SERIAL_SUPPORT=y
-CONFIG_SPL_DRIVERS_MISC_SUPPORT=y
-CONFIG_NR_DRAM_BANKS=2
+CONFIG_SPL_DRIVERS_MISC=y
 CONFIG_SPL=y
-CONFIG_SPL_TEXT_BASE=0x10000000
 CONFIG_AHCI=y
 CONFIG_DISTRO_DEFAULTS=y
 CONFIG_FIT_VERBOSE=y
@@ -29,15 +37,15 @@ CONFIG_SPL_BOARD_INIT=y
 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y
 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0x110
 CONFIG_SPL_ENV_SUPPORT=y
-CONFIG_SPL_I2C_SUPPORT=y
+CONFIG_SPL_I2C=y
 CONFIG_SPL_MPC8XXX_INIT_DDR_SUPPORT=y
-CONFIG_SPL_WATCHDOG_SUPPORT=y
+CONFIG_SPL_WATCHDOG=y
 CONFIG_CMD_BOOTZ=y
 CONFIG_CMD_GREPENV=y
+CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
 CONFIG_CMD_MEMINFO=y
 CONFIG_CMD_MEMTEST=y
-CONFIG_SYS_MEMTEST_START=0x80000000
-CONFIG_SYS_MEMTEST_END=0x9fffffff
+CONFIG_CMD_GPIO=y
 CONFIG_CMD_GPT=y
 CONFIG_CMD_I2C=y
 CONFIG_CMD_MMC=y
@@ -48,14 +56,19 @@ CONFIG_MP=y
 CONFIG_MTDPARTS_DEFAULT="mtdparts=1550000.spi-0:2m(uboot),14m(free)"
 # CONFIG_SPL_EFI_PARTITION is not set
 CONFIG_OF_CONTROL=y
-CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1046a-qds-duart"
+CONFIG_ENV_OVERWRITE=y
 CONFIG_ENV_IS_IN_MMC=y
 CONFIG_SYS_RELOC_GD_ENV_ADDR=y
 CONFIG_DM=y
 CONFIG_SATA_CEVA=y
 CONFIG_FSL_CAAM=y
+CONFIG_DYNAMIC_DDR_CLK_FREQ=y
+CONFIG_DDR_ECC=y
+CONFIG_ECC_INIT_VIA_DDRCONTROLLER=y
 CONFIG_DM_I2C=y
-CONFIG_DM_MMC=y
+CONFIG_SYS_I2C_EARLY_INIT=y
+CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
+CONFIG_SYS_I2C_EEPROM_ADDR=0x57
 CONFIG_FSL_ESDHC=y
 # CONFIG_SPI_FLASH_BAR is not set
 CONFIG_SPI_FLASH_SPANSION=y
@@ -66,10 +79,11 @@ CONFIG_PHY_REALTEK=y
 CONFIG_PHY_VITESSE=y
 CONFIG_E1000=y
 CONFIG_FMAN_ENET=y
+CONFIG_NVME=y
 CONFIG_PCI=y
-CONFIG_DM_PCI=y
 CONFIG_DM_PCI_COMPAT=y
-CONFIG_PCIE_LAYERSCAPE=y
+CONFIG_PCIE_LAYERSCAPE_RC=y
+CONFIG_PCIE_LAYERSCAPE_EP=y
 CONFIG_SYS_QE_FMAN_FW_IN_MMC=y
 CONFIG_DM_SCSI=y
 CONFIG_SYS_NS16550=y
@@ -78,7 +92,6 @@ CONFIG_DM_SPI=y
 CONFIG_FSL_DSPI=y
 CONFIG_FSL_QSPI=y
 CONFIG_USB=y
-CONFIG_DM_USB=y
 CONFIG_USB_XHCI_HCD=y
 CONFIG_USB_XHCI_DWC3=y
 CONFIG_EFI_LOADER_BOUNCE_BUFFER=y