imx: nitrogen6x: Enabled data cache

[J-u-boot.git] / doc / README.mpc85xxads

diff --git a/doc/README.mpc85xxads b/doc/README.mpc85xxads
index ae8202bdd17d4146be4f0196dbb8ee4ab9d1a530..28bbcbe095dfa20b8af64369e47a5b6d667e69b2 100644 (file)
--- a/doc/README.mpc85xxads
+++ b/doc/README.mpc85xxads
@@ -35,7 +35,7 @@ Updated 13-July-2004 Jon Loeliger
     "On"  == 0
 
     SW18 is switch 18 as silk-screened onto the board.
-    SW4[8] is the bit labled 8 on Switch 4.
+    SW4[8] is the bit labeled 8 on Switch 4.
     SW2[1:6] refers to bits labeled 1 through 6 in order on switch 2
     SW3[7:1] refers to bits labeled 7 through 1 in order on switch 3
 
@@ -124,8 +124,8 @@ Updated 13-July-2004 Jon Loeliger
     kernel's ppcboot.h is consistent with U-Boot's u-boot.h. You can use two
     default configuration files as your starting points to configure the
     kernel:
-       arch/ppc/configs/mpc8540_ads_defconfig
-       arch/ppc/configs/mpc8560_ads_defconfig
+       arch/powerpc/configs/mpc8540_ads_defconfig
+       arch/powerpc/configs/mpc8560_ads_defconfig
 
 3. DEFINITIONS AND COMPILATION
 
@@ -144,8 +144,8 @@ Updated 13-July-2004 Jon Loeliger
                            also manual config the DDR after undef this
                            definition.
     CONFIG_DDR_ECC         only for ECC DDR module
-    CONFIG_DDR_DLL         DLL fix on some ADS boards needed for more
-                           stability.
+    CONFIG_SYS_FSL_ERRATUM_DDR_MSYNC_IN            DLL fix on some ADS boards needed
+                           for more stability.
     CONFIG_HAS_FEC         If an FEC is on chip, set to 1, else 0.
 
 Other than the above definitions, the rest in the config files are