board: phytec: am62a7: Add PHYTEC phyCORE-AM62A7 SoM

[J-u-boot.git] / configs / ls1012aqds_tfa_SECURE_BOOT_defconfig

diff --git a/configs/ls1012aqds_tfa_SECURE_BOOT_defconfig b/configs/ls1012aqds_tfa_SECURE_BOOT_defconfig
index dc0f1c5510f3d0fe6ecf12962147252b96d2c9d0..8dc27474200d199661f25987256a73be6c82765c 100644 (file)
--- a/configs/ls1012aqds_tfa_SECURE_BOOT_defconfig
+++ b/configs/ls1012aqds_tfa_SECURE_BOOT_defconfig
@@ -10,6 +10,7 @@ CONFIG_ENV_SIZE=0x2000
 CONFIG_DM_GPIO=y
 CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1012a-qds"
 CONFIG_QSPI_AHB_INIT=y
+CONFIG_SF_DEFAULT_BUS=1
 CONFIG_ARMV8_SEC_FIRMWARE_SUPPORT=y
 CONFIG_SEC_FIRMWARE_ARMV8_PSCI=y
 CONFIG_PCI=y
@@ -21,19 +22,18 @@ CONFIG_SYS_MEMTEST_START=0x80000000
 CONFIG_SYS_MEMTEST_END=0x9fffffff
 # CONFIG_SYS_MALLOC_F is not set
 CONFIG_FIT_VERBOSE=y
-CONFIG_OF_BOARD_SETUP=y
-CONFIG_OF_STDOUT_VIA_ALIAS=y
 CONFIG_DISTRO_DEFAULTS=y
 CONFIG_BOOTDELAY=10
+CONFIG_OF_BOARD_SETUP=y
+CONFIG_OF_STDOUT_VIA_ALIAS=y
 CONFIG_USE_BOOTARGS=y
 CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 quiet lpj=250000"
 # CONFIG_USE_BOOTCOMMAND is not set
+CONFIG_SYS_PBSIZE=532
 # CONFIG_DISPLAY_BOARDINFO is not set
 CONFIG_DISPLAY_BOARDINFO_LATE=y
 CONFIG_MISC_INIT_R=y
 CONFIG_ID_EEPROM=y
-CONFIG_SYS_MAXARGS=64
-CONFIG_SYS_PBSIZE=532
 CONFIG_CMD_GREPENV=y
 CONFIG_CMD_EEPROM=y
 CONFIG_SYS_EEPROM_PAGE_WRITE_BITS=3
@@ -60,7 +60,6 @@ CONFIG_SYS_I2C_EEPROM_ADDR=0x57
 CONFIG_FSL_ESDHC=y
 CONFIG_MTD=y
 CONFIG_DM_SPI_FLASH=y
-CONFIG_SF_DEFAULT_BUS=1
 # CONFIG_SPI_FLASH_BAR is not set
 CONFIG_SPI_FLASH_EON=y
 CONFIG_SPI_FLASH_SPANSION=y
@@ -74,7 +73,6 @@ CONFIG_PCIE_LAYERSCAPE_RC=y
 CONFIG_DM_RTC=y
 CONFIG_RTC_PCF8563=y
 CONFIG_SCSI=y
-CONFIG_DM_SCSI=y
 CONFIG_SYS_NS16550_SERIAL=y
 CONFIG_SPI=y
 CONFIG_DM_SPI=y