]> Git Repo - J-u-boot.git/blobdiff - configs/ls1043ardb_SECURE_BOOT_defconfig
Convert CONFIG_CONS_INDEX et al to Kconfig
[J-u-boot.git] / configs / ls1043ardb_SECURE_BOOT_defconfig
index 5c9fb914a3dc1da0c5a1cd5225a9009338115285..2d85f671cc2e7a41da9fd260403c796d920b8453 100644 (file)
@@ -18,6 +18,7 @@ CONFIG_OF_BOARD_SETUP=y
 CONFIG_BOOTDELAY=10
 CONFIG_USE_BOOTARGS=y
 CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 mtdparts=60000000.nor:2m@0x100000(nor_bank0_uboot),40m@0x1100000(nor_bank0_fit),7m(nor_bank0_user),2m@0x4100000(nor_bank4_uboot),40m@0x5100000(nor_bank4_fit),-(nor_bank4_user);7e800000.flash:1m(nand_uboot),1m(nand_uboot_env),20m(nand_fit);spi0.0:1m(uboot),5m(kernel),1m(dtb),9m(file_system)"
+CONFIG_BOOTCOMMAND="run distro_bootcmd; run nor_bootcmd; env exists secureboot && esbc_halt;"
 CONFIG_MISC_INIT_R=y
 CONFIG_CMD_IMLS=y
 CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
@@ -36,6 +37,7 @@ CONFIG_ENV_OVERWRITE=y
 CONFIG_DM=y
 # CONFIG_DDR_SPD is not set
 CONFIG_ECC_INIT_VIA_DDRCONTROLLER=y
+CONFIG_MPC8XXX_GPIO=y
 CONFIG_DM_I2C=y
 CONFIG_SPL_SYS_I2C_LEGACY=y
 CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
@@ -50,6 +52,9 @@ CONFIG_MTD_RAW_NAND=y
 CONFIG_NAND_FSL_IFC=y
 CONFIG_SYS_NAND_ONFI_DETECTION=y
 CONFIG_SF_DEFAULT_BUS=1
+CONFIG_SPI_FLASH_EON=y
+CONFIG_SPI_FLASH_STMICRO=y
+CONFIG_SPI_FLASH_SST=y
 CONFIG_PHYLIB=y
 CONFIG_PHY_REALTEK=y
 CONFIG_PHY_VITESSE=y
@@ -59,10 +64,10 @@ CONFIG_PHY_GIGE=y
 CONFIG_E1000=y
 CONFIG_FMAN_ENET=y
 CONFIG_SYS_FMAN_FW_ADDR=0x60900000
-CONFIG_SYS_QE_FW_ADDR=0x60940000
 CONFIG_NVME=y
 CONFIG_PCI=y
 CONFIG_PCIE_LAYERSCAPE_RC=y
+CONFIG_SYS_QE_FW_ADDR=0x60940000
 CONFIG_SYS_QE_FMAN_FW_IN_NOR=y
 CONFIG_SYS_NS16550=y
 CONFIG_SPI=y
This page took 0.030424 seconds and 4 git commands to generate.