Convert CONFIG_SYS_LOAD_ADDR to Kconfig

[J-u-boot.git] / configs / ls1021atwr_sdcard_qspi_defconfig

diff --git a/configs/ls1021atwr_sdcard_qspi_defconfig b/configs/ls1021atwr_sdcard_qspi_defconfig
index a231672ebc02e6cc453519ca1bf1dc481505bde2..b001a408e85e9b8ef0d2e50770118f7efa61e69b 100644 (file)
--- a/configs/ls1021atwr_sdcard_qspi_defconfig
+++ b/configs/ls1021atwr_sdcard_qspi_defconfig
@@ -3,16 +3,23 @@ CONFIG_TARGET_LS1021ATWR=y
 CONFIG_SYS_TEXT_BASE=0x82000000
 CONFIG_SPL_LIBCOMMON_SUPPORT=y
 CONFIG_SPL_LIBGENERIC_SUPPORT=y
-CONFIG_SPL_MMC_SUPPORT=y
-CONFIG_SPL_SERIAL_SUPPORT=y
+CONFIG_NR_DRAM_BANKS=1
+CONFIG_SYS_MEMTEST_START=0x80000000
+CONFIG_SYS_MEMTEST_END=0x9fffffff
 CONFIG_ENV_SIZE=0x20000
 CONFIG_ENV_OFFSET=0x300000
-CONFIG_NR_DRAM_BANKS=1
+CONFIG_SYS_I2C_MXC_I2C1=y
+CONFIG_SYS_I2C_MXC_I2C2=y
+CONFIG_SYS_I2C_MXC_I2C3=y
+CONFIG_DM_GPIO=y
+CONFIG_DEFAULT_DEVICE_TREE="ls1021a-twr-duart"
+CONFIG_SPL_TEXT_BASE=0x10000000
+CONFIG_SPL_MMC_SUPPORT=y
+CONFIG_SPL_SERIAL_SUPPORT=y
 CONFIG_SPL=y
 CONFIG_AHCI=y
-CONFIG_SPL_FSL_PBL=y
-CONFIG_SPL_TEXT_BASE=0x10000000
 CONFIG_DISTRO_DEFAULTS=y
+CONFIG_SYS_LOAD_ADDR=0x82000000
 CONFIG_FIT=y
 CONFIG_FIT_VERBOSE=y
 CONFIG_OF_BOARD_SETUP=y
@@ -23,48 +30,51 @@ CONFIG_BOOTDELAY=3
 CONFIG_USE_BOOTARGS=y
 CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0"
 CONFIG_SILENT_CONSOLE=y
-# CONFIG_CONSOLE_MUX is not set
 CONFIG_SYS_CONSOLE_IS_IN_ENV=y
 CONFIG_MISC_INIT_R=y
+CONFIG_ID_EEPROM=y
+CONFIG_SPL_FSL_PBL=y
 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y
 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0xe8
 CONFIG_SPL_ENV_SUPPORT=y
-CONFIG_SPL_I2C_SUPPORT=y
+CONFIG_SPL_I2C=y
 CONFIG_SPL_MPC8XXX_INIT_DDR_SUPPORT=y
-CONFIG_SPL_WATCHDOG_SUPPORT=y
+CONFIG_SPL_WATCHDOG=y
 CONFIG_CMD_GREPENV=y
+CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
 CONFIG_CMD_MEMINFO=y
 CONFIG_CMD_MEMTEST=y
+CONFIG_CMD_GPIO=y
 CONFIG_CMD_GPT=y
 CONFIG_CMD_I2C=y
 CONFIG_CMD_MMC=y
-CONFIG_CMD_SF=y
 CONFIG_CMD_USB=y
-CONFIG_CMD_BMP=y
 # CONFIG_SPL_EFI_PARTITION is not set
 CONFIG_OF_CONTROL=y
-CONFIG_DEFAULT_DEVICE_TREE="ls1021a-twr-duart"
+CONFIG_ENV_OVERWRITE=y
 CONFIG_ENV_IS_IN_MMC=y
 CONFIG_SYS_RELOC_GD_ENV_ADDR=y
 CONFIG_DM=y
 CONFIG_SATA_CEVA=y
 CONFIG_FSL_CAAM=y
-CONFIG_DM_MMC=y
+CONFIG_DM_I2C=y
+CONFIG_SPL_SYS_I2C_LEGACY=y
+CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
+CONFIG_SYS_I2C_EEPROM_ADDR=0x53
 CONFIG_FSL_ESDHC=y
 CONFIG_MTD=y
-CONFIG_SPI_FLASH=y
 CONFIG_SPI_FLASH_ATMEL=y
 CONFIG_SPI_FLASH_STMICRO=y
 CONFIG_PHY_ATHEROS=y
 CONFIG_DM_ETH=y
+CONFIG_DM_MDIO=y
 CONFIG_PHY_GIGE=y
 CONFIG_E1000=y
 CONFIG_MII=y
 CONFIG_TSEC_ENET=y
+CONFIG_NVME=y
 CONFIG_PCI=y
-CONFIG_DM_PCI=y
-CONFIG_DM_PCI_COMPAT=y
-CONFIG_PCIE_LAYERSCAPE=y
+CONFIG_PCIE_LAYERSCAPE_RC=y
 CONFIG_DM_SCSI=y
 CONFIG_SYS_NS16550=y
 CONFIG_SPI=y
@@ -72,9 +82,5 @@ CONFIG_DM_SPI=y
 CONFIG_FSL_DSPI=y
 CONFIG_FSL_QSPI=y
 CONFIG_USB=y
-CONFIG_DM_USB=y
 CONFIG_USB_XHCI_HCD=y
 CONFIG_USB_XHCI_DWC3=y
-CONFIG_VIDEO_FSL_DCU_FB=y
-CONFIG_VIDEO=y
-# CONFIG_VIDEO_SW_CURSOR is not set