Convert CONFIG_RESET_PHY_R to Kconfig

[J-u-boot.git] / configs / ls1088ardb_tfa_SECURE_BOOT_defconfig

diff --git a/configs/ls1088ardb_tfa_SECURE_BOOT_defconfig b/configs/ls1088ardb_tfa_SECURE_BOOT_defconfig
index 224cc63296a48e548d2120bf5602444245659e75..2ccf790cc06c3afa0efea01545e640e9a20fda36 100644 (file)
--- a/configs/ls1088ardb_tfa_SECURE_BOOT_defconfig
+++ b/configs/ls1088ardb_tfa_SECURE_BOOT_defconfig
@@ -3,6 +3,7 @@ CONFIG_GIC_V3_ITS=y
 CONFIG_TARGET_LS1088ARDB=y
 CONFIG_TFABOOT=y
 CONFIG_SYS_TEXT_BASE=0x82000000
+CONFIG_SYS_MALLOC_LEN=0x202000
 CONFIG_SYS_MALLOC_F_LEN=0x6000
 CONFIG_NR_DRAM_BANKS=2
 CONFIG_SYS_MEMTEST_START=0x80000000
@@ -11,22 +12,31 @@ CONFIG_ENV_SIZE=0x2000
 CONFIG_NXP_ESBC=y
 CONFIG_DM_GPIO=y
 CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1088a-rdb"
+CONFIG_FSL_USE_PCA9547_MUX=y
+CONFIG_VID=y
+CONFIG_SPL_VID=y
+CONFIG_VID_FLS_ENV="ls1088ardb_vdd_mv"
+CONFIG_VOL_MONITOR_LTC3882_READ=y
+CONFIG_VOL_MONITOR_LTC3882_SET=y
 CONFIG_QSPI_AHB_INIT=y
 CONFIG_ARMV8_SEC_FIRMWARE_SUPPORT=y
 CONFIG_SEC_FIRMWARE_ARMV8_PSCI=y
 CONFIG_AHCI=y
 CONFIG_DISTRO_DEFAULTS=y
+CONFIG_REMAKE_ELF=y
+CONFIG_MP=y
 CONFIG_FIT_VERBOSE=y
 CONFIG_OF_BOARD_SETUP=y
 CONFIG_OF_STDOUT_VIA_ALIAS=y
-CONFIG_SYS_EXTRA_OPTIONS="SYS_FSL_DDR4"
 CONFIG_USE_BOOTARGS=y
 CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 ramdisk_size=0x3000000 default_hugepagesz=2m hugepagesz=2m hugepages=256"
 # CONFIG_USE_BOOTCOMMAND is not set
 # CONFIG_DISPLAY_BOARDINFO is not set
 CONFIG_DISPLAY_BOARDINFO_LATE=y
 CONFIG_MISC_INIT_R=y
+CONFIG_RESET_PHY_R=y
 CONFIG_CMD_GREPENV=y
+CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
 CONFIG_CMD_MEMINFO=y
 CONFIG_CMD_MEMTEST=y
 CONFIG_CMD_DM=y
@@ -37,21 +47,28 @@ CONFIG_CMD_NAND=y
 CONFIG_CMD_PCI=y
 CONFIG_CMD_USB=y
 CONFIG_CMD_CACHE=y
-CONFIG_MP=y
 CONFIG_OF_CONTROL=y
 CONFIG_ENV_OVERWRITE=y
+CONFIG_USE_ETHPRIME=y
+CONFIG_ETHPRIME="DPMAC1@xgmii"
 CONFIG_NET_RANDOM_ETHADDR=y
 CONFIG_DM=y
+CONFIG_SATA=y
 CONFIG_SCSI_AHCI=y
 CONFIG_SATA_CEVA=y
+CONFIG_DDR_ECC=y
+CONFIG_ECC_INIT_VIA_DDRCONTROLLER=y
+CONFIG_MPC8XXX_GPIO=y
 CONFIG_DM_I2C=y
 CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
-CONFIG_I2C_DEFAULT_BUS_NUMBER=0
 CONFIG_I2C_MUX=y
 CONFIG_I2C_MUX_PCA954x=y
+CONFIG_SYS_I2C_EEPROM_ADDR=0x57
 CONFIG_FSL_ESDHC=y
 CONFIG_MTD=y
 CONFIG_MTD_RAW_NAND=y
+CONFIG_NAND_FSL_IFC=y
+CONFIG_SYS_NAND_ONFI_DETECTION=y
 CONFIG_DM_SPI_FLASH=y
 # CONFIG_SPI_FLASH_BAR is not set
 CONFIG_SPI_FLASH_SPANSION=y
@@ -60,13 +77,12 @@ CONFIG_PHYLIB=y
 CONFIG_PHY_VITESSE=y
 CONFIG_DM_ETH=y
 CONFIG_DM_MDIO=y
+CONFIG_PHY_GIGE=y
 CONFIG_E1000=y
 CONFIG_MII=y
 CONFIG_FSL_LS_MDIO=y
-CONFIG_NVME=y
+CONFIG_NVME_PCI=y
 CONFIG_PCI=y
-CONFIG_DM_PCI=y
-CONFIG_DM_PCI_COMPAT=y
 CONFIG_PCIE_LAYERSCAPE_RC=y
 CONFIG_DM_RTC=y
 CONFIG_RTC_PCF2127=y
@@ -77,7 +93,6 @@ CONFIG_DM_SPI=y
 CONFIG_FSL_DSPI=y
 CONFIG_FSL_QSPI=y
 CONFIG_USB=y
-CONFIG_DM_USB=y
 CONFIG_USB_XHCI_HCD=y
 CONFIG_USB_XHCI_DWC3=y
 CONFIG_USB_DWC3=y