Convert CONFIG_CONS_INDEX et al to Kconfig

[J-u-boot.git] / configs / ls1043aqds_nand_defconfig

diff --git a/configs/ls1043aqds_nand_defconfig b/configs/ls1043aqds_nand_defconfig
index 6b8c77b61440f62106d95f56a9ecfa2f97e9c0f4..9e60af28279aac063684c25dc6160a9bab60ea0e 100644 (file)
--- a/configs/ls1043aqds_nand_defconfig
+++ b/configs/ls1043aqds_nand_defconfig
@@ -1,6 +1,7 @@
 CONFIG_ARM=y
 CONFIG_TARGET_LS1043AQDS=y
 CONFIG_SYS_TEXT_BASE=0x82000000
+CONFIG_SYS_MALLOC_LEN=0x102000
 CONFIG_SPL_LIBCOMMON_SUPPORT=y
 CONFIG_SPL_LIBGENERIC_SUPPORT=y
 CONFIG_NR_DRAM_BANKS=2
@@ -8,18 +9,26 @@ CONFIG_SYS_MEMTEST_START=0x80000000
 CONFIG_SYS_MEMTEST_END=0x9fffffff
 CONFIG_ENV_SIZE=0x2000
 CONFIG_ENV_OFFSET=0x300000
+CONFIG_SYS_I2C_MXC_I2C1=y
+CONFIG_SYS_I2C_MXC_I2C2=y
+CONFIG_SYS_I2C_MXC_I2C3=y
+CONFIG_SYS_I2C_MXC_I2C4=y
 CONFIG_DM_GPIO=y
+CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1043a-qds-duart"
 CONFIG_SPL_TEXT_BASE=0x10000000
+CONFIG_FSL_USE_PCA9547_MUX=y
 CONFIG_FSL_LS_PPA=y
-CONFIG_SPL_SERIAL_SUPPORT=y
-CONFIG_SPL_DRIVERS_MISC_SUPPORT=y
+CONFIG_SPL_SERIAL=y
+CONFIG_SPL_DRIVERS_MISC=y
 CONFIG_SPL=y
-CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1043a-qds-duart"
 CONFIG_AHCI=y
 CONFIG_DISTRO_DEFAULTS=y
 CONFIG_FIT_VERBOSE=y
 CONFIG_OF_BOARD_SETUP=y
-CONFIG_SYS_EXTRA_OPTIONS="RAMBOOT_PBL,NAND_BOOT"
+CONFIG_SYS_EXTRA_OPTIONS="NAND_BOOT"
+CONFIG_RAMBOOT_PBL=y
+CONFIG_SYS_FSL_PBL_PBI="board/freescale/ls1043aqds/ls1043aqds_pbi.cfg"
+CONFIG_SYS_FSL_PBL_RCW="board/freescale/ls1043aqds/ls1043aqds_rcw_nand.cfg"
 CONFIG_NAND_BOOT=y
 CONFIG_BOOTDELAY=10
 CONFIG_USE_BOOTARGS=y
@@ -30,15 +39,17 @@ CONFIG_SPL_FSL_PBL=y
 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y
 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0xf0
 CONFIG_SPL_ENV_SUPPORT=y
-CONFIG_SPL_I2C_SUPPORT=y
-CONFIG_SPL_MPC8XXX_INIT_DDR_SUPPORT=y
+CONFIG_SPL_I2C=y
+CONFIG_SPL_MPC8XXX_INIT_DDR=y
 CONFIG_SPL_NAND_SUPPORT=y
-CONFIG_SPL_WATCHDOG_SUPPORT=y
+CONFIG_SPL_WATCHDOG=y
 CONFIG_CMD_BOOTZ=y
 CONFIG_CMD_IMLS=y
 CONFIG_CMD_GREPENV=y
+CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
 CONFIG_CMD_MEMINFO=y
 CONFIG_CMD_MEMTEST=y
+CONFIG_CMD_GPIO=y
 CONFIG_CMD_GPT=y
 CONFIG_CMD_I2C=y
 CONFIG_CMD_MMC=y
@@ -55,24 +66,37 @@ CONFIG_SYS_RELOC_GD_ENV_ADDR=y
 CONFIG_DM=y
 CONFIG_SATA_CEVA=y
 CONFIG_FSL_CAAM=y
+CONFIG_DYNAMIC_DDR_CLK_FREQ=y
+CONFIG_DDR_ECC=y
+CONFIG_ECC_INIT_VIA_DDRCONTROLLER=y
+CONFIG_MPC8XXX_GPIO=y
 CONFIG_DM_I2C=y
-CONFIG_DM_MMC=y
+CONFIG_SPL_SYS_I2C_LEGACY=y
+CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
+CONFIG_SYS_I2C_EEPROM_ADDR=0x57
 CONFIG_FSL_ESDHC=y
 CONFIG_MTD=y
 CONFIG_MTD_NOR_FLASH=y
 CONFIG_FLASH_CFI_DRIVER=y
 CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y
 CONFIG_SYS_FLASH_CFI=y
+CONFIG_NAND_FSL_IFC=y
+CONFIG_SYS_NAND_ONFI_DETECTION=y
+CONFIG_SYS_NAND_U_BOOT_LOCATIONS=y
+CONFIG_SYS_NAND_U_BOOT_OFFS=0x20000
 CONFIG_SF_DEFAULT_BUS=1
+CONFIG_SPI_FLASH_EON=y
+CONFIG_SPI_FLASH_STMICRO=y
+CONFIG_SPI_FLASH_SST=y
 CONFIG_PHYLIB=y
 CONFIG_PHYLIB_10G=y
 CONFIG_PHY_REALTEK=y
 CONFIG_PHY_VITESSE=y
 CONFIG_E1000=y
 CONFIG_FMAN_ENET=y
+CONFIG_SYS_FMAN_FW_ADDR=0x900000
 CONFIG_NVME=y
 CONFIG_PCI=y
-CONFIG_DM_PCI=y
 CONFIG_DM_PCI_COMPAT=y
 CONFIG_PCIE_LAYERSCAPE_RC=y
 CONFIG_SYS_QE_FMAN_FW_IN_NAND=y
@@ -81,7 +105,5 @@ CONFIG_SYS_NS16550=y
 CONFIG_SPI=y
 CONFIG_DM_SPI=y
 CONFIG_USB=y
-CONFIG_DM_USB=y
 CONFIG_USB_XHCI_HCD=y
 CONFIG_USB_XHCI_DWC3=y
-CONFIG_EFI_LOADER_BOUNCE_BUFFER=y