#define CONFIG_STATUS_LED 1 /* Status LED enabled */
#define CONFIG_BOARD_SPECIFIC_LED /* version has board specific leds */
-#define CONFIG_BOOTP_MASK (CONFIG_BOOTP_DEFAULT | CONFIG_BOOTP_BOOTFILESIZE | CONFIG_BOOTP_NISDOMAIN)
+/*
+ * BOOTP options
+ */
+#define CONFIG_BOOTP_SUBNETMASK
+#define CONFIG_BOOTP_GATEWAY
+#define CONFIG_BOOTP_HOSTNAME
+#define CONFIG_BOOTP_BOOTPATH
+#define CONFIG_BOOTP_BOOTFILESIZE
+#define CONFIG_BOOTP_NISDOMAIN
+
#undef CONFIG_MAC_PARTITION
#undef CONFIG_DOS_PARTITION
#define CONFIG_ENV_OVERWRITE 1 /* allow modification of vendor params */
-#define CONFIG_COMMANDS ( CONFIG_CMD_DFL | \
- CFG_CMD_NAND | \
- CFG_CMD_DHCP | \
- CFG_CMD_PING | \
- CFG_CMD_MII | \
- CFG_CMD_NFS)
+
+/*
+ * Command line configuration.
+ */
+#include <config_cmd_default.h>
+
+#define CONFIG_CMD_DHCP
+#define CONFIG_CMD_MII
+#define CONFIG_CMD_NAND
+#define CONFIG_CMD_NFS
+#define CONFIG_CMD_PING
+
#define CONFIG_BOARD_EARLY_INIT_F 1
#define CONFIG_MISC_INIT_R
-/* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
-#include <cmd_confdefs.h>
-
/*
* Miscellaneous configurable options
*/
#define CFG_HUSH_PARSER 1
#define CFG_PROMPT_HUSH_PS2 "> "
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
+#if defined(CONFIG_CMD_KGDB)
#define CFG_CBSIZE 1024 /* Console I/O Buffer Size */
#else
#define CFG_CBSIZE 256 /* Console I/O Buffer Size */
* Cache Configuration
*/
#define CFG_CACHELINE_SIZE 16 /* For all MPC8xx CPUs */
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
+#if defined(CONFIG_CMD_KGDB)
#define CFG_CACHELINE_SHIFT 4 /* log base 2 of the above value */
#endif
/****************************************************************/
/* NAND */
+#define CFG_NAND_LEGACY
#define CFG_NAND_BASE NAND_BASE
#define CONFIG_MTD_NAND_ECC_JFFS2
#define CONFIG_MTD_NAND_VERIFY_WRITE
#define CONFIG_CRC32_VERIFY 1
#define CONFIG_HUSH_OLD_PARSER_COMPATIBLE 1
-/* Note: change below for your network setting!!!
- * This was done just to facilitate manufacturing test and configuration.
- */
-#define CONFIG_ETHADDR 00:e0:0c:07:9b:8a
+/*****************************************************************************/
+
+/* pass open firmware flat tree */
+#define CONFIG_OF_FLAT_TREE 1
-#define CONFIG_SERVERIP 192.168.08.1
-#define CONFIG_IPADDR 192.168.08.85
-#define CONFIG_GATEWAYIP 192.168.08.1
-#define CONFIG_NETMASK 255.255.255.0
-#define CONFIG_HOSTNAME stx_xtc
-#define CONFIG_ROOTPATH /xtcroot
-#define CONFIG_BOOTFILE uImage
-#define CONFIG_LOADADDR 0x1000000
+/* maximum size of the flat tree (8K) */
+#define OF_FLAT_TREE_MAX_SIZE 8192
+#define OF_CPU "PowerPC,MPC870@0"
+#define OF_TBCLK (MPC8XX_HZ / 16)
+#define CONFIG_OF_HAS_BD_T 1
+#define CONFIG_OF_HAS_UBOOT_ENV 1
#endif /* __CONFIG_H */