sunxi: Enable AXP818 SW for Sinovoip BPI M3

[J-u-boot.git] / configs / Sinovoip_BPI_M3_defconfig

diff --git a/configs/Sinovoip_BPI_M3_defconfig b/configs/Sinovoip_BPI_M3_defconfig
index 2ff0058b7d7300119c00fd9ae31eef54c96b52da..29694ce1ef738997636fa38594c35e90f7f0547e 100644 (file)
--- a/configs/Sinovoip_BPI_M3_defconfig
+++ b/configs/Sinovoip_BPI_M3_defconfig
@@ -5,14 +5,31 @@ CONFIG_DRAM_TYPE=7
 CONFIG_DRAM_CLK=480
 CONFIG_DRAM_ZQ=15355
 CONFIG_DRAM_ODT_EN=y
+CONFIG_INITIAL_USB_SCAN_DELAY=500
+CONFIG_USB0_VBUS_PIN="AXP0-VBUS-ENABLE"
+CONFIG_USB0_VBUS_DET="AXP0-VBUS-DETECT"
+CONFIG_USB0_ID_DET="PH11"
+CONFIG_USB1_VBUS_PIN="PD24"
 CONFIG_AXP_GPIO=y
 CONFIG_DEFAULT_DEVICE_TREE="sun8i-a83t-sinovoip-bpi-m3"
 # CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
 CONFIG_SPL=y
+CONFIG_SYS_EXTRA_OPTIONS="SATAPWR=SUNXI_GPD(25)"
+CONFIG_HUSH_PARSER=y
+CONFIG_CMD_BOOTZ=y
 # CONFIG_CMD_IMLS is not set
 # CONFIG_CMD_FLASH is not set
+CONFIG_CMD_MMC=y
 # CONFIG_CMD_FPGA is not set
-CONFIG_AXP_DCDC1_VOLT=3000
+CONFIG_CMD_DHCP=y
+CONFIG_CMD_MII=y
+CONFIG_CMD_PING=y
+CONFIG_CMD_EXT2=y
+CONFIG_CMD_EXT4=y
+CONFIG_CMD_FAT=y
+CONFIG_CMD_FS_GENERIC=y
 CONFIG_AXP_DCDC5_VOLT=1200
-CONFIG_AXP_ALDO2_VOLT=0
-CONFIG_AXP_ALDO3_VOLT=0
+CONFIG_AXP_DLDO3_VOLT=2500
+CONFIG_AXP_SW_ON=y
+CONFIG_USB_EHCI_HCD=y
+CONFIG_USB_MUSB_HOST=y