Finish conversion of CONFIG_SYS_CLK_FREQ to Kconfig

[J-u-boot.git] / configs / ls1046aqds_sdcard_qspi_defconfig

diff --git a/configs/ls1046aqds_sdcard_qspi_defconfig b/configs/ls1046aqds_sdcard_qspi_defconfig
index 3761aafe8a18e51a2efee5a0eeadd23b7cd87e00..18f560e9473df81a5a238a70772349876a09fdb6 100644 (file)
--- a/configs/ls1046aqds_sdcard_qspi_defconfig
+++ b/configs/ls1046aqds_sdcard_qspi_defconfig
@@ -1,6 +1,7 @@
 CONFIG_ARM=y
 CONFIG_TARGET_LS1046AQDS=y
 CONFIG_SYS_TEXT_BASE=0x82000000
+CONFIG_SYS_MALLOC_LEN=0x102000
 CONFIG_SPL_LIBCOMMON_SUPPORT=y
 CONFIG_SPL_LIBGENERIC_SUPPORT=y
 CONFIG_NR_DRAM_BANKS=2
@@ -12,11 +13,14 @@ CONFIG_SYS_I2C_MXC_I2C1=y
 CONFIG_SYS_I2C_MXC_I2C2=y
 CONFIG_SYS_I2C_MXC_I2C3=y
 CONFIG_SYS_I2C_MXC_I2C4=y
-CONFIG_SYS_MALLOC_LEN=0x102000
 CONFIG_DM_GPIO=y
 CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1046a-qds-duart"
 CONFIG_SPL_TEXT_BASE=0x10000000
 CONFIG_FSL_USE_PCA9547_MUX=y
+CONFIG_VID=y
+CONFIG_VID_FLS_ENV="ls1046aqds_vdd_mv"
+CONFIG_VOL_MONITOR_INA220=y
+CONFIG_VOL_MONITOR_IR36021_SET=y
 CONFIG_FSL_LS_PPA=y
 CONFIG_SPL_MMC=y
 CONFIG_SPL_SERIAL=y
@@ -26,15 +30,16 @@ CONFIG_AHCI=y
 CONFIG_DISTRO_DEFAULTS=y
 CONFIG_FIT_VERBOSE=y
 CONFIG_OF_BOARD_SETUP=y
-CONFIG_SYS_EXTRA_OPTIONS="SD_BOOT_QSPI"
+CONFIG_DYNAMIC_SYS_CLK_FREQ=y
 CONFIG_RAMBOOT_PBL=y
 CONFIG_SYS_FSL_PBL_PBI="board/freescale/ls1046aqds/ls1046aqds_pbi.cfg"
 CONFIG_SYS_FSL_PBL_RCW="board/freescale/ls1046aqds/ls1046aqds_rcw_sd_qspi.cfg"
 CONFIG_SD_BOOT=y
+CONFIG_SD_BOOT_QSPI=y
 CONFIG_BOOTDELAY=10
 CONFIG_USE_BOOTARGS=y
 CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 mtdparts=1550000.spi-0:2m(uboot),14m(free)"
-# CONFIG_USE_BOOTCOMMAND is not set
+CONFIG_BOOTCOMMAND="run distro_bootcmd; run sd_bootcmd; env exists secureboot && esbc_halt;;"
 CONFIG_MISC_INIT_R=y
 CONFIG_SPL_FSL_PBL=y
 CONFIG_SPL_BOARD_INIT=y
@@ -69,13 +74,17 @@ CONFIG_FSL_CAAM=y
 CONFIG_DYNAMIC_DDR_CLK_FREQ=y
 CONFIG_DDR_ECC=y
 CONFIG_ECC_INIT_VIA_DDRCONTROLLER=y
+CONFIG_MPC8XXX_GPIO=y
 CONFIG_DM_I2C=y
 CONFIG_SYS_I2C_EARLY_INIT=y
 CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
 CONFIG_SYS_I2C_EEPROM_ADDR=0x57
 CONFIG_FSL_ESDHC=y
 # CONFIG_SPI_FLASH_BAR is not set
+CONFIG_SPI_FLASH_EON=y
 CONFIG_SPI_FLASH_SPANSION=y
+CONFIG_SPI_FLASH_STMICRO=y
+CONFIG_SPI_FLASH_SST=y
 # CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
 CONFIG_PHYLIB=y
 CONFIG_PHYLIB_10G=y
@@ -83,6 +92,7 @@ CONFIG_PHY_REALTEK=y
 CONFIG_PHY_VITESSE=y
 CONFIG_E1000=y
 CONFIG_FMAN_ENET=y
+CONFIG_SYS_FMAN_FW_ADDR=0x900000
 CONFIG_NVME=y
 CONFIG_PCI=y
 CONFIG_DM_PCI_COMPAT=y
@@ -98,4 +108,3 @@ CONFIG_FSL_QSPI=y
 CONFIG_USB=y
 CONFIG_USB_XHCI_HCD=y
 CONFIG_USB_XHCI_DWC3=y
-CONFIG_EFI_LOADER_BOUNCE_BUFFER=y