net: phy: micrel: add an option to disable gigabit for the KSZ9031

[J-u-boot.git] / configs / at91sam9260ek_nandflash_defconfig

diff --git a/configs/at91sam9260ek_nandflash_defconfig b/configs/at91sam9260ek_nandflash_defconfig
index e4fc8d705e15df2794189b959fd8d85888727527..312d820d7876352d0cef29b110bf1fa9f9368f44 100644 (file)
--- a/configs/at91sam9260ek_nandflash_defconfig
+++ b/configs/at91sam9260ek_nandflash_defconfig
@@ -1,12 +1,51 @@
 CONFIG_ARM=y
 CONFIG_ARCH_AT91=y
 CONFIG_TARGET_AT91SAM9260EK=y
+CONFIG_SYS_MALLOC_F_LEN=0x2000
+CONFIG_DEFAULT_DEVICE_TREE="at91sam9260ek"
+CONFIG_DEBUG_UART=y
 CONFIG_SYS_EXTRA_OPTIONS="AT91SAM9260,SYS_USE_NANDFLASH"
+CONFIG_ENV_IS_IN_NAND=y
+CONFIG_BOOTDELAY=3
+# CONFIG_DISPLAY_BOARDINFO is not set
+CONFIG_SYS_PROMPT="U-Boot> "
 # CONFIG_CMD_BDI is not set
+CONFIG_CMD_BOOTZ=y
 # CONFIG_CMD_IMI is not set
 # CONFIG_CMD_IMLS is not set
 # CONFIG_CMD_LOADS is not set
+CONFIG_CMD_NAND=y
+CONFIG_CMD_SF=y
+CONFIG_CMD_USB=y
 # CONFIG_CMD_FPGA is not set
 # CONFIG_CMD_SOURCE is not set
 # CONFIG_CMD_SETEXPR is not set
-CONFIG_SYS_PROMPT="U-Boot> "
+CONFIG_CMD_DHCP=y
+CONFIG_CMD_PING=y
+CONFIG_CMD_FAT=y
+CONFIG_OF_CONTROL=y
+CONFIG_DM=y
+CONFIG_CLK=y
+CONFIG_CLK_AT91=y
+CONFIG_DM_GPIO=y
+CONFIG_AT91_GPIO=y
+# CONFIG_MMC is not set
+CONFIG_DM_SPI_FLASH=y
+CONFIG_SPI_FLASH=y
+CONFIG_SPI_FLASH_ATMEL=y
+CONFIG_SPI_FLASH_DATAFLASH=y
+CONFIG_DM_ETH=y
+CONFIG_MACB=y
+CONFIG_PINCTRL=y
+CONFIG_PINCTRL_AT91=y
+CONFIG_DM_SERIAL=y
+CONFIG_DEBUG_UART_ATMEL=y
+CONFIG_DEBUG_UART_BASE=0xfffff200
+CONFIG_DEBUG_UART_CLOCK=132000000
+CONFIG_DEBUG_UART_BOARD_INIT=y
+CONFIG_DEBUG_UART_ANNOUNCE=y
+CONFIG_ATMEL_USART=y
+CONFIG_DM_SPI=y
+CONFIG_ATMEL_SPI=y
+CONFIG_USB=y
+CONFIG_USB_STORAGE=y