Convert CONFIG_CONS_INDEX et al to Kconfig

[J-u-boot.git] / include / configs / etamin.h

diff --git a/include/configs/etamin.h b/include/configs/etamin.h
index 880149fb890298622610e3f7fe27fa8af8cee57f..dc83ab71908b4fee5d7ba9015a122c58128a1ff4 100644 (file)
--- a/include/configs/etamin.h
+++ b/include/configs/etamin.h
@@ -14,19 +14,10 @@
 
 #include "siemens-am33x-common.h"
 /* NAND specific changes for etamin due to different page size */
-#undef CONFIG_SYS_NAND_PAGE_SIZE
-#undef CONFIG_SYS_NAND_OOBSIZE
-#undef CONFIG_SYS_NAND_BLOCK_SIZE
 #undef CONFIG_SYS_NAND_ECCPOS
-#undef CONFIG_SYS_NAND_U_BOOT_OFFS
 #undef CONFIG_SYS_ENV_SECT_SIZE
-#undef CONFIG_NAND_OMAP_ECCSCHEME
-#define CONFIG_NAND_OMAP_ECCSCHEME     OMAP_ECC_BCH16_CODE_HW
 
 #define CONFIG_SYS_ENV_SECT_SIZE       (512 << 10)     /* 512 KiB */
-#define CONFIG_SYS_NAND_PAGE_SIZE       4096
-#define CONFIG_SYS_NAND_OOBSIZE         224
-#define CONFIG_SYS_NAND_BLOCK_SIZE      (128 * CONFIG_SYS_NAND_PAGE_SIZE)
 #define CONFIG_SYS_NAND_ECCPOS { 2, 3, 4, 5, 6, 7, 8, 9, \
                                10, 11, 12, 13, 14, 15, 16, 17, 18, 19, \
                                20, 21, 22, 23, 24, 25, 26, 27, 28, 29, \
@@ -55,17 +46,12 @@
 #define CONFIG_SYS_NAND_ECCSIZE 512
 #define CONFIG_SYS_NAND_ECCBYTES 26
 
-#define CONFIG_SYS_NAND_U_BOOT_OFFS     0x200000
-
-#define CONFIG_SYS_NAND_MAX_CHIPS       1
-
 #undef CONFIG_SYS_MAX_NAND_DEVICE
 #define CONFIG_SYS_MAX_NAND_DEVICE      3
 #define CONFIG_SYS_NAND_BASE2           (0x18000000)    /* physical address */
 #define CONFIG_SYS_NAND_BASE_LIST       {CONFIG_SYS_NAND_BASE, \
                                        CONFIG_SYS_NAND_BASE2}
 
-#define CONFIG_SYS_NAND_ONFI_DETECTION
 #define DDR_PLL_FREQ   303
 
 /* FWD Button = 27
@@ -86,10 +72,6 @@
 /* Physical Memory Map */
 #define CONFIG_MAX_RAM_BANK_SIZE       (1024 << 20)    /* 1GB */
 
-/* I2C Configuration */
-#define CONFIG_SYS_I2C_SPEED           100000
-
-#define CONFIG_SYS_I2C_EEPROM_ADDR              0x50
 #define EEPROM_ADDR_DDR3 0x90
 #define EEPROM_ADDR_CHIP 0x120
 
@@ -102,15 +84,11 @@
 */
 
 /* nedded by compliance test in read mode */
-#if defined(CONFIG_SPL_CMT)
-#define CONFIG_SYS_DCACHE_OFF
-#endif
 
 /* Define own nand partitions */
 #define CONFIG_ENV_RANGE               (4 * CONFIG_SYS_ENV_SECT_SIZE)
 
 
-
 #undef COMMON_ENV_DFU_ARGS
 #define COMMON_ENV_DFU_ARGS    "dfu_args=run bootargs_defaults;" \
                                "setenv bootargs ${bootargs};" \
@@ -185,26 +163,5 @@
        CONFIG_ENV_SETTINGS_BUTTONS_AND_LEDS \
        CONFIG_ENV_SETTINGS_V2 \
        CONFIG_ENV_SETTINGS_NAND_V2
-
-#ifndef CONFIG_RESTORE_FLASH
-
-#define CONFIG_BOOTCOMMAND \
-"if dfubutton; then " \
-       "run dfu_start; " \
-       "reset; " \
-"fi;" \
-"run nand_boot;" \
-"run nand_boot_backup;" \
-"reset;"
-
-
-#else
-#define CONFIG_BOOTCOMMAND                     \
-       "setenv autoload no; "                  \
-       "dhcp; "                                \
-       "if tftp 80000000 debrick.scr; then "   \
-               "source 80000000; "             \
-       "fi"
-#endif
 #endif /* CONFIG_SPL_BUILD */
 #endif /* ! __CONFIG_ETAMIN_H */