| | 1 | CONFIG_ARM=y |
| | 2 | CONFIG_SKIP_LOWLEVEL_INIT=y |
| | 3 | CONFIG_SYS_DCACHE_OFF=y |
| | 4 | CONFIG_ARCH_CPU_INIT=y |
| | 5 | CONFIG_ARCH_KIRKWOOD=y |
| | 6 | CONFIG_SYS_KWD_CONFIG="board/LaCie/netspace_v2/kwbimage-ns2l.cfg" |
| | 7 | CONFIG_TEXT_BASE=0x600000 |
| | 8 | CONFIG_NR_DRAM_BANKS=2 |
| | 9 | CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0xc8012000 |
| | 10 | CONFIG_TARGET_NETSPACE_V2=y |
| | 11 | CONFIG_NETSPACE_LITE_V2=y |
| | 12 | CONFIG_ENV_SIZE=0x1000 |
| | 13 | CONFIG_ENV_OFFSET=0x70000 |
| | 14 | CONFIG_ENV_SECT_SIZE=0x10000 |
| | 15 | CONFIG_DEFAULT_DEVICE_TREE="kirkwood-ns2lite" |
| | 16 | CONFIG_SYS_PROMPT="ns2> " |
| | 17 | CONFIG_IDENT_STRING=" NS v2 Lite" |
| | 18 | CONFIG_SYS_LOAD_ADDR=0x800000 |
| | 19 | CONFIG_ENV_ADDR=0x70000 |
| | 20 | # CONFIG_SYS_MALLOC_F is not set |
| | 21 | CONFIG_BOOTDELAY=3 |
| | 22 | CONFIG_USE_BOOTARGS=y |
| | 23 | CONFIG_BOOTARGS="console=ttyS0,115200" |
| | 24 | CONFIG_USE_BOOTCOMMAND=y |
| | 25 | CONFIG_BOOTCOMMAND="dhcp && run netconsole; if run usbload || run diskload; then bootm; fi" |
| | 26 | CONFIG_USE_PREBOOT=y |
| | 27 | CONFIG_CONSOLE_MUX=y |
| | 28 | # CONFIG_DISPLAY_BOARDINFO is not set |
| | 29 | CONFIG_MISC_INIT_R=y |
| | 30 | CONFIG_RESET_PHY_R=y |
| | 31 | CONFIG_HUSH_PARSER=y |
| | 32 | CONFIG_SYS_MAXARGS=32 |
| | 33 | CONFIG_SYS_PBSIZE=1046 |
| | 34 | CONFIG_CMD_EEPROM=y |
| | 35 | CONFIG_SYS_EEPROM_PAGE_WRITE_BITS=4 |
| | 36 | CONFIG_CMD_I2C=y |
| | 37 | CONFIG_CMD_SATA=y |
| | 38 | CONFIG_CMD_USB=y |
| | 39 | # CONFIG_CMD_SETEXPR is not set |
| | 40 | CONFIG_CMD_DHCP=y |
| | 41 | CONFIG_SYS_DISABLE_AUTOLOAD=y |
| | 42 | CONFIG_CMD_MII=y |
| | 43 | CONFIG_CMD_PING=y |
| | 44 | CONFIG_CMD_EXT2=y |
| | 45 | CONFIG_CMD_FAT=y |
| | 46 | CONFIG_ISO_PARTITION=y |
| | 47 | CONFIG_EFI_PARTITION=y |
| | 48 | # CONFIG_PARTITION_UUIDS is not set |
| | 49 | CONFIG_OF_CONTROL=y |
| | 50 | CONFIG_ENV_OVERWRITE=y |
| | 51 | CONFIG_ENV_IS_IN_SPI_FLASH=y |
| | 52 | CONFIG_ENV_SPI_MAX_HZ=20000000 |
| | 53 | CONFIG_NETCONSOLE=y |
| | 54 | CONFIG_SYS_FAULT_ECHO_LINK_DOWN=y |
| | 55 | CONFIG_SATA_MV=y |
| | 56 | CONFIG_SYS_SATA_MAX_DEVICE=1 |
| | 57 | CONFIG_LBA48=y |
| | 58 | CONFIG_SYS_64BIT_LBA=y |
| | 59 | CONFIG_KIRKWOOD_GPIO=y |
| | 60 | CONFIG_SYS_I2C_LEGACY=y |
| | 61 | CONFIG_SYS_I2C_MVTWSI=y |
| | 62 | CONFIG_SYS_I2C_SLAVE=0x0 |
| | 63 | CONFIG_SYS_I2C_EEPROM_ADDR=0x50 |
| | 64 | # CONFIG_MMC is not set |
| | 65 | CONFIG_DM_SPI_FLASH=y |
| | 66 | CONFIG_SPI_FLASH_MACRONIX=y |
| | 67 | CONFIG_MVGBE=y |
| | 68 | CONFIG_MII=y |
| | 69 | CONFIG_SYS_NS16550_SERIAL=y |
| | 70 | CONFIG_SYS_NS16550_REG_SIZE=-4 |
| | 71 | CONFIG_SPI=y |
| | 72 | CONFIG_DM_SPI=y |
| | 73 | CONFIG_KIRKWOOD_SPI=y |
| | 74 | CONFIG_USB=y |
| | 75 | CONFIG_USB_EHCI_HCD=y |
| | 76 | CONFIG_USB_STORAGE=y |
projects / J-u-boot.git / blame_incremental