| | 1 | CONFIG_ARM=y |
| | 2 | CONFIG_TARGET_LS1043ARDB=y |
| | 3 | CONFIG_SYS_TEXT_BASE=0x82000000 |
| | 4 | CONFIG_SYS_MALLOC_LEN=0x102000 |
| | 5 | CONFIG_SPL_LIBCOMMON_SUPPORT=y |
| | 6 | CONFIG_SPL_LIBGENERIC_SUPPORT=y |
| | 7 | CONFIG_NR_DRAM_BANKS=2 |
| | 8 | CONFIG_ENV_SIZE=0x2000 |
| | 9 | CONFIG_ENV_OFFSET=0x300000 |
| | 10 | CONFIG_SYS_I2C_MXC_I2C1=y |
| | 11 | CONFIG_SYS_I2C_MXC_I2C2=y |
| | 12 | CONFIG_SYS_I2C_MXC_I2C3=y |
| | 13 | CONFIG_SYS_I2C_MXC_I2C4=y |
| | 14 | CONFIG_DM_GPIO=y |
| | 15 | CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1043a-rdb" |
| | 16 | CONFIG_SPL_TEXT_BASE=0x10000000 |
| | 17 | CONFIG_FSL_LS_PPA=y |
| | 18 | CONFIG_SPL_MMC=y |
| | 19 | CONFIG_SPL_SERIAL=y |
| | 20 | CONFIG_SPL_DRIVERS_MISC=y |
| | 21 | CONFIG_SPL=y |
| | 22 | CONFIG_DISTRO_DEFAULTS=y |
| | 23 | CONFIG_REMAKE_ELF=y |
| | 24 | CONFIG_MP=y |
| | 25 | CONFIG_FIT_VERBOSE=y |
| | 26 | CONFIG_OF_BOARD_SETUP=y |
| | 27 | CONFIG_RAMBOOT_PBL=y |
| | 28 | CONFIG_SYS_FSL_PBL_PBI="board/freescale/ls1043ardb/ls1043ardb_pbi.cfg" |
| | 29 | CONFIG_SYS_FSL_PBL_RCW="board/freescale/ls1043ardb/ls1043ardb_rcw_sd.cfg" |
| | 30 | CONFIG_SD_BOOT=y |
| | 31 | CONFIG_BOOTDELAY=10 |
| | 32 | CONFIG_USE_BOOTARGS=y |
| | 33 | CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 mtdparts=60000000.nor:2m@0x100000(nor_bank0_uboot),40m@0x1100000(nor_bank0_fit),7m(nor_bank0_user),2m@0x4100000(nor_bank4_uboot),40m@0x5100000(nor_bank4_fit),-(nor_bank4_user);7e800000.flash:1m(nand_uboot),1m(nand_uboot_env),20m(nand_fit);spi0.0:1m(uboot),5m(kernel),1m(dtb),9m(file_system)" |
| | 34 | CONFIG_BOOTCOMMAND="run distro_bootcmd; run sd_bootcmd; env exists secureboot && esbc_halt;" |
| | 35 | CONFIG_ARCH_MISC_INIT=y |
| | 36 | CONFIG_MISC_INIT_R=y |
| | 37 | CONFIG_SPL_FSL_PBL=y |
| | 38 | CONFIG_SPL_BOARD_INIT=y |
| | 39 | CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y |
| | 40 | CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0xf0 |
| | 41 | CONFIG_SPL_ENV_SUPPORT=y |
| | 42 | CONFIG_SPL_MPC8XXX_INIT_DDR=y |
| | 43 | CONFIG_SPL_WATCHDOG=y |
| | 44 | CONFIG_CMD_IMLS=y |
| | 45 | CONFIG_CMD_SPL=y |
| | 46 | CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5 |
| | 47 | CONFIG_CMD_DM=y |
| | 48 | CONFIG_CMD_GPIO=y |
| | 49 | CONFIG_CMD_GPT=y |
| | 50 | CONFIG_CMD_I2C=y |
| | 51 | CONFIG_CMD_MMC=y |
| | 52 | CONFIG_CMD_NAND=y |
| | 53 | CONFIG_CMD_USB=y |
| | 54 | CONFIG_CMD_CACHE=y |
| | 55 | CONFIG_MTDPARTS_DEFAULT="mtdparts=60000000.nor:2m@0x100000(nor_bank0_uboot),40m@0x1100000(nor_bank0_fit),7m(nor_bank0_user),2m@0x4100000(nor_bank4_uboot),40m@0x5100000(nor_bank4_fit),-(nor_bank4_user);7e800000.flash:1m(nand_uboot),1m(nand_uboot_env),20m(nand_fit);spi0.0:1m(uboot),5m(kernel),1m(dtb),9m(file_system)" |
| | 56 | # CONFIG_SPL_EFI_PARTITION is not set |
| | 57 | CONFIG_OF_CONTROL=y |
| | 58 | CONFIG_ENV_OVERWRITE=y |
| | 59 | CONFIG_ENV_IS_IN_MMC=y |
| | 60 | CONFIG_SYS_RELOC_GD_ENV_ADDR=y |
| | 61 | CONFIG_USE_ETHPRIME=y |
| | 62 | CONFIG_ETHPRIME="FM1@DTSEC3" |
| | 63 | CONFIG_DM=y |
| | 64 | CONFIG_FSL_CAAM=y |
| | 65 | CONFIG_MPC8XXX_GPIO=y |
| | 66 | CONFIG_DM_I2C=y |
| | 67 | CONFIG_SPL_SYS_I2C_LEGACY=y |
| | 68 | CONFIG_I2C_SET_DEFAULT_BUS_NUM=y |
| | 69 | CONFIG_SYS_I2C_EEPROM_ADDR=0x53 |
| | 70 | CONFIG_FSL_ESDHC=y |
| | 71 | CONFIG_MTD=y |
| | 72 | CONFIG_MTD_NOR_FLASH=y |
| | 73 | CONFIG_FLASH_CFI_DRIVER=y |
| | 74 | CONFIG_CFI_FLASH_USE_WEAK_ACCESSORS=y |
| | 75 | CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y |
| | 76 | CONFIG_SYS_FLASH_CFI=y |
| | 77 | CONFIG_MTD_RAW_NAND=y |
| | 78 | CONFIG_NAND_FSL_IFC=y |
| | 79 | CONFIG_SYS_NAND_ONFI_DETECTION=y |
| | 80 | CONFIG_SF_DEFAULT_BUS=1 |
| | 81 | CONFIG_SPI_FLASH_EON=y |
| | 82 | CONFIG_SPI_FLASH_STMICRO=y |
| | 83 | CONFIG_SPI_FLASH_SST=y |
| | 84 | CONFIG_PHYLIB=y |
| | 85 | CONFIG_PHY_AQUANTIA=y |
| | 86 | CONFIG_PHY_REALTEK=y |
| | 87 | CONFIG_PHY_VITESSE=y |
| | 88 | CONFIG_DM_ETH=y |
| | 89 | CONFIG_DM_MDIO=y |
| | 90 | CONFIG_E1000=y |
| | 91 | CONFIG_FMAN_ENET=y |
| | 92 | CONFIG_SYS_FMAN_FW_ADDR=0x900000 |
| | 93 | CONFIG_NVME_PCI=y |
| | 94 | CONFIG_PCI=y |
| | 95 | CONFIG_PCIE_LAYERSCAPE_RC=y |
| | 96 | CONFIG_SYS_QE_FW_ADDR=0x940000 |
| | 97 | CONFIG_SYS_QE_FMAN_FW_IN_MMC=y |
| | 98 | CONFIG_SYS_NS16550=y |
| | 99 | CONFIG_SPI=y |
| | 100 | CONFIG_DM_SPI=y |
| | 101 | CONFIG_USB=y |
| | 102 | CONFIG_USB_XHCI_HCD=y |
| | 103 | CONFIG_USB_XHCI_DWC3=y |
| | 104 | # CONFIG_SPL_USE_TINY_PRINTF is not set |
| | 105 | CONFIG_EFI_LOADER_BOUNCE_BUFFER=y |
projects / J-u-boot.git / blame_incremental