| | 1 | CONFIG_ARM=y |
| | 2 | CONFIG_SKIP_LOWLEVEL_INIT=y |
| | 3 | CONFIG_ARCH_AT91=y |
| | 4 | CONFIG_SYS_TEXT_BASE=0x73f00000 |
| | 5 | CONFIG_SYS_MALLOC_LEN=0x80000 |
| | 6 | CONFIG_TARGET_AT91SAM9M10G45EK=y |
| | 7 | CONFIG_ATMEL_LEGACY=y |
| | 8 | CONFIG_NR_DRAM_BANKS=1 |
| | 9 | CONFIG_DM_GPIO=y |
| | 10 | CONFIG_DEFAULT_DEVICE_TREE="at91sam9m10g45ek" |
| | 11 | CONFIG_DEBUG_UART_BASE=0xffffee00 |
| | 12 | CONFIG_DEBUG_UART_CLOCK=132000000 |
| | 13 | CONFIG_DEBUG_UART_BOARD_INIT=y |
| | 14 | CONFIG_ENV_OFFSET_REDUND=0x100000 |
| | 15 | CONFIG_SYS_LOAD_ADDR=0x22000000 |
| | 16 | CONFIG_DEBUG_UART=y |
| | 17 | CONFIG_HAS_CUSTOM_SYS_INIT_SP_ADDR=y |
| | 18 | CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0x70003f00 |
| | 19 | CONFIG_NAND_BOOT=y |
| | 20 | CONFIG_BOOTDELAY=3 |
| | 21 | CONFIG_USE_BOOTARGS=y |
| | 22 | CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk mtdparts=atmel_nand:256k(bootstrap)ro,512k(uboot)ro,256k(env),256k(env_redundant),256k(spare),512k(dtb),6M(kernel)ro,-(rootfs) root=/dev/mtdblock7 rw rootfstype=jffs2" |
| | 23 | CONFIG_USE_BOOTCOMMAND=y |
| | 24 | CONFIG_BOOTCOMMAND="nand read 0x70000000 0x200000 0x300000;bootm 0x70000000" |
| | 25 | CONFIG_SYS_CONSOLE_IS_IN_ENV=y |
| | 26 | # CONFIG_DISPLAY_BOARDINFO is not set |
| | 27 | CONFIG_RESET_PHY_R=y |
| | 28 | CONFIG_HUSH_PARSER=y |
| | 29 | CONFIG_SYS_PROMPT="U-Boot> " |
| | 30 | CONFIG_SYS_CBSIZE=256 |
| | 31 | CONFIG_SYS_PBSIZE=281 |
| | 32 | # CONFIG_CMD_BDI is not set |
| | 33 | CONFIG_CMD_BOOTZ=y |
| | 34 | # CONFIG_CMD_IMI is not set |
| | 35 | # CONFIG_CMD_FLASH is not set |
| | 36 | # CONFIG_CMD_LOADS is not set |
| | 37 | CONFIG_CMD_MMC=y |
| | 38 | CONFIG_CMD_NAND=y |
| | 39 | CONFIG_CMD_USB=y |
| | 40 | # CONFIG_CMD_SETEXPR is not set |
| | 41 | CONFIG_CMD_DHCP=y |
| | 42 | CONFIG_BOOTP_BOOTFILESIZE=y |
| | 43 | CONFIG_CMD_PING=y |
| | 44 | CONFIG_CMD_FAT=y |
| | 45 | CONFIG_OF_CONTROL=y |
| | 46 | CONFIG_ENV_IS_IN_NAND=y |
| | 47 | CONFIG_SYS_REDUNDAND_ENVIRONMENT=y |
| | 48 | CONFIG_SYS_RELOC_GD_ENV_ADDR=y |
| | 49 | CONFIG_DM=y |
| | 50 | CONFIG_CLK=y |
| | 51 | CONFIG_CLK_AT91=y |
| | 52 | CONFIG_AT91_GPIO=y |
| | 53 | CONFIG_GENERIC_ATMEL_MCI=y |
| | 54 | CONFIG_MTD=y |
| | 55 | CONFIG_NAND_ATMEL=y |
| | 56 | CONFIG_DM_ETH=y |
| | 57 | CONFIG_MACB=y |
| | 58 | CONFIG_PINCTRL=y |
| | 59 | CONFIG_PINCTRL_AT91=y |
| | 60 | CONFIG_DM_SERIAL=y |
| | 61 | CONFIG_DEBUG_UART_ANNOUNCE=y |
| | 62 | CONFIG_ATMEL_USART=y |
| | 63 | CONFIG_TIMER=y |
| | 64 | CONFIG_ATMEL_PIT_TIMER=y |
| | 65 | CONFIG_USB=y |
| | 66 | CONFIG_USB_EHCI_HCD=y |
| | 67 | CONFIG_USB_STORAGE=y |
projects / J-u-boot.git / blame_incremental