xilinx: zynqmp: Enable gpio-key/button driver

[J-u-boot.git] / configs / udoo_defconfig

CONFIG_ARM=y
CONFIG_ARCH_MX6=y
CONFIG_SYS_TEXT_BASE=0x17800000
CONFIG_SPL_GPIO=y
CONFIG_SPL_LIBCOMMON_SUPPORT=y
CONFIG_SPL_LIBGENERIC_SUPPORT=y
CONFIG_NR_DRAM_BANKS=1
CONFIG_ENV_SIZE=0x2000
CONFIG_ENV_OFFSET=0x60000
CONFIG_MX6QDL=y
CONFIG_TARGET_UDOO=y
CONFIG_DM_GPIO=y
CONFIG_DEFAULT_DEVICE_TREE="imx6q-udoo"
CONFIG_SPL_TEXT_BASE=0x00908000
CONFIG_SPL_MMC_SUPPORT=y
CONFIG_SPL_SERIAL_SUPPORT=y
CONFIG_SPL=y
CONFIG_SPL_LIBDISK_SUPPORT=y
CONFIG_AHCI=y
CONFIG_DISTRO_DEFAULTS=y
CONFIG_SYS_EXTRA_OPTIONS="IMX_CONFIG=arch/arm/mach-imx/spl_sd.cfg"
CONFIG_BOOTDELAY=3
CONFIG_BOOTCOMMAND="run findfdt; run distro_bootcmd"
CONFIG_BOARD_EARLY_INIT_F=y
CONFIG_SPL_FS_EXT4=y
CONFIG_SPL_I2C=y
CONFIG_SPL_WATCHDOG=y
CONFIG_CMD_GPIO=y
CONFIG_CMD_MMC=y
# CONFIG_CMD_PINMUX is not set
CONFIG_CMD_SATA=y
CONFIG_CMD_CACHE=y
CONFIG_CMD_EXT4_WRITE=y
CONFIG_OF_CONTROL=y
CONFIG_ENV_OVERWRITE=y
CONFIG_ENV_IS_IN_MMC=y
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG=y
CONFIG_DM=y
CONFIG_BOUNCE_BUFFER=y
CONFIG_DWC_AHSATA=y
CONFIG_FSL_USDHC=y
CONFIG_PHYLIB=y
CONFIG_PHY_MICREL=y
CONFIG_PHY_MICREL_KSZ90X1=y
CONFIG_DM_ETH=y
CONFIG_FEC_MXC=y
CONFIG_MII=y
CONFIG_PINCTRL=y
CONFIG_PINCTRL_IMX6=y
CONFIG_DM_SCSI=y
CONFIG_MXC_UART=y
CONFIG_DM_THERMAL=y