test: dm: add button_cmd test

[J-u-boot.git] / configs / meesc_defconfig

CONFIG_ARM=y
CONFIG_SKIP_LOWLEVEL_INIT=y
CONFIG_ARCH_CPU_INIT=y
CONFIG_ARCH_AT91=y
CONFIG_TEXT_BASE=0x21F00000
CONFIG_SYS_MALLOC_LEN=0x80000
CONFIG_TARGET_MEESC=y
CONFIG_NR_DRAM_BANKS=1
CONFIG_ENV_OFFSET=0xC0000
CONFIG_DM_GPIO=y
CONFIG_DEFAULT_DEVICE_TREE="at91sam9263ek"
CONFIG_SYS_LOAD_ADDR=0x20100000
CONFIG_FIT=y
CONFIG_NAND_BOOT=y
CONFIG_BOOTDELAY=3
CONFIG_USE_PREBOOT=y
CONFIG_SYS_CBSIZE=512
CONFIG_SYS_PBSIZE=532
CONFIG_BOARD_EARLY_INIT_F=y
CONFIG_MISC_INIT_R=y
CONFIG_HUSH_PARSER=y
# CONFIG_CMD_BDI is not set
CONFIG_CMD_BOOTZ=y
# CONFIG_CMD_LOADS is not set
CONFIG_CMD_NAND=y
# CONFIG_CMD_SETEXPR is not set
CONFIG_CMD_DHCP=y
CONFIG_BOOTP_BOOTFILESIZE=y
CONFIG_CMD_PING=y
CONFIG_OF_CONTROL=y
CONFIG_ENV_IS_IN_NAND=y
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
CONFIG_NET_RETRY_COUNT=20
CONFIG_CLK=y
CONFIG_CLK_AT91=y
CONFIG_AT91_GPIO=y
# CONFIG_MMC is not set
CONFIG_MTD=y
# CONFIG_SYS_NAND_USE_FLASH_BBT is not set
CONFIG_NAND_ATMEL=y
CONFIG_DM_SPI_FLASH=y
CONFIG_SPI_FLASH_ATMEL=y
CONFIG_SPI_FLASH_DATAFLASH=y
CONFIG_MACB=y
CONFIG_RMII=y
CONFIG_PINCTRL=y
CONFIG_PINCTRL_AT91=y
CONFIG_DM_SERIAL=y
CONFIG_ATMEL_USART=y
CONFIG_SPI=y
CONFIG_DM_SPI=y