configs: Migrate and re-enabled CONFIG_CMD_MTDPARTS

[J-u-boot.git] / configs / corvus_defconfig

CONFIG_ARM=y
# CONFIG_SPL_USE_ARCH_MEMCPY is not set
# CONFIG_SPL_USE_ARCH_MEMSET is not set
CONFIG_ARCH_AT91=y
CONFIG_SYS_TEXT_BASE=0x72000000
CONFIG_TARGET_CORVUS=y
CONFIG_SPL_GPIO_SUPPORT=y
CONFIG_SPL_LIBCOMMON_SUPPORT=y
CONFIG_SPL_LIBGENERIC_SUPPORT=y
CONFIG_SYS_MALLOC_F_LEN=0x800
CONFIG_SPL_SERIAL_SUPPORT=y
CONFIG_SPL=y
CONFIG_NR_DRAM_BANKS=1
CONFIG_SYS_EXTRA_OPTIONS="AT91SAM9M10G45,MACH_TYPE=2066,SYS_USE_NANDFLASH"
CONFIG_BOOTDELAY=3
CONFIG_USE_BOOTARGS=y
CONFIG_BOOTARGS="console=ttyS0,115200 earlyprintk mtdparts=atmel_nand:256k(bootstrap)ro,512k(uboot)ro,256k(env),256k(env_redundant),256k(spare),512k(dtb),6M(kernel)ro,-(rootfs) root=/dev/mtdblock7 rw rootfstype=jffs2"
# CONFIG_DISPLAY_BOARDINFO is not set
CONFIG_BOARD_EARLY_INIT_F=y
CONFIG_SPL_NAND_SUPPORT=y
CONFIG_HUSH_PARSER=y
CONFIG_SYS_PROMPT="U-Boot> "
# CONFIG_CMD_BDI is not set
CONFIG_CMD_BOOTZ=y
# CONFIG_CMD_IMI is not set
CONFIG_CMD_DFU=y
CONFIG_CMD_GPIO=y
# CONFIG_CMD_LOADS is not set
CONFIG_CMD_NAND=y
CONFIG_CMD_USB=y
# CONFIG_CMD_SOURCE is not set
# CONFIG_CMD_SETEXPR is not set
CONFIG_CMD_DHCP=y
CONFIG_CMD_PING=y
CONFIG_CMD_MTDPARTS=y
CONFIG_OF_CONTROL=y
CONFIG_OF_EMBED=y
CONFIG_DEFAULT_DEVICE_TREE="at91sam9g45-corvus"
CONFIG_ENV_IS_IN_NAND=y
CONFIG_CLK=y
CONFIG_CLK_AT91=y
CONFIG_DFU_NAND=y
# CONFIG_MMC is not set
CONFIG_NAND=y
CONFIG_NAND_ATMEL=y
CONFIG_PHYLIB=y
CONFIG_ATMEL_USART=y
CONFIG_USB=y
CONFIG_USB_EHCI_HCD=y
CONFIG_USB_STORAGE=y
CONFIG_USB_GADGET=y
CONFIG_USB_GADGET_MANUFACTURER="Siemens AG"
CONFIG_USB_GADGET_VENDOR_NUM=0x0908
CONFIG_USB_GADGET_PRODUCT_NUM=0x02d2
CONFIG_USB_GADGET_ATMEL_USBA=y
CONFIG_USB_GADGET_DOWNLOAD=y
# CONFIG_EFI_LOADER is not set