configs: visionfive2: Enable MULTI_DTB_FIT for JH7110 based board DT

[J-u-boot.git] / configs / ds109_defconfig

CONFIG_ARM=y
CONFIG_SKIP_LOWLEVEL_INIT=y
CONFIG_SYS_DCACHE_OFF=y
CONFIG_ARCH_CPU_INIT=y
CONFIG_ARCH_KIRKWOOD=y
CONFIG_SUPPORT_PASSING_ATAGS=y
CONFIG_CMDLINE_TAG=y
CONFIG_INITRD_TAG=y
CONFIG_SYS_KWD_CONFIG="board/Synology/ds109/kwbimage.cfg"
CONFIG_TEXT_BASE=0x600000
CONFIG_NR_DRAM_BANKS=2
CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0xc8012000
CONFIG_TARGET_DS109=y
CONFIG_ENV_SIZE=0x10000
CONFIG_ENV_OFFSET=0x3D0000
CONFIG_ENV_SECT_SIZE=0x10000
CONFIG_DEFAULT_DEVICE_TREE="marvell/kirkwood-ds109"
CONFIG_SYS_LOAD_ADDR=0x800000
CONFIG_ENV_ADDR=0x3D0000
# CONFIG_SYS_MALLOC_F is not set
CONFIG_USE_BOOTCOMMAND=y
CONFIG_BOOTCOMMAND="setenv ethact egiga0; ${x_bootcmd_ethernet}; ${x_bootcmd_usb}; ${x_bootcmd_kernel}; setenv bootargs ${x_bootargs} ${x_bootargs_root}; bootm 0x6400000;"
CONFIG_USE_PREBOOT=y
CONFIG_RESET_PHY_R=y
CONFIG_HUSH_PARSER=y
CONFIG_SYS_MAXARGS=32
CONFIG_CMD_IDE=y
CONFIG_CMD_I2C=y
CONFIG_CMD_USB=y
# CONFIG_CMD_SETEXPR is not set
CONFIG_CMD_DHCP=y
CONFIG_CMD_PING=y
CONFIG_CMD_EXT2=y
CONFIG_CMD_FAT=y
CONFIG_ISO_PARTITION=y
CONFIG_OF_CONTROL=y
CONFIG_ENV_OVERWRITE=y
CONFIG_ENV_IS_IN_SPI_FLASH=y
CONFIG_ENV_SPI_MAX_HZ=50000000
CONFIG_NETCONSOLE=y
CONFIG_SYS_FAULT_ECHO_LINK_DOWN=y
CONFIG_SYS_ATA_STRIDE=4
CONFIG_SYS_ATA_DATA_OFFSET=0x100
CONFIG_SYS_ATA_REG_OFFSET=0x100
CONFIG_SYS_ATA_ALT_OFFSET=0x100
CONFIG_LBA48=y
CONFIG_DM_I2C=y
CONFIG_SYS_I2C_MVTWSI=y
# CONFIG_MMC is not set
CONFIG_MTD=y
CONFIG_DM_SPI_FLASH=y
CONFIG_SPI_FLASH_STMICRO=y
CONFIG_MVGBE=y
CONFIG_MII=y
CONFIG_DM_RTC=y
CONFIG_RTC_MV=y
CONFIG_SYS_NS16550_SERIAL=y
CONFIG_SYS_NS16550_REG_SIZE=-4
CONFIG_SPI=y
CONFIG_DM_SPI=y
CONFIG_KIRKWOOD_SPI=y
CONFIG_USB=y
CONFIG_USB_EHCI_HCD=y