patman: Reset the output directory when it is removed

[J-u-boot.git] / configs / bitmain_antminer_s9_defconfig

CONFIG_ARM=y
CONFIG_SYS_VENDOR="bitmain"
CONFIG_SYS_BOARD="antminer_s9"
CONFIG_SYS_CONFIG_NAME="bitmain_antminer_s9"
CONFIG_SPL_SYS_DCACHE_OFF=y
CONFIG_ARCH_ZYNQ=y
CONFIG_SYS_TEXT_BASE=0x4000000
CONFIG_ENV_OFFSET=0x300000
CONFIG_SPL_STACK_R_ADDR=0x200000
CONFIG_SPL=y
CONFIG_SYS_BOOTCOUNT_ADDR=0xEFFFFF0
CONFIG_DEBUG_UART_BASE=0xe0001000
CONFIG_DEBUG_UART_CLOCK=50000000
CONFIG_DEBUG_UART=y
CONFIG_SYS_CUSTOM_LDSCRIPT=y
CONFIG_SYS_LDSCRIPT="arch/arm/mach-zynq/u-boot.lds"
CONFIG_FIT=y
CONFIG_FIT_SIGNATURE=y
CONFIG_FIT_VERBOSE=y
CONFIG_BOOTDELAY=3
# CONFIG_DISPLAY_CPUINFO is not set
CONFIG_SPL_STACK_R=y
CONFIG_HUSH_PARSER=y
CONFIG_SYS_PROMPT="antminer> "
CONFIG_CMD_BOOTZ=y
# CONFIG_CMD_ELF is not set
# CONFIG_CMD_DM is not set
# CONFIG_CMD_FLASH is not set
CONFIG_CMD_FPGA_LOADBP=y
CONFIG_CMD_FPGA_LOADFS=y
CONFIG_CMD_FPGA_LOADMK=y
CONFIG_CMD_FPGA_LOADP=y
CONFIG_CMD_GPIO=y
CONFIG_CMD_MMC=y
CONFIG_CMD_NAND_LOCK_UNLOCK=y
CONFIG_CMD_PART=y
# CONFIG_CMD_SETEXPR is not set
CONFIG_CMD_DHCP=y
# CONFIG_CMD_NFS is not set
CONFIG_CMD_MII=y
CONFIG_CMD_PING=y
CONFIG_CMD_PXE=y
CONFIG_CMD_CACHE=y
CONFIG_CMD_EXT2=y
CONFIG_CMD_EXT4=y
CONFIG_CMD_EXT4_WRITE=y
CONFIG_CMD_FAT=y
CONFIG_CMD_FS_GENERIC=y
CONFIG_DEFAULT_DEVICE_TREE="bitmain-antminer-s9"
CONFIG_ENV_IS_IN_NAND=y
CONFIG_NET_RANDOM_ETHADDR=y
CONFIG_SPL_DM_SEQ_ALIAS=y
CONFIG_BOOTCOUNT_LIMIT=y
CONFIG_FPGA_XILINX=y
CONFIG_FPGA_ZYNQPL=y
CONFIG_DM_GPIO=y
CONFIG_MMC_SDHCI=y
CONFIG_MMC_SDHCI_ZYNQ=y
CONFIG_MTD_DEVICE=y
CONFIG_NAND=y
CONFIG_NAND_ZYNQ=y
CONFIG_NAND_ZYNQ_USE_BOOTLOADER1_TIMINGS=y
CONFIG_MII=y
CONFIG_ZYNQ_GEM=y
CONFIG_DEBUG_UART_ZYNQ=y
CONFIG_DEBUG_UART_ANNOUNCE=y
CONFIG_ZYNQ_SERIAL=y
# CONFIG_WATCHDOG is not set
CONFIG_WDT=y
CONFIG_WDT_CDNS=y
# CONFIG_EFI_LOADER is not set