board: sl28: add basic PSCI implementation

[J-u-boot.git] / configs / uniphier_v7_defconfig

CONFIG_ARM=y
CONFIG_ARCH_UNIPHIER=y
CONFIG_SYS_TEXT_BASE=0x84000000
CONFIG_NR_DRAM_BANKS=3
CONFIG_ENV_SIZE=0x2000
CONFIG_DEFAULT_DEVICE_TREE="uniphier-pxs2-vodka"
CONFIG_SPL_TEXT_BASE=0x00100000
CONFIG_SPL_MMC=y
CONFIG_SPL_SERIAL=y
CONFIG_SPL=y
CONFIG_MICRO_SUPPORT_CARD=y
CONFIG_SYS_LOAD_ADDR=0x85000000
CONFIG_TIMESTAMP=y
# CONFIG_ARCH_FIXUP_FDT_MEMORY is not set
CONFIG_BOOTCOMMAND="run ${bootdev}script; run ${bootdev}boot"
CONFIG_USE_PREBOOT=y
CONFIG_PREBOOT="env exist ${bootdev}preboot && run ${bootdev}preboot"
CONFIG_LOGLEVEL=6
CONFIG_SPL_NAND_SUPPORT=y
CONFIG_SPL_NOR_SUPPORT=y
CONFIG_CMD_CONFIG=y
# CONFIG_CMD_XIMG is not set
CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=10
CONFIG_CMD_GPIO=y
CONFIG_CMD_GPT=y
CONFIG_CMD_I2C=y
CONFIG_CMD_MMC=y
CONFIG_CMD_SPI=y
CONFIG_CMD_USB=y
CONFIG_CMD_TFTPPUT=y
CONFIG_CMD_CACHE=y
CONFIG_CMD_TIME=y
# CONFIG_CMD_SLEEP is not set
CONFIG_CMD_MTDPARTS=y
CONFIG_MTDIDS_DEFAULT="nand0=uniphier-nand.0"
CONFIG_MTDPARTS_DEFAULT="mtdparts=uniphier-nand.0:1m(firmware),-(UBI)"
CONFIG_CMD_UBI=y
# CONFIG_SPL_DOS_PARTITION is not set
# CONFIG_SPL_EFI_PARTITION is not set
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
CONFIG_USE_BOOTFILE=y
CONFIG_BOOTFILE="zImage"
CONFIG_NET_RANDOM_ETHADDR=y
CONFIG_GPIO_UNIPHIER=y
CONFIG_MISC=y
CONFIG_I2C_EEPROM=y
CONFIG_SUPPORT_EMMC_BOOT=y
CONFIG_MMC_UNIPHIER=y
CONFIG_MTD=y
CONFIG_MTD_RAW_NAND=y
CONFIG_NAND_DENALI_DT=y
CONFIG_SYS_NAND_ONFI_DETECTION=y
CONFIG_SYS_NAND_U_BOOT_LOCATIONS=y
CONFIG_SYS_NAND_U_BOOT_OFFS=0x20000
CONFIG_SPL_NAND_DENALI=y
CONFIG_NAND_DENALI_SPARE_AREA_SKIP_BYTES=8
CONFIG_SNI_AVE=y
CONFIG_SPI=y
CONFIG_DM_SPI=y
CONFIG_UNIPHIER_SPI=y
CONFIG_USB=y
CONFIG_USB_XHCI_HCD=y
CONFIG_USB_XHCI_DWC3=y
CONFIG_USB_EHCI_HCD=y
CONFIG_USB_EHCI_GENERIC=y
CONFIG_USB_DWC3=y
CONFIG_USB_DWC3_UNIPHIER=y
CONFIG_PANIC_HANG=y
CONFIG_FDT_FIXUP_PARTITIONS=y