configs: stm32mp1: Restore boot SPL from sdcard for Engicam i.Core STM32MP1 C.TOUCH 2.0

[J-u-boot.git] / configs / gurnard_defconfig

CONFIG_ARM=y
CONFIG_SKIP_LOWLEVEL_INIT_ONLY=y
CONFIG_ARCH_AT91=y
CONFIG_TEXT_BASE=0x73f00000
CONFIG_SYS_MALLOC_LEN=0x100000
CONFIG_SYS_MALLOC_F_LEN=0x400
CONFIG_TARGET_GURNARD=y
CONFIG_AT91_GPIO_PULLUP=y
CONFIG_ATMEL_LEGACY=y
CONFIG_NR_DRAM_BANKS=1
CONFIG_ENV_SIZE=0x40000
CONFIG_ENV_OFFSET=0x80000
CONFIG_DEFAULT_DEVICE_TREE="at91sam9g45-gurnard"
CONFIG_SYS_LOAD_ADDR=0x23000000
CONFIG_FIT=y
CONFIG_BOOTDELAY=3
CONFIG_SYS_CBSIZE=256
CONFIG_SYS_PBSIZE=276
# CONFIG_DISPLAY_BOARDINFO is not set
CONFIG_BOARD_EARLY_INIT_F=y
CONFIG_RESET_PHY_R=y
CONFIG_HUSH_PARSER=y
# CONFIG_CMD_BDI is not set
# CONFIG_CMD_IMI is not set
CONFIG_CMD_GPIO=y
# CONFIG_CMD_LOADS is not set
CONFIG_CMD_MMC=y
CONFIG_CMD_NAND=y
CONFIG_CMD_PART=y
CONFIG_CMD_USB=y
# CONFIG_CMD_SOURCE is not set
# CONFIG_CMD_SETEXPR is not set
CONFIG_BOOTP_BOOTFILESIZE=y
CONFIG_CMD_DHCP=y
CONFIG_CMD_MII=y
# CONFIG_CMD_MDIO is not set
CONFIG_CMD_PING=y
CONFIG_CMD_CACHE=y
CONFIG_CMD_FAT=y
CONFIG_OF_CONTROL=y
CONFIG_ENV_OVERWRITE=y
CONFIG_ENV_IS_IN_NAND=y
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
CONFIG_NET_RETRY_COUNT=20
CONFIG_TFTP_PORT=y
CONFIG_TFTP_TSIZE=y
CONFIG_AT91_GPIO=y
CONFIG_GENERIC_ATMEL_MCI=y
CONFIG_MTD_RAW_NAND=y
# CONFIG_SYS_NAND_USE_FLASH_BBT is not set
CONFIG_NAND_ATMEL=y
CONFIG_ATMEL_NAND_HWECC=y
CONFIG_MACB=y
CONFIG_RMII=y
CONFIG_ATMEL_USART=y
CONFIG_TIMER=y
CONFIG_ATMEL_PIT_TIMER=y
CONFIG_USB=y
CONFIG_USB_EHCI_HCD=y
CONFIG_VIDEO=y
# CONFIG_VIDEO_LOGO is not set
# CONFIG_VIDEO_BPP32 is not set
CONFIG_ATMEL_LCD=y
CONFIG_CMD_DHRYSTONE=y