I2C: adding new "i2c bus" Command to the I2C Subsystem.

[u-boot.git] / doc / README.mpc8313erdb

diff --git a/doc/README.mpc8313erdb b/doc/README.mpc8313erdb
index 7ad4cc76c32088796d18446c0cfaa61f926cb300..cd5668993c46aec125b142c898bdde42e3d3f959 100644 (file)
--- a/doc/README.mpc8313erdb
+++ b/doc/README.mpc8313erdb
@@ -3,10 +3,10 @@ Freescale MPC8313ERDB Board
 
 1.     Board Switches and Jumpers
 
-       SW3 is used to set CFG_RESET_SOURCE.
+       S3 is used to set CFG_RESET_SOURCE.
 
        To boot the image at 0xFE000000 in NOR flash, use these DIP
-       switche settings for SW3 SW4:
+       switch settings for S3 S4:
 
        +------+        +------+
        |      |        | **** |
@@ -22,7 +22,7 @@ Freescale MPC8313ERDB Board
        0x8000_0000     0x8fff_ffff     PCI MEM          256M
        0x9000_0000     0x9fff_ffff     PCI_MMIO         256M
        0xe000_0000     0xe00f_ffff     IMMR             1M
-       0xe200_0000     0xe20f_ffff     PCI IO           16M
+       0xe200_0000     0xe20f_ffff     PCI IO           16M
        0xe280_0000     0xe280_7fff     NAND FLASH (CS1) 32K
        0xf000_0000     0xf001_ffff     VSC7385 (CS2)    128K
        0xfa00_0000     0xfa00_7fff     Board Status/    32K