nxp: Migrate CONFIG_DDR_CLK_FREQ to Kconfig

[u-boot.git] / include / configs / UCP1020.h

diff --git a/include/configs/UCP1020.h b/include/configs/UCP1020.h
index 6a01a904254fa45cb894e14481e510ea12185560..51083569a88d432a0f4957412a660e5498d806cd 100644 (file)
--- a/include/configs/UCP1020.h
+++ b/include/configs/UCP1020.h
@@ -13,6 +13,8 @@
 #ifndef __CONFIG_H
 #define __CONFIG_H
 
+#include <linux/stringify.h>
+
 /*** Arcturus FirmWare Environment */
 
 #define MAX_SERIAL_SIZE 15
@@ -30,9 +32,6 @@
 #define FWENV_TYPE     FWENV_NOR_FLASH
 
 #if (FWENV_TYPE == FWENV_MMC)
-#ifndef CONFIG_SYS_MMC_ENV_DEV
-#define CONFIG_SYS_MMC_ENV_DEV 1
-#endif
 #define FWENV_ADDR1 -1
 #define FWENV_ADDR2 -1
 #define FWENV_ADDR3 -1
@@ -120,8 +119,6 @@
 #define CONFIG_NETMASK         255.255.255.0
 #define CONFIG_ETHPRIME                "eTSEC1"
 
-#undef CONFIG_SYS_REDUNDAND_ENVIRONMENT
-
 #define CONFIG_SYS_L2_SIZE     (256 << 10)
 
 #endif
@@ -148,13 +145,10 @@
 #define CONFIG_SYS_MONITOR_BASE        CONFIG_SYS_TEXT_BASE    /* start of monitor */
 #endif
 
-#define CONFIG_ENV_OVERWRITE
-
 #define CONFIG_SYS_SATA_MAX_DEVICE     2
 #define CONFIG_LBA48
 
 #define CONFIG_SYS_CLK_FREQ    66666666
-#define CONFIG_DDR_CLK_FREQ    66666666
 
 #define CONFIG_HWCONFIG
 
@@ -166,9 +160,6 @@
 
 #define CONFIG_ENABLE_36BIT_PHYS
 
-#define CONFIG_SYS_MEMTEST_START       0x00200000      /* memtest works on */
-#define CONFIG_SYS_MEMTEST_END         0x1fffffff
-
 #define CONFIG_SYS_CCSRBAR             0xffe00000
 #define CONFIG_SYS_CCSRBAR_PHYS_LOW    CONFIG_SYS_CCSRBAR
 
@@ -179,11 +170,6 @@
 #endif
 
 /* DDR Setup */
-#define CONFIG_DDR_ECC_ENABLE
-#ifndef CONFIG_DDR_ECC_ENABLE
-#define CONFIG_SYS_DDR_RAW_TIMING
-#define CONFIG_DDR_SPD
-#endif
 #define CONFIG_SYS_SPD_BUS_NUM 1
 
 #define CONFIG_SYS_SDRAM_SIZE_LAW      LAW_SIZE_512M
@@ -212,11 +198,7 @@
 #define CONFIG_SYS_DDR_SR_CNTR         0x00000000
 #define CONFIG_SYS_DDR_RCW_1           0x00000000
 #define CONFIG_SYS_DDR_RCW_2           0x00000000
-#ifdef CONFIG_DDR_ECC_ENABLE
 #define CONFIG_SYS_DDR_CONTROL         0xE70C0000      /* Type = DDR3 & ECC */
-#else
-#define CONFIG_SYS_DDR_CONTROL         0xC70C0000      /* Type = DDR3 */
-#endif
 #define CONFIG_SYS_DDR_CONTROL_2       0x04401050
 #define CONFIG_SYS_DDR_TIMING_4                0x00220001
 #define CONFIG_SYS_DDR_TIMING_5                0x03402400
@@ -230,8 +212,6 @@
 #define CONFIG_SYS_DDR_MODE_2          0x8000c000
 #define CONFIG_SYS_DDR_INTERVAL                0x0C300000
 
-#undef CONFIG_CLOCKS_IN_MHZ
-
 /*
  * Memory map
  *
@@ -320,14 +300,6 @@
 #define CONFIG_SYS_NS16550_COM2        (CONFIG_SYS_CCSRBAR + 0x4600)
 
 /* I2C */
-#define CONFIG_SYS_I2C
-#define CONFIG_SYS_I2C_FSL
-#define CONFIG_SYS_FSL_I2C_SPEED       400000
-#define CONFIG_SYS_FSL_I2C_SLAVE       0x7F
-#define CONFIG_SYS_FSL_I2C_OFFSET      0x3000
-#define CONFIG_SYS_FSL_I2C2_SPEED      400000
-#define CONFIG_SYS_FSL_I2C2_SLAVE      0x7F
-#define CONFIG_SYS_FSL_I2C2_OFFSET     0x3100
 #define CONFIG_SYS_I2C_NOPROBES                { {0, 0x29} }
 #define CONFIG_SYS_SPD_BUS_NUM         1 /* For rom_loc and flash bank */
 
@@ -372,51 +344,10 @@
 /*
  * Environment
  */
-#ifdef CONFIG_ENV_FIT_UCBOOT
-
-#define CONFIG_ENV_ADDR                (CONFIG_SYS_FLASH_BASE + 0x20000)
-#define CONFIG_ENV_SIZE                0x20000
-#define CONFIG_ENV_SECT_SIZE   0x20000 /* 128K (one sector) */
-
-#else
-
-
-#ifdef CONFIG_RAMBOOT_SPIFLASH
-
-#define CONFIG_ENV_SIZE                0x3000          /* 12KB */
-#define CONFIG_ENV_OFFSET      0x2000          /* 8KB */
-#define CONFIG_ENV_SECT_SIZE   0x1000
-
-#if defined(CONFIG_SYS_REDUNDAND_ENVIRONMENT)
-/* Address and size of Redundant Environment Sector    */
-#define CONFIG_ENV_OFFSET_REDUND       (CONFIG_ENV_OFFSET + CONFIG_ENV_SIZE)
-#define CONFIG_ENV_SIZE_REDUND         CONFIG_ENV_SIZE
-#endif
-
-#elif defined(CONFIG_RAMBOOT_SDCARD)
+#if !defined(CONFIG_ENV_FIT_UCBOOT) && defined(CONFIG_RAMBOOT_SDCARD)
 #define CONFIG_FSL_FIXED_MMC_LOCATION
-#define CONFIG_ENV_SIZE                0x2000
-#define CONFIG_SYS_MMC_ENV_DEV 0
-
-#elif defined(CONFIG_SYS_RAMBOOT)
-#define CONFIG_ENV_ADDR                (CONFIG_SYS_MONITOR_BASE - 0x1000)
-#define CONFIG_ENV_SIZE                0x2000
-
-#else
-#define CONFIG_ENV_BASE                (CONFIG_SYS_FLASH_BASE)
-#define CONFIG_ENV_SECT_SIZE   0x20000 /* 128K (one sector) */
-#define CONFIG_ENV_SIZE                CONFIG_ENV_SECT_SIZE
-#define CONFIG_ENV_ADDR                (CONFIG_ENV_BASE + 0xC0000)
-#if defined(CONFIG_SYS_REDUNDAND_ENVIRONMENT)
-/* Address and size of Redundant Environment Sector    */
-#define CONFIG_ENV_ADDR_REDUND (CONFIG_ENV_ADDR + CONFIG_ENV_SIZE)
-#define CONFIG_ENV_SIZE_REDUND CONFIG_ENV_SIZE
 #endif
 
-#endif
-
-#endif /* CONFIG_ENV_FIT_UCBOOT */
-
 #define CONFIG_LOADS_ECHO              /* echo on for serial download */
 #define CONFIG_SYS_LOADS_BAUD_CHANGE   /* allow baudrate change */