Convert CONFIG_SF_DEFAULT_* to Kconfig

[u-boot.git] / include / configs / T1040QDS.h

diff --git a/include/configs/T1040QDS.h b/include/configs/T1040QDS.h
index fb79b6a559988d9d5b4e4b326a9d770a4f1d21c4..89ace7c1b0185834ef4b1e2335f3cbc949c980a6 100644 (file)
--- a/include/configs/T1040QDS.h
+++ b/include/configs/T1040QDS.h
@@ -36,15 +36,10 @@
 
 /* High Level Configuration Options */
 #define CONFIG_SYS_BOOK3E_HV           /* Category E.HV supported */
-#define CONFIG_MP                      /* support multiple processors */
 
 /* support deep sleep */
 #define CONFIG_DEEP_SLEEP
 
-#ifndef CONFIG_SYS_TEXT_BASE
-#define CONFIG_SYS_TEXT_BASE   0xeff40000
-#endif
-
 #ifndef CONFIG_RESET_VECTOR_ADDRESS
 #define CONFIG_RESET_VECTOR_ADDRESS    0xeffffffc
 #endif
@@ -62,16 +57,8 @@
 
 #define CONFIG_ENV_OVERWRITE
 
-#ifndef CONFIG_MTD_NOR_FLASH
-#else
-#define CONFIG_FLASH_CFI_DRIVER
-#define CONFIG_SYS_FLASH_CFI
-#define CONFIG_SYS_FLASH_USE_BUFFER_WRITE
-#endif
-
 #ifdef CONFIG_MTD_NOR_FLASH
 #if defined(CONFIG_SPIFLASH)
-#define CONFIG_SYS_EXTRA_ENV_RELOC
 #define CONFIG_ENV_SPI_BUS              0
 #define CONFIG_ENV_SPI_CS               0
 #define CONFIG_ENV_SPI_MAX_HZ           10000000
@@ -80,12 +67,10 @@
 #define CONFIG_ENV_OFFSET               0x100000        /* 1MB */
 #define CONFIG_ENV_SECT_SIZE            0x10000
 #elif defined(CONFIG_SDCARD)
-#define CONFIG_SYS_EXTRA_ENV_RELOC
 #define CONFIG_SYS_MMC_ENV_DEV          0
 #define CONFIG_ENV_SIZE                        0x2000
 #define CONFIG_ENV_OFFSET              (512 * 1658)
 #elif defined(CONFIG_NAND)
-#define CONFIG_SYS_EXTRA_ENV_RELOC
 #define CONFIG_ENV_SIZE                        CONFIG_SYS_NAND_BLOCK_SIZE
 #define CONFIG_ENV_OFFSET              (7 * CONFIG_SYS_NAND_BLOCK_SIZE)
 #else
@@ -126,7 +111,6 @@ unsigned long get_board_ddr_clk(void);
 
 #define CONFIG_SYS_MEMTEST_START       0x00200000      /* memtest works on */
 #define CONFIG_SYS_MEMTEST_END         0x00400000
-#define CONFIG_SYS_ALT_MEMTEST
 
 /*
  *  Config the L3 Cache as L3 SRAM
@@ -156,7 +140,6 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_CHIP_SELECTS_PER_CTRL   (2 * CONFIG_DIMM_SLOTS_PER_CTLR)
 
 #define CONFIG_DDR_SPD
-#define CONFIG_FSL_DDR_INTERACTIVE
 
 #define CONFIG_SYS_SPD_BUS_NUM 0
 #define SPD_EEPROM_ADDRESS     0x51
@@ -231,7 +214,7 @@ unsigned long get_board_ddr_clk(void);
                                | CSPR_PORT_SIZE_8 \
                                | CSPR_MSEL_GPCM \
                                | CSPR_V)
-#define CONFIG_SYS_AMASK3      IFC_AMASK(4*1024)
+#define CONFIG_SYS_AMASK3      IFC_AMASK(64 * 1024)
 #define CONFIG_SYS_CSOR3       0x0
 /* QIXIS Timing parameters for IFC CS3 */
 #define CONFIG_SYS_CS3_FTIM0           (FTIM0_GPCM_TACSE(0x0e) | \
@@ -343,9 +326,6 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_SYS_RAMBOOT
 #endif
 
-#define CONFIG_BOARD_EARLY_INIT_R
-#define CONFIG_MISC_INIT_R
-
 #define CONFIG_HWCONFIG
 
 /* define to use L1 as initial stack */
@@ -371,7 +351,6 @@ unsigned long get_board_ddr_clk(void);
  * open - index 2
  * shorted - index 1
  */
-#define CONFIG_CONS_INDEX      1
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE    1
 #define CONFIG_SYS_NS16550_CLK         (get_bus_freq(0)/2)
@@ -436,8 +415,6 @@ unsigned long get_board_ddr_clk(void);
 /*
  * eSPI - Enhanced SPI
  */
-#define CONFIG_SF_DEFAULT_SPEED         10000000
-#define CONFIG_SF_DEFAULT_MODE          0
 
 /*
  * General PCI
@@ -523,7 +500,6 @@ unsigned long get_board_ddr_clk(void);
 #endif
 
 #ifdef CONFIG_MMC
-#define CONFIG_FSL_ESDHC
 #define CONFIG_FSL_ESDHC_USE_PERIPHERAL_CLK
 #define CONFIG_SYS_FSL_ESDHC_ADDR       CONFIG_SYS_MPC85xx_ESDHC_ADDR
 #define CONFIG_FSL_ESDHC_ADAPTER_IDENT
@@ -531,7 +507,6 @@ unsigned long get_board_ddr_clk(void);
 
 /* Qman/Bman */
 #ifndef CONFIG_NOBQFMAN
-#define CONFIG_SYS_DPAA_QBMAN          /* Support Q/Bman */
 #define CONFIG_SYS_BMAN_NUM_PORTALS    10
 #define CONFIG_SYS_BMAN_MEM_BASE       0xf4000000
 #define CONFIG_SYS_BMAN_MEM_PHYS       0xff4000000ull
@@ -561,7 +536,6 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_SYS_DPAA_PME
 
 #define CONFIG_QE
-#define CONFIG_U_QE
 /* Default address of microcode for the Linux Fman driver */
 #if defined(CONFIG_SPIFLASH)
 /*
@@ -611,7 +585,6 @@ unsigned long get_board_ddr_clk(void);
 #define CONFIG_SYS_FM1_DTSEC3_RISER_PHY_ADDR    0x1e
 #define CONFIG_SYS_FM1_DTSEC4_RISER_PHY_ADDR    0x1f
 
-#define CONFIG_MII             /* MII PHY management */
 #define CONFIG_ETHPRIME                "FM1@DTSEC1"
 #endif
 
@@ -623,11 +596,6 @@ unsigned long get_board_ddr_clk(void);
 /*
  * Dynamic MTD Partition support with mtdparts
  */
-#ifdef CONFIG_MTD_NOR_FLASH
-#define CONFIG_MTD_DEVICE
-#define CONFIG_MTD_PARTITIONS
-#define CONFIG_FLASH_CFI_MTD
-#endif
 
 /*
  * Environment
@@ -638,9 +606,6 @@ unsigned long get_board_ddr_clk(void);
 /*
  * Miscellaneous configurable options
  */
-#define CONFIG_SYS_LONGHELP                    /* undef to save memory */
-#define CONFIG_CMDLINE_EDITING                 /* Command-line editing */
-#define CONFIG_AUTO_COMPLETE                   /* add autocompletion support */
 #define CONFIG_SYS_LOAD_ADDR   0x2000000       /* default load address */
 
 /*