}
U_BOOT_CMD(
waithci, 1, 1, do_waithci,
- "waithci - Wait for host control interrupt\n",
+ "Wait for host control interrupt",
NULL
);
}
U_BOOT_CMD(
fifo, 5, 1, do_fifo,
- "fifo - Fifo module operations\n",
+ "Fifo module operations",
"wait\nfifo read\n"
"fifo write fifo(0..3) data [cnt=1]\n"
"fifo write address(>=4) data [cnt=1]\n"
}
U_BOOT_CMD(
sbe, 4, 0, do_setup_bootstrap_eeprom,
- "sbe - setup bootstrap eeprom\n",
+ "setup bootstrap eeprom",
"<cpufreq:400|533|667> [<console-uart:0|1> [<bringup delay (0..20s)>]]"
);
}
U_BOOT_CMD(
painit, 1, 1, do_painit,
- "painit - prepare PciAccess system\n",
+ "prepare PciAccess system",
NULL
);
#endif /* CONFIG_PRAM */
}
U_BOOT_CMD(
selfreset, 1, 1, do_selfreset,
- "selfreset- assert self-reset# signal\n",
+ "assert self-reset# signal",
NULL
);
}
U_BOOT_CMD(
resetout, 2, 1, do_resetout,
- "resetout - assert PMC-RESETOUT# signal\n",
+ "assert PMC-RESETOUT# signal",
NULL
);
}
U_BOOT_CMD(
inta, 2, 1, do_inta,
- "inta - Assert/Deassert or query INTA# state in non-monarch mode\n",
+ "Assert/Deassert or query INTA# state in non-monarch mode",
NULL
);
}
U_BOOT_CMD(
pmm, 2, 1, do_pmm,
- "pmm - Setup pmm[1] registers\n",
+ "Setup pmm[1] registers",
"<pciaddr> (pciaddr will be aligned to 256MB)\n"
);
return state;
}
U_BOOT_CMD(eepwren, 2, 0, do_eep_wren,
- "eepwren - Enable / disable / query EEPROM write access\n",
+ "Enable / disable / query EEPROM write access",
NULL);
#endif /* #if defined(CONFIG_SYS_EEPROM_WREN) */