qcow2: Optimize write zero of unaligned tail cluster

qcow2: Optimize write zero of unaligned tail cluster

We've already improved discards to operate efficiently on the tail
of an unaligned qcow2 image; it's time to make a similar improvement
to write zeroes.  The special case is only valid at the tail
cluster of a file, where we must recognize that any sectors beyond
the image end would implicitly read as zero, and therefore should
not penalize our logic for widening a partial cluster into writing
the whole cluster as zero.

However, note that for now, the special case of end-of-file is only
recognized if there is no backing file, or if the backing file has
the same length; that's because when the backing file is shorter
than the active layer, we don't have code in place to recognize
that reads of a sector unallocated at the top and beyond the backing
end-of-file are implicitly zero.  It's not much of a real loss,
because most people don't use images that aren't cluster-aligned,
or where the active layer is a different size than the backing
layer (especially where the difference falls within a single cluster).

Update test 154 to cover the new scenarios, using two images of
intentionally differing length.

While at it, fix the test to gracefully skip when run as
./check -qcow2 -o compat=0.10 154
since the older format lacks zero clusters already required earlier
in the test.

Signed-off-by: Eric Blake <[email protected]>
Reviewed-by: Max Reitz <[email protected]>
Message-id: 20170507000552[email protected]
Signed-off-by: Max Reitz <[email protected]>