X-Git-Url: https://repo.jachan.dev/qemu.git/blobdiff_plain/afd76ffba966a072a7bbd0048bdf3b2ab69d3d4a..29e0436e3d86f750bed6ab2ff3132aeabb72c92a:/qemu-options.hx

diff --git a/qemu-options.hx b/qemu-options.hx
index c0d3951e9f..d5b0c26e8e 100644
--- a/qemu-options.hx
+++ b/qemu-options.hx
@@ -804,9 +804,8 @@ ETEXI
 
 DEF("drive", HAS_ARG, QEMU_OPTION_drive,
     "-drive [file=file][,if=type][,bus=n][,unit=m][,media=d][,index=i]\n"
-    "       [,cyls=c,heads=h,secs=s[,trans=t]][,snapshot=on|off]\n"
     "       [,cache=writethrough|writeback|none|directsync|unsafe][,format=f]\n"
-    "       [,serial=s][,addr=A][,rerror=ignore|stop|report]\n"
+    "       [,snapshot=on|off][,rerror=ignore|stop|report]\n"
     "       [,werror=ignore|stop|report|enospc][,id=name][,aio=threads|native]\n"
     "       [,readonly=on|off][,copy-on-read=on|off]\n"
     "       [,discard=ignore|unmap][,detect-zeroes=on|off|unmap]\n"
@@ -847,10 +846,6 @@ This option defines where is connected the drive by using an index in the list
 of available connectors of a given interface type.
 @item media=@var{media}
 This option defines the type of the media: disk or cdrom.
-@item cyls=@var{c},heads=@var{h},secs=@var{s}[,trans=@var{t}]
-Force disk physical geometry and the optional BIOS translation (trans=none or
-lba). These parameters are deprecated, use the corresponding parameters
-of @code{-device} instead.
 @item snapshot=@var{snapshot}
 @var{snapshot} is "on" or "off" and controls snapshot mode for the given drive
 (see @option{-snapshot}).
@@ -884,13 +879,6 @@ The default mode is @option{cache=writeback}.
 Specify which disk @var{format} will be used rather than detecting
 the format.  Can be used to specify format=raw to avoid interpreting
 an untrusted format header.
-@item serial=@var{serial}
-This option specifies the serial number to assign to the device. This
-parameter is deprecated, use the corresponding parameter of @code{-device}
-instead.
-@item addr=@var{addr}
-Specify the controller's PCI address (if=virtio only). This parameter is
-deprecated, use the corresponding parameter of @code{-device} instead.
 @item werror=@var{action},rerror=@var{action}
 Specify which @var{action} to take on write and read errors. Valid actions are:
 "ignore" (ignore the error and try to continue), "stop" (pause QEMU),