#include "sun4m.h"
#include "monitor.h"
#include "sysbus.h"
+#include "trace.h"
//#define DEBUG_IRQ_COUNT
-//#define DEBUG_IRQ
-
-#ifdef DEBUG_IRQ
-#define DPRINTF(fmt, ...) \
- do { printf("IRQ: " fmt , ## __VA_ARGS__); } while (0)
-#else
-#define DPRINTF(fmt, ...)
-#endif
/*
* Registers of interrupt controller in sun4m.
static void slavio_check_interrupts(SLAVIO_INTCTLState *s, int set_irqs);
// per-cpu interrupt controller
-static uint32_t slavio_intctl_mem_readl(void *opaque, a_target_phys_addr addr)
+static uint32_t slavio_intctl_mem_readl(void *opaque, target_phys_addr_t addr)
{
SLAVIO_CPUINTCTLState *s = opaque;
uint32_t saddr, ret;
ret = 0;
break;
}
- DPRINTF("read cpu %d reg 0x" TARGET_FMT_plx " = %x\n", s->cpu, addr, ret);
+ trace_slavio_intctl_mem_readl(s->cpu, addr, ret);
return ret;
}
-static void slavio_intctl_mem_writel(void *opaque, a_target_phys_addr addr,
+static void slavio_intctl_mem_writel(void *opaque, target_phys_addr_t addr,
uint32_t val)
{
SLAVIO_CPUINTCTLState *s = opaque;
uint32_t saddr;
saddr = addr >> 2;
- DPRINTF("write cpu %d reg 0x" TARGET_FMT_plx " = %x\n", s->cpu, addr, val);
+ trace_slavio_intctl_mem_writel(s->cpu, addr, val);
switch (saddr) {
case 1: // clear pending softints
val &= CPU_SOFTIRQ_MASK | CPU_IRQ_INT15_IN;
s->intreg_pending &= ~val;
slavio_check_interrupts(s->master, 1);
- DPRINTF("Cleared cpu %d irq mask %x, curmask %x\n", s->cpu, val,
- s->intreg_pending);
+ trace_slavio_intctl_mem_writel_clear(s->cpu, val, s->intreg_pending);
break;
case 2: // set softint
val &= CPU_SOFTIRQ_MASK;
s->intreg_pending |= val;
slavio_check_interrupts(s->master, 1);
- DPRINTF("Set cpu %d irq mask %x, curmask %x\n", s->cpu, val,
- s->intreg_pending);
+ trace_slavio_intctl_mem_writel_set(s->cpu, val, s->intreg_pending);
break;
default:
break;
};
// master system interrupt controller
-static uint32_t slavio_intctlm_mem_readl(void *opaque, a_target_phys_addr addr)
+static uint32_t slavio_intctlm_mem_readl(void *opaque, target_phys_addr_t addr)
{
SLAVIO_INTCTLState *s = opaque;
uint32_t saddr, ret;
ret = 0;
break;
}
- DPRINTF("read system reg 0x" TARGET_FMT_plx " = %x\n", addr, ret);
+ trace_slavio_intctlm_mem_readl(addr, ret);
return ret;
}
-static void slavio_intctlm_mem_writel(void *opaque, a_target_phys_addr addr,
+static void slavio_intctlm_mem_writel(void *opaque, target_phys_addr_t addr,
uint32_t val)
{
SLAVIO_INTCTLState *s = opaque;
uint32_t saddr;
saddr = addr >> 2;
- DPRINTF("write system reg 0x" TARGET_FMT_plx " = %x\n", addr, val);
+ trace_slavio_intctlm_mem_writel(addr, val);
switch (saddr) {
case 2: // clear (enable)
// Force clear unused bits
val &= MASTER_IRQ_MASK;
s->intregm_disabled &= ~val;
- DPRINTF("Enabled master irq mask %x, curmask %x\n", val,
- s->intregm_disabled);
+ trace_slavio_intctlm_mem_writel_enable(val, s->intregm_disabled);
slavio_check_interrupts(s, 1);
break;
- case 3: // set (disable, clear pending)
+ case 3: // set (disable; doesn't affect pending)
// Force clear unused bits
val &= MASTER_IRQ_MASK;
s->intregm_disabled |= val;
- s->intregm_pending &= ~val;
slavio_check_interrupts(s, 1);
- DPRINTF("Disabled master irq mask %x, curmask %x\n", val,
- s->intregm_disabled);
+ trace_slavio_intctlm_mem_writel_disable(val, s->intregm_disabled);
break;
case 4:
s->target_cpu = val & (MAX_CPUS - 1);
slavio_check_interrupts(s, 1);
- DPRINTF("Set master irq cpu %d\n", s->target_cpu);
+ trace_slavio_intctlm_mem_writel_target(s->target_cpu);
break;
default:
break;
pending &= ~s->intregm_disabled;
- DPRINTF("pending %x disabled %x\n", pending, s->intregm_disabled);
+ trace_slavio_check_interrupts(pending, s->intregm_disabled);
for (i = 0; i < MAX_CPUS; i++) {
pil_pending = 0;
}
}
- /* Level 15 and CPU timer interrupts are not maskable */
- pil_pending |= s->slaves[i].intreg_pending &
- (CPU_IRQ_INT15_IN | CPU_IRQ_TIMER_IN);
+ /* Level 15 and CPU timer interrupts are only masked when
+ the MASTER_DISABLE bit is set */
+ if (!(s->intregm_disabled & MASTER_DISABLE)) {
+ pil_pending |= s->slaves[i].intreg_pending &
+ (CPU_IRQ_INT15_IN | CPU_IRQ_TIMER_IN);
+ }
/* Add soft interrupts */
pil_pending |= (s->slaves[i].intreg_pending & CPU_SOFTIRQ_MASK) >> 16;
if (set_irqs) {
- for (j = MAX_PILS; j > 0; j--) {
+ /* Since there is not really an interrupt 0 (and pil_pending
+ * and irl_out bit zero are thus always zero) there is no need
+ * to do anything with cpu_irqs[i][0] and it is OK not to do
+ * the j=0 iteration of this loop.
+ */
+ for (j = MAX_PILS-1; j > 0; j--) {
if (pil_pending & (1 << j)) {
if (!(s->slaves[i].irl_out & (1 << j))) {
qemu_irq_raise(s->cpu_irqs[i][j]);
uint32_t pil = intbit_to_level[irq];
unsigned int i;
- DPRINTF("Set cpu %d irq %d -> pil %d level %d\n", s->target_cpu, irq, pil,
- level);
+ trace_slavio_set_irq(s->target_cpu, irq, pil, level);
if (pil > 0) {
if (level) {
#ifdef DEBUG_IRQ_COUNT
{
SLAVIO_INTCTLState *s = opaque;
- DPRINTF("Set cpu %d local timer level %d\n", cpu, level);
+ trace_slavio_set_timer_irq_cpu(cpu, level);
if (level) {
s->slaves[cpu].intreg_pending |= CPU_IRQ_TIMER_IN;
}
}
-static int vmstate_intctl_post_load(void *opaque)
+static int vmstate_intctl_post_load(void *opaque, int version_id)
{
SLAVIO_INTCTLState *s = opaque;
}
};
-static void slavio_intctl_reset(void *opaque)
+static void slavio_intctl_reset(DeviceState *d)
{
- SLAVIO_INTCTLState *s = opaque;
+ SLAVIO_INTCTLState *s = container_of(d, SLAVIO_INTCTLState, busdev.qdev);
int i;
for (i = 0; i < MAX_CPUS; i++) {
qdev_init_gpio_in(&dev->qdev, slavio_set_irq_all, 32 + MAX_CPUS);
io_memory = cpu_register_io_memory(slavio_intctlm_mem_read,
- slavio_intctlm_mem_write, s);
+ slavio_intctlm_mem_write, s,
+ DEVICE_NATIVE_ENDIAN);
sysbus_init_mmio(dev, INTCTLM_SIZE, io_memory);
for (i = 0; i < MAX_CPUS; i++) {
}
io_memory = cpu_register_io_memory(slavio_intctl_mem_read,
slavio_intctl_mem_write,
- &s->slaves[i]);
+ &s->slaves[i],
+ DEVICE_NATIVE_ENDIAN);
sysbus_init_mmio(dev, INTCTL_SIZE, io_memory);
s->slaves[i].cpu = i;
s->slaves[i].master = s;
}
- vmstate_register(-1, &vmstate_intctl, s);
- qemu_register_reset(slavio_intctl_reset, s);
- slavio_intctl_reset(s);
+
return 0;
}
.init = slavio_intctl_init1,
.qdev.name = "slavio_intctl",
.qdev.size = sizeof(SLAVIO_INTCTLState),
+ .qdev.vmsd = &vmstate_intctl,
+ .qdev.reset = slavio_intctl_reset,
};
static void slavio_intctl_register_devices(void)
projects / qemu.git / blobdiff