mptcp: remote addresses fullmesh

mptcp: remote addresses fullmesh

This patch added and managed a new per endpoint flag, named
MPTCP_PM_ADDR_FLAG_FULLMESH.

In mptcp_pm_create_subflow_or_signal_addr(), if such flag is set, instead
of:
        remote_address((struct sock_common *)sk, &remote);
fill a temporary allocated array of all known remote address. After
releaseing the pm lock loop on such array and create a subflow for each
remote address from the given local.

Note that the we could still use an array even for non 'fullmesh'
endpoint: with a single entry corresponding to the primary MPC subflow
remote address.

Suggested-by: Paolo Abeni <[email protected]>
Signed-off-by: Geliang Tang <[email protected]>
Signed-off-by: Mat Martineau <[email protected]>
Signed-off-by: David S. Miller <[email protected]>