device driver only uses consistent allocations, one would have to
check the return value from pci_set_consistent_dma_mask().
-If your 64-bit device is going to be an enormous consumer of DMA
-mappings, this can be problematic since the DMA mappings are a
-finite resource on many platforms. Please see the "DAC Addressing
-for Address Space Hungry Devices" section near the end of this
-document for how to handle this case.
-
Finally, if your device can only drive the low 24-bits of
address during PCI bus mastering you might do something like:
"mydev: 24-bit DMA addressing not available.\n");
goto ignore_this_device;
}
-[Better use DMA_24BIT_MASK instead of 0x00ffffff.
-See linux/include/dma-mapping.h for reference.]
When pci_set_dma_mask() is successful, and returns zero, the PCI layer
saves away this mask you have provided. The PCI layer will use this
int i, count = pci_map_sg(dev, sglist, nents, direction);
struct scatterlist *sg;
- for (i = 0, sg = sglist; i < count; i++, sg++) {
+ for_each_sg(sglist, sg, count, i) {
hw_address[i] = sg_dma_address(sg);
hw_len[i] = sg_dma_len(sg);
}
they are entirely deprecated. Some ports already do not provide these
as it is impossible to correctly support them.
- 64-bit DMA and DAC cycle support
-
-Do you understand all of the text above? Great, then you already
-know how to use 64-bit DMA addressing under Linux. Simply make
-the appropriate pci_set_dma_mask() calls based upon your cards
-capabilities, then use the mapping APIs above.
-
-It is that simple.
-
-Well, not for some odd devices. See the next section for information
-about that.
-
- DAC Addressing for Address Space Hungry Devices
-
-There exists a class of devices which do not mesh well with the PCI
-DMA mapping API. By definition these "mappings" are a finite
-resource. The number of total available mappings per bus is platform
-specific, but there will always be a reasonable amount.
-
-What is "reasonable"? Reasonable means that networking and block I/O
-devices need not worry about using too many mappings.
-
-As an example of a problematic device, consider compute cluster cards.
-They can potentially need to access gigabytes of memory at once via
-DMA. Dynamic mappings are unsuitable for this kind of access pattern.
-
-To this end we've provided a small API by which a device driver
-may use DAC cycles to directly address all of physical memory.
-Not all platforms support this, but most do. It is easy to determine
-whether the platform will work properly at probe time.
-
-First, understand that there may be a SEVERE performance penalty for
-using these interfaces on some platforms. Therefore, you MUST only
-use these interfaces if it is absolutely required. %99 of devices can
-use the normal APIs without any problems.
-
-Note that for streaming type mappings you must either use these
-interfaces, or the dynamic mapping interfaces above. You may not mix
-usage of both for the same device. Such an act is illegal and is
-guaranteed to put a banana in your tailpipe.
-
-However, consistent mappings may in fact be used in conjunction with
-these interfaces. Remember that, as defined, consistent mappings are
-always going to be SAC addressable.
-
-The first thing your driver needs to do is query the PCI platform
-layer if it is capable of handling your devices DAC addressing
-capabilities:
-
- int pci_dac_dma_supported(struct pci_dev *hwdev, u64 mask);
-
-You may not use the following interfaces if this routine fails.
-
-Next, DMA addresses using this API are kept track of using the
-dma64_addr_t type. It is guaranteed to be big enough to hold any
-DAC address the platform layer will give to you from the following
-routines. If you have consistent mappings as well, you still
-use plain dma_addr_t to keep track of those.
-
-All mappings obtained here will be direct. The mappings are not
-translated, and this is the purpose of this dialect of the DMA API.
-
-All routines work with page/offset pairs. This is the _ONLY_ way to
-portably refer to any piece of memory. If you have a cpu pointer
-(which may be validly DMA'd too) you may easily obtain the page
-and offset using something like this:
-
- struct page *page = virt_to_page(ptr);
- unsigned long offset = offset_in_page(ptr);
-
-Here are the interfaces:
-
- dma64_addr_t pci_dac_page_to_dma(struct pci_dev *pdev,
- struct page *page,
- unsigned long offset,
- int direction);
-
-The DAC address for the tuple PAGE/OFFSET are returned. The direction
-argument is the same as for pci_{map,unmap}_single(). The same rules
-for cpu/device access apply here as for the streaming mapping
-interfaces. To reiterate:
-
- The cpu may touch the buffer before pci_dac_page_to_dma.
- The device may touch the buffer after pci_dac_page_to_dma
- is made, but the cpu may NOT.
-
-When the DMA transfer is complete, invoke:
-
- void pci_dac_dma_sync_single_for_cpu(struct pci_dev *pdev,
- dma64_addr_t dma_addr,
- size_t len, int direction);
-
-This must be done before the CPU looks at the buffer again.
-This interface behaves identically to pci_dma_sync_{single,sg}_for_cpu().
-
-And likewise, if you wish to let the device get back at the buffer after
-the cpu has read/written it, invoke:
-
- void pci_dac_dma_sync_single_for_device(struct pci_dev *pdev,
- dma64_addr_t dma_addr,
- size_t len, int direction);
-
-before letting the device access the DMA area again.
-
-If you need to get back to the PAGE/OFFSET tuple from a dma64_addr_t
-the following interfaces are provided:
-
- struct page *pci_dac_dma_to_page(struct pci_dev *pdev,
- dma64_addr_t dma_addr);
- unsigned long pci_dac_dma_to_offset(struct pci_dev *pdev,
- dma64_addr_t dma_addr);
-
-This is possible with the DAC interfaces purely because they are
-not translated in any way.
-
Optimizing Unmap State Space Consumption
On many platforms, pci_unmap_{single,page}() is simply a nop.
projects / linux.git / blobdiff